- 您現在的位置：買賣IC網 > PDF目錄382379 > PCD3316 (NXP Semiconductors N.V.) Caller-ID on Call Waiting CIDCW receiver PDF資料下載
參數資料
| 型號： | PCD3316 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Caller-ID on Call Waiting CIDCW receiver |
| 中文描述： | 來電呼叫等待CIDCW編號接收機 |
| 文件頁數： | 5/30頁 |
| 文件大?。?/td> | 534K |
| 代理商： | PCD3316 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
Philips Semiconductors
PCD3316
CIDCW receiver
Product specification
11 March 1999
5 of 30
9397 750 04824
Philips Electronics N.V. 1999. All rights reserved.
Unetited
finally the data pattern are sent (see
Figure 3
). These mark bits are detected by the
PCD3316 which sets the FSK-BOM Indication bit (Status register, bit 4). The
FSK-BOM Indication bit is reset when the FSK receiver is disabled.
They can be used for ring or line polarity reversal detection. The POL on/off bit (Mode
register 1, bit 4) must be set to enable generation of an interrupt when a polarity
and POL1) of the Status register (see
Section 7.4
). The 3.58 MHz clock is not needed
for the generation of a polarity interrupt.
7.2 CAS detection
After a power-on reset or after enabling the CAS detector the internal registers of the
CAS detection function are initialized. The initialization takes a maximum of
100 periods of the 3.58 MHz clock.
If the CAS detection is enabled the PCD3316 will generate an interrupt (Interrupt
register, bit 1 is set) when a correct dual tone (2130 and 2750 Hz) is detected.
Interrupts will be blocked when the signal level on the CAS input is below the
threshold in the level detector.
7.3 FSK reception
The FSK receiver function can be enabled by setting the FSK on/off bit (Mode
register 1, bit 7).
In the FSK transmission specification of BT and Bellcore a channel seizure is
If the FSK-BOM Indication bit is set, the FSK receiver will generate an interrupt after it
has received a complete data word. An FSK data word consists of one start bit
(space), followed by eight data bits and one stop bit (mark). Interrupts will therefore
not be generated during the channel seizure and during the block of marks. When a
valid data word has been received, FSK data is available in the FSK data register.
By clearing the FSK-BOM-mask on/off bit (Mode register 1, bit 6), the FSK receiver
will not wait with the generation of interrupts until a Begin Of Mark (BOM) has been
detected but will handle the channel seizure as normal data. The block of marks
which is a string of logic 1 will still not generate interrupts because there are no start
bits.
After the generation of an interrupt the IRQ pin will become active (see
Figure 4
), and
the FSK Interrupt bit is set (Interrupt register, bit 5). The received data is available in
the FSK data register.
Fig 3.
FSK transmission specification.
width
MBH979
channel seizure
mark
FSK transmission
FSK-BOM
data
相關PDF資料 |
PDF描述 |
|---|---|
| PCD3316T | Caller-ID on Call Waiting CIDCW receiver |
| PCD3330-1 | Multistandard repertory dialler/ringer with EEPROM |
| PCD3330-1P | Multistandard repertory dialler/ringer with EEPROM |
| PCD3330-1T | Multistandard repertory dialler/ringer with EEPROM |
| PCD3354AH | 8-bit microcontrollers with DTMF generator and 256 bytes EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PCD3316T | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Caller-ID on Call Waiting CIDCW receiver |
| PCD3316TD-T | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Caller Number ID Circuit |
| PCD3320CD | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Pulse Telephone Dialer |
| PCD3321CD | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Pulse Telephone Dialer |
| PCD3322CP | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Pulse Telephone Dialer |
發布緊急采購，3分鐘左右您將得到回復。