參數資料
型號： PCD5041HZ
廠商： NXP SEMICONDUCTORS
元件分類： 無繩電話/電話
英文描述： DECT burst mode controller
中文描述： TELECOM, CORDLESS, BURST MODE CONTROLLER, PQFP80
文件頁數： 13/28頁
文件大?。?/td> 134K
代理商： PCD5041HZ
1996 Oct 31
13
Philips Semiconductors
Objective specification
DECT burst mode controller
PCD5041
6.5.3
S
EAMLESS HANDOVER
Seamless handover guarantees that when speech
information is switched from one slot to another, no speech
samples are lost, added or displaced. Seamless handover
is achieved in the RF interface by:
Using a look-up table containing the correct start
addresses of the B-fields in the data memory
The RF receive and transmit blocks move data to/from
the data memory block in 4-bit nibbles.
6.5.4
RF
CONTROL SIGNALS
The timing of the control signals to the RF section is fixed,
but such that an RF delay between 1.5 and 7
μ
s can be
tolerated. Only the transmitter ramp signal and the
synthesizer enable are programmable within certain limits.
6.5.5
SYNTHESIZER PROGRAMMING
To program a synthesizer, a 3-wire serial interface is used.
The signals on this interface are:
S_ENABLE (enable)
S_CLK (clock)
S_DATA (data).
To program various types of synthesizers, a 3-byte shift
register is present. Three data formats are supported:
8, 16 or 24 bit words can be selected. The transfer of data
from a frequency table in the common data memory to the
shift register is under control of the PCC.
6.5.6
RSSI
MEASUREMENT
(see Fig.8)
The RSSI measurement in the PCD5041 RF-interface
block is done in 3 parts: a peak/hold detector, a 6-bit A/D
converter, and an RSSI control unit, which controls the
peak/hold detector and the A/D converter. Once per slot
time, a sample is fetched by the PCC and saved in the
appropriate area of the common data memory.
If the radio receiver is active in a particular time slot, the
RSSI value will automatically be measured in that slot.
Adjustment to the RSSI_AN input level can be made with
VREF.
Fig.8 RSSI measurement path.
handbook, full pagewidth
MBH711
RSSI
PROCESSING
(SW in PCC)
internal
bus
write in memory
RSSI
CTRL
(HW)
6-BIT
A/D
PEAK
HOLD
RSSI value
filtered width
= 30
μ
s
(
τ
=10 to 40
μ
s)
6
RSSI_AN
RF-INTERFACE
RSSI_AN
VREF
RSSI_CTR
start_AD
相關PDF資料
PDF描述
PCD5042H DECT burst mode controller
PCD5042HZ DECT burst mode controller
PCD5042 DECT burst mode controller
PCD5043 DECT burst mode controller
PCD5043H DECT burst mode controller
相關代理商/技術參數
參數描述
PCD5042 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
PCD5042H 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
PCD5042HZ 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
PCD5043 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
PCD5043H 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:DECT burst mode controller
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*