- 您現在的位置：買賣IC網 > PDF目錄192292 > S1M8657X01-E0T0 TELECOM, CELLULAR, BASEBAND CIRCUIT, PQFP48 PDF資料下載
參數資料
| 型號： | S1M8657X01-E0T0 |
| 元件分類： | 無繩電話/電話 |
| 英文描述： | TELECOM, CELLULAR, BASEBAND CIRCUIT, PQFP48 |
| 封裝： | 7 X 7 MM, LQFP-48 |
| 文件頁數： | 9/34頁 |
| 文件大?。?/td> | 281K |
| 代理商： | S1M8657X01-E0T0 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
TX IF/BBA WITH AGC
S1M8657
17
Modes of Operation
S1M8657 can be controlled by parallel control mode or by SPI bus. The analog switch , an existing external
component, in the IC an be also controlled through separate specified parallel inputs or by SPI. The modes of
operation can be formed by parallel inputs such as FMB, IDLEB, and PAON, or by related SPI registers, as
shown in Table 1.
Table 1. Mode control in the parallel mode control
MODE
FMB
IDLEB
PAON
CDMA talk
H
CDMA idle
H
L
X
FM talk
L
H
FM idle
L
X
Tx puncture (SPI Only)
X
H
L
The modem in CDMA transmit mode operates the I and Q DAC in S1M8657, which then outputs the CDMA
spread-spectrum with Tx IF mid-frequency. All the circuits in S1M8657 are stopped in CDMA receive mode (Idle).
The modem only operates Q-DAC in the FM transmit mode (Talk). Besides this, all CDMA related circuits are
stopped. The signal for FM modulation passes through the Q-FM-LPF (FM-MOD) output pin to come out. All
circuits in S1M8657 are stopped in FM receive only mode (Idle). Because Tx puncture mode can only be
controlled through the SPI bus, it turns on and off the blocks related to the intervals with no data. By doing so, it
minimizes the consumption current. The SPI registers related to this feature are controlled by setting PAON =
Low, SEN = High, IDLEB = High.
Tx Phase Locked Loop
S1M8657 has a built-in programmable PLL which can determine the IF mid-frequency. If the SPI BUS is not
used, the default value in the built-in register must be used; the Tx IF frequency is 130.38Mhz when TCXO =
19.68Mhz. The block diagram of the PLL is shown in Figure 7. The PLL is composed of the VCO, R-Divider, N-
Divider, and Phase Detector, while the Loop filter and VCO components are outside S1M8657. The divide ratios
in the PLL R and N counters can be programmed through the SPI bus. These can change the phase comparison
frequency. The N-Counter is composed of a 9-BIT A-Counter and 4-BIT B-Counter and 8/9 or 16/17 Dual-
Modulus Prescaler.
相關PDF資料 |
PDF描述 |
|---|---|
| S1M8657X01-F0T0 | TELECOM, CELLULAR, BASEBAND CIRCUIT, BCC48 |
| S1M8660AX01-F0T0 | SPECIALTY TELECOM CIRCUIT, CBCC48 |
| S1M8836X01-G0T0 | PLL FREQUENCY SYNTHESIZER, 1000 MHz, CQCC24 |
| S1P-SLV | 1 CONTACT(S), FEMALE, TWO PART BOARD CONNECTOR, CRIMP |
| S1T0567X01-D0B0 | TELECOM, TONE DECODER CIRCUIT, PDIP8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S1M8657X01-F0T0 | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:TX IF/BBA WITH AGC |
| S1M8660A | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:RX IF / BBA WITH GPS |
| S1M8660AX01-F0T0 | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:RX IF / BBA WITH GPS |
| S1M8662A | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:CDMA/PCS/GPS Triple Mode IF/ baseband IC |
| S1M8662AX01-F0T0 | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:CDMA/PCS/GPS Triple Mode IF/ baseband IC |
發布緊急采購，3分鐘左右您將得到回復。