參數資料
型號: SAF-XC2387-72F66L
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQFP144
封裝: GREEN, PLASTIC, LQFP-144
文件頁數: 98/120頁
文件大小: 1432K
代理商: SAF-XC2387-72F66L
XC2387
XC2000 Family Derivatives
Electrical Parameters
Data Sheet
77
V2.1, 2008-08
2) Not subject to production test - verified by design/characterization. Hysteresis is implemented to avoid
metastable states and switching due to internal ground bounce. It cannot suppress switching due to external
system noise under all conditions.
3) The maximum deliverable output current of a port driver depends on the selected output driver mode, see
Table 13, Current Limits for Port Output Drivers. The limit for pin groups must be respected.
4) As a rule, with decreasing output current the output levels approach the respective supply level (
V
OL→VSS,
VOH→VDDP). However, only the levels for nominal output currents are verified.
5) This specification is not valid for outputs which are switched to open drain mode. In this case the respective
output will float and the voltage is determined by the external circuit.
6) An additional error current (
I
INJ) will flow if an overload current flows through an adjacent pin. Please refer to
the definition of the overload coupling factor
KOV.
7) The given values are worst-case values. In production test, this leakage current is only tested at 125°C; other
values are ensured by correlation. For derating, please refer to the following descriptions:
Leakage derating depending on temperature (
T
J = junction temperature [°C]):
IOZ = 0.05 × e(1.5 + 0.028×TJ) [A]. For example, at a temperature of 130°C the resulting leakage current is
8.54
A.
Leakage derating depending on voltage level (DV =
VDDP - VPIN [V]):
I
OZ = IOZtempmax - (1.6 × DV) [A]
This voltage derating formula is an approximation which applies for maximum temperature.
Because pin P2.8 is connected to two pads (standard pad and high-speed clock pad), it has twice the normal
leakage.
8) Keep current: Limit the current through this pin to the indicated value so that the enabled pull device can keep
the default pin level:
V
PIN ≥ VIH for a pullup; VPIN ≤ VIL for a pulldown.
Force current: Drive the indicated minimum current through this pin to change the default pin level driven by
the enabled pull device:
V
PIN ≤ VIL for a pullup; VPIN ≥ VIH for a pulldown.
These values apply to the fixed pull-devices in dedicated pins and to the user-selectable pull-devices in
general purpose IO pins.
9) Not subject to production test - verified by design/characterization.
Because pin P2.8 is connected to two pads (standard pad and high-speed clock pad), it has twice the normal
capacitance.
相關PDF資料
PDF描述
SAF-XC2735X-72F80L RISC MICROCONTROLLER, PQFP64
SAF-XC2785X-104F80L 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
SAK-XC2785X-72F80L 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
SAK-XC2785X-104F80L 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
SAF-XC2786X-96F66L66 32-BIT, FLASH, MICROCONTROLLER, PQFP144
相關代理商/技術參數
參數描述
SAF-XC2387-72F66L AC 功能描述:IC MCU 16BIT FLASH 144-LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:XC23xx 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:260 系列:73S12xx 核心處理器:80515 芯體尺寸:8-位 速度:24MHz 連通性:I²C,智能卡,UART/USART,USB 外圍設備:LED,POR,WDT 輸入/輸出數:9 程序存儲器容量:64KB(64K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:2K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-VFQFN 裸露焊盤 包裝:管件
SAF-XC2387-72F66LAC 功能描述:16位微控制器 - MCU 16 BIT FLASH RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
SAF-XC2766X-96F66L66 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance
SAF-XC2786X-96F66L 制造商:Infineon Technologies AG 功能描述:
SAF-XC822-1FRA 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit Single-Chip Microcontroller