- 您現在的位置：買賣IC網 > PDF目錄368130 > PS9702B (Electronic Theatre Controls, Inc.) 6Ch, 24bit, 192kHz Digital Audio Processor for Full Digital Amplifier PDF資料下載
參數資料
| 型號： | PS9702B |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | 6Ch, 24bit, 192kHz Digital Audio Processor for Full Digital Amplifier |
| 中文描述： | 6通道，24位，192kHz的數字音頻處理器的全數字放大器 |
| 文件頁數： | 8/41頁 |
| 文件大?。?/td> | 505K |
| 代理商： | PS9702B |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁
PULSUS
PS9702B
Signal Descriptions
1. Clock and Reset
Copyright 2000-2003, Pulsus Technologies Inc
.
8
2003 REV1.2
The PS9702B uses 98.304MHz (48KHz x 2048) system clock internally. The PS9702B uses external
12.288MHz clock source and has x8 PLL (Phase Locked Loop) for internal system clock generation.
PS9702B can select the system clock between the internally generated clock and the external input clock
(In this case the external input clock must be 98.304MHz).
2. PCM Audio Input Signals
PS9702B uses serial interface for PCM audio data input using
BCK
,
LRCK
, and
DIN
pins. It has one
input port for six channel audio data (named as main channel) and has three sub-input port for two channel
audio data (named as sub-channel). But the three sub-input ports can be used as one six-channel audio
input port.
3. PWM Audio Output Signals
The PS9702B converts PCM audio data to PWM audio signal. It outputs one six-channel PWM signal for
main audio, one two-channel PWM signal for record-out and one additional two-channel PCM signal for
record-out. All PWM signal consist of the both positive and negative PWM signals.
4. Control Interface Signals
The PS9702B supports internal control register I/O using both SPI and I
2
C. The pin
SPI/I2C
selects the
control interface method. The control registers has 8-bit address space and 16-bit or 24-bit data length. All
internal control registers are both readable and writable.
5. Special Control Signals
The PS9702B can generate only AD mode PWM signal. For more information about the Power stage
driving method and BD/AD mode of PWM amplifier, refer the “PULSUS PWM Amplification application
notes”.
The PS9702B has Overload protection logic. When the pin
OVERLOAD
is “HIGH” (default setting, the
polarity is programmable), the PS9702B goes to protection mode and all PWM outputs go to “LOW” (default
setting).
相關PDF資料 |
PDF描述 |
|---|---|
| PS9713E3 | Half Bridge Driver, Soft Turn-On, Single Input Plus Shut-Down, Fixed 500ns Deadtime in a 8-pin DIP package; A IR2302 packaged in a Lead-Free 8-Lead SOIC |
| PS9713E4 | IP2001; Similar to iP2001 with Lead Free packaging. |
| PS9814 | NECs 10 Mbps HIGH CMR OPEN COLLECTOR OUTPUT TYPE 8-PIN SOP HIGH-SPEED PHOTOCOUPLER |
| PS9814-1 | NECs 10 Mbps HIGH CMR OPEN COLLECTOR OUTPUT TYPE 8-PIN SOP HIGH-SPEED PHOTOCOUPLER |
| PS9814-2 | NECs 10 Mbps HIGH CMR OPEN COLLECTOR OUTPUT TYPE 8-PIN SOP HIGH-SPEED PHOTOCOUPLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PS9711 | 功能描述:高速光耦合器 Hi-Speed Digital Out RoHS:否 制造商:Avago Technologies 電流傳遞比: 最大波特率: 最大正向二極管電壓:1.75 V 最大反向二極管電壓:5 V 最大功率耗散:40 mW 最大工作溫度:+125 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-5 封裝:Tube |
| PS9711-E3 | 制造商:NEC 制造商全稱:NEC 功能描述:HIGH NOISE REDUCTION/HIGH-SPEED 10 Mbps, TOTEM-POLE OUTPUT TYPE 5-PIN SOP TOM PHOTOCOUPLER |
| PS9711-E4 | 制造商:NEC 制造商全稱:NEC 功能描述:HIGH NOISE REDUCTION/HIGH-SPEED 10 Mbps, TOTEM-POLE OUTPUT TYPE 5-PIN SOP TOM PHOTOCOUPLER |
| PS9711-F3 | 制造商:NEC 制造商全稱:NEC 功能描述:HIGH NOISE REDUCTION/HIGH-SPEED 10 Mbps, TOTEM-POLE OUTPUT TYPE 5-PIN SOP TOM PHOTOCOUPLER |
| PS9711-F4 | 制造商:NEC 制造商全稱:NEC 功能描述:HIGH NOISE REDUCTION/HIGH-SPEED 10 Mbps, TOTEM-POLE OUTPUT TYPE 5-PIN SOP TOM PHOTOCOUPLER |
發布緊急采購，3分鐘左右您將得到回復。