參數資料
型號： SAA7327
廠商： NXP Semiconductors N.V.
英文描述： Digital servo processor and Compact Disc decoder with integrated DAC for video CD (CD7 II)(應用于視頻CD的帶綜合數模轉換器（DAC）的數字伺服處理器和光盤譯碼器)
中文描述： 數字伺服處理器和光盤解碼器集成了用于視頻光盤（CD7抗原二）（應用于視頻光碟的帶綜合數模轉換器（DAC）的的數字伺服處理器和光盤譯碼器援會）
文件頁數： 32/68頁
文件大?。?/td> 284K
代理商： SAA7327
2000 Jun 26
32
Philips Semiconductors
Product specification
Digital servo processor and Compact Disc
decoder with integrated DAC for video CD (CD7 II)
SAA7327
During reset (i.e. RESET pin is held LOW)
the RA, FO and SL pins are high-impedance.
7.14.10 L
ASER INTERFACE
The LDON pin (open-drain output) is used to switch the
laser off and on. When the laser is on, the output is
high-impedance. The action of the LDON pin is controlled
by the xtra_preset parameter; the pin is automatically
driven if the focus control loop is active.
7.14.11 R
ADIAL SHOCK DETECTOR
Theshockdetector (seeFig.22) canbeswitched onduring
normal track following, and detects within an adjustable
frequency whether disturbances in the radial spot position
relative to the track exceed an adjustable level (controlled
by shock_level).
Every time the radial tracking error exceeds this level the
radial control bandwidth is switched to twice its original
bandwidth and the loop gain is increased by a factor of 4.
The shock detection level is adjustable in 16 steps from
0% to 100% of the traverse radial amplitude which is sent
to an amplitude detection unit via an adjustable band-pass
filter(controlledbysledge_parm1);lowercornerfrequency
can be set at either 0 or 20 Hz, and upper corner
frequency at 750 or 1850 Hz. The shock detector is
switched off automatically during jump mode.
7.15
Microcontroller interface
Communication on the microcontroller interface can be
set-up in two different modes:
4-wire bus mode: protocol compatible with SAA7345
(CD6) and TDA1301 (DSIC2) where:
– SCL = serial clock
– SDA = serial data
– RAB = R/W control and data strobe (active HIGH) for
writing to decoder registers 0 to F, reading status bit
selected via decoder register 2 and reading
Q-channel subcode
– SILD = R/W control and data strobe (active LOW) for
servo commands.
I
2
C-bus mode: I
2
C-bus protocol where SAA7327
behaves as slave device, activated by setting
RAB = HIGH and SILD = LOW where:
– I
2
C-bus slave address (write mode) = 30H
– I
2
C-bus slave address (read mode) = 31H
– Maximum data transfer rate = 400 kbits/s.
It should be noted that only servo commands can be used
therefore, writing to decoder registers 0 to F, reading
decoder status and reading Q-channel subcode data must
be performed by servo commands.
handbook, full pagewidth
RE
MGC914
SHOCK
OUTPUT
HIGH-PASS FILTER
(0 or 20 Hz)
LOW-PASS FILTER
(750 or 1850 Hz)
AMPLITUDE
DETECTION
Fig.22 Block diagram of radial shock detector.
相關PDF資料
PDF描述
SAA7335GP DSP for CD and DVD-ROM systems
SAA7335 DSP for CD and DVD-ROM systems(在CD和DVD-ROM應用中的DSP)
SAA7341 COMS Digital decoding IC for Compact Disc
SAA7341GP COMS Digital decoding IC for Compact Disc
SAA7345 Bitstream conversion ADC for digital audio systems
相關代理商/技術參數
參數描述
SAA7327H 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Digital servo processor and Compact Disc decoder with integrated DAC for video CD CD7 II
SAA7327H/T/M2B,557 功能描述:視頻 IC COMPACT DISC SYSTEMS RoHS:否 制造商:Fairchild Semiconductor 工作電源電壓:5 V 電源電流:80 mA 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-28 封裝:Reel
SAA7327HBG 功能描述:視頻 IC COMPACT DISC SYSTEMS RoHS:否 制造商:Fairchild Semiconductor 工作電源電壓:5 V 電源電流:80 mA 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-28 封裝:Reel
SAA7335 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DSP for CD and DVD-ROM systems
SAA7335GP 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DSP for CD and DVD-ROM systems
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*