參數資料
型號： PCD3359A
廠商： NXP Semiconductors N.V.
英文描述： 8-bit microcontroller with DTMF generator and 128 bytes EEPROM
中文描述： 8位的DTMF產生器和128字節EEPROM的微控制器
文件頁數： 19/32頁
文件大?。?/td> 165K
代理商： PCD3359A
1998 May 11
19
Philips Semiconductors
Product specification
8-bit microcontroller with DTMF
generator and 128 bytes EEPROM
PCD3359A
9
TIMING
Although the PCD3359A operates over a clock frequency
range from 1 to 16 MHz, f
xtal
= 3.58 MHz will usually be
chosen to take full advantage of the frequency generator
section.
10 RESET
In addition to the conditions given in the “PCD33XXA
Family”data sheet, all derivative registers are cleared in
the reset state.
11 IDLE MODE
In Idle mode, the frequency generator, the EEPROM and
the Timer 2 sections remain operative. Therefore, the
IDLE instruction may be executed while an erase and/or
write access to EEPROM is in progress.
12 STOP MODE
Since the oscillator is switched off, the frequency
generator, the EEPROM and the Timer 2 sections receive
no clock. It is suggested to clear both the HGF and the
LGF registers before entering Stop mode. This will cut off
the biasing of the internal amplifiers, considerably
reducing current requirements.
The Stop mode
must not
be entered while an erase
and/or write access to EEPROM is in progress. The STOP
instruction may only be executed when EWP in EPCR is
zero. The Timer 2 section is frozen during Stop mode.
After exit from Stop mode by a HIGH level on CE/T0,
Timer 2 proceeds from the held state.
The Port 0 Wake-up interrupt function remains operative
during Stop mode (depending only on the EPIn bits in
register MDYCON). In addition to the description in the
“PCD33xxA family”data sheet, Stop mode may be left by
a Port 0 Wake-up interrupt event (see Section 8.2).
13 INSTRUCTION SET RESTRICTIONS
Please note the following:
ROM space being restricted to 2 kbytes, the
‘SEL MB1/2/3’ instructions would define non-existing
program memory banks and should therefore be
avoided
RAM space being restricted to 64 bytes, care should be
taken to avoid accesses to non-existing RAM locations.
14 OVERVIEW OF PORT AND POWER-ON-RESET
CONFIGURATION
All standard quasi-bidirectional I/O ports are available; see
“PCD33xxA family” data sheet.
Port 0: 8 parallel port lines P0.0 to P0.7 or wake-up
interrupts
Port 1: 8 parallel port lines P1.0 to P1.7
Port 2: 4 parallel port lines P2.0 to P2.3.
Table 25
Port and Power-on-reset configuration
See notes 1 and 2.
Notes
1.
2.
3.
Port output drive: 1 = standard I/O; 2 = open-drain I/O, see “PCD33xxA family”data sheet.
Port state after reset: S = Set (HIGH) and R = Reset (LOW).
The melody output drive type is push-pull.
COVERED
BY OTP
PORT 0
PORT 1
PORT 2
V
POR
0
1
2
3
4
5
6
7
0
1
2
3
4
5
6
7
0
1
2
3
PCD3756A
1S 1S 1S 1S 1S 1S 1S 1S 1S 1S 1S 1S 1S 1S 1R
1R
(3)
2S
2S
2S
2S
1.3 V
相關PDF資料
PDF描述
PCD3359AH 8-bit microcontroller with DTMF generator and 128 bytes EEPROM
PCD3359AP 8-bit microcontroller with DTMF generator and 128 bytes EEPROM
PCD3359AT 8-bit microcontroller with DTMF generator and 128 bytes EEPROM
PCD3360 Programmable multi-tone telephone ringer
PCD3360P Programmable multi-tone telephone ringer
相關代理商/技術參數
參數描述
PCD3359AH 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with DTMF generator and 128 bytes EEPROM
PCD3359AP 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with DTMF generator and 128 bytes EEPROM
PCD3359AT 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontroller with DTMF generator and 128 bytes EEPROM
PCD3360 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Programmable multi-tone telephone ringer
PCD3360P 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Programmable multi-tone telephone ringer
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*