- 您現在的位置：買賣IC網 > PDF目錄369949 > PCF8562 (NXP Semiconductors N.V.) Universal LCD driver for low multiplex rates PDF資料下載
參數資料
| 型號： | PCF8562 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Universal LCD driver for low multiplex rates |
| 中文描述： | 通用LCD驅動器的低復用率 |
| 文件頁數： | 17/36頁 |
| 文件大?。?/td> | 928K |
| 代理商： | PCF8562 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
November 22, 2004
17
Philips Semiconductors
Preliminary specification
Universal LCD driver
for low multiplex rates
PCF8562
The PCF8562 includes a RAM bank switching feature in the static and 1 : 2 drive modes. In the static drive mode, the
BANK SELECT command may request the contents of bit 2 to be selected for display instead of the contents of bit 0. In
1 : 2 mode, the contents of bits 2 and 3 may be selected instead of bits 0 and 1. This allows display information to be
prepared in an alternative bank and then selected for display when it is assembled.
6.14
Input bank selector
The input bank selector loads display data into the display RAM in accordance with the selected LCD drive configuration.
The BANK SELECT command can be used to load display data in bit 2 in static drive mode or in bits 2 and 3 in
1 : 2 mode. The input bank selector functions are independent of the output bank selector.
6.15
Blinker
The PCF8562 has a very versatile display blinking capability. The whole display can blink at a frequency selected by the
BLINK command. Each blink frequency is a multiple integer value of the clock frequency; the ratio between the clock
frequency and blink frequency depends on the blink mode selected, as shown in Table 3.
An additional feature allows an arbitrary selection of LCD segments to be blinked in the static and 1 : 2 drive modes.
This is implemented without any communication overheads by the output bank selector which alternates the displayed
data between the data in the display RAM bank and the data in an alternative RAM bank at the blink frequency. This
mode can also be implemented by the BLINK command.
In the 1 : 3 and 1 : 4 drive modes, where no alternative RAM bank is available, groups of LCD segments can be blinked
by selectively changing the display RAM data at fixed time intervals.
The entire display can be blinked at a frequency other than the nominal blink frequency by sequentially resetting and
setting the display enable bit E at the required rate using the MODE SET command.
Table 3
Blinking frequencies
Note
1.
Blink modes 0.5, 1 and 2 Hz, and nominal blink frequencies 0.5, 1 and 2 Hz correspond to an oscillator frequency
(f
CLK
) of 1536 Hz at pin CLK. The oscillator frequency range is given in Chapter 11.
BLINK MODE
NORMAL OPERATING MODE
RATIO
NOMINAL BLINK FREQUENCY
Off
2 Hz
blinking off
2 Hz
1 Hz
1 Hz
0.5 Hz
0.5 Hz
f
768
f
1536
f
3072
相關PDF資料 |
PDF描述 |
|---|---|
| PCF8832 | STN RGB - 384 output column driver |
| PCF8890 | 240 + 1 outputs TFT LCD gate driver |
| PCF93C110 | 32-Bit Microcontroller |
| PCB93C110 | 32-Bit Microcontroller |
| PCG3N60C3W | TRANSISTOR | IGBT | N-CHAN | 600V V(BR)CES | CHIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PCF8562_09 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal LCD driver for low multiplex rates |
| PCF8562_11 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal LCD driver for low multiplex rates |
| PCF8562DTT/2,518 | 制造商:NXP Semiconductors 功能描述:Tape & Reel |
| PCF8562TT/2 | 制造商:NXP Semiconductors 功能描述: |
| PCF8562TT/2,118 | 功能描述:LCD 驅動器 LCD DRIVER 32/128SEG RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。