- 您現在的位置：買賣IC網 > PDF目錄12046 > P89LPC9103FTK,115 (NXP Semiconductors)IC 80C51 MCU FLASH 1K 10-HVSON PDF資料下載
參數資料
| 型號： | P89LPC9103FTK,115 |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 26/39頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC 80C51 MCU FLASH 1K 10-HVSON |
| 產品培訓模塊： | Migrating from 8/16-Bit MCUs to 32-Bit ARMs |
| 標準包裝： | 1 |
| 系列： | LPC900 |
| 核心處理器： | 8051 |
| 芯體尺寸： | 8-位 |
| 速度： | 18MHz |
| 連通性： | UART/USART |
| 外圍設備： | 欠壓檢測/復位，LED，POR，PWM，WDT |
| 輸入/輸出數： | 8 |
| 程序存儲器容量： | 1KB（1K x 8） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 128 x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2.4 V ~ 3.6 V |
| 數據轉換器： | A/D 4x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 10-VFDFN 裸露焊盤 |
| 包裝： | 標準包裝 |
| 配用： | 622-1008-ND - BOARD FOR LPC9103 10-HVSON 622-1006-ND - SOCKET ADAPTER BOARD 622-1004-ND - BOARD DEMO FOR PHILIPS PCA9633 622-1003-ND - KIT FOR LCD DEMO 568-1759-ND - EMULATOR DEBUGGER/PROGRMMR LPC9X |
| 其它名稱： | 568-2001-6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁
P89LPC9102_9103_9107_3
NXP B.V. 2007. All rights reserved.
Product data sheet
Rev. 03 — 10 July 2007
32 of 61
NXP Semiconductors
P89LPC9102/9103/9107
8-bit microcontrollers with two-clock accelerated 80C51 core
8.12.2 Quasi-bidirectional output conguration
Quasi-bidirectional output type can be used as both an input and output without the need
to recongure the port. This is possible because when the port outputs a logic HIGH, it is
weakly driven, allowing an external device to pull the pin LOW. When the pin is driven
LOW, it is driven strongly and able to sink a fairly large current. These features are
somewhat similar to an open-drain output except that there are three pull-up transistors in
the quasi-bidirectional output that serve different purposes.
The P89LPC9102/9103/9107 is a 3 V device, however, the pins are 5 V-tolerant. In
quasi-bidirectional mode, if a user applies 5 V on the pin, there will be a current owing
from the pin to VDD, causing extra power consumption. Therefore, applying 5 V in
quasi-bidirectional mode is discouraged.
A quasi-bidirectional port pin has a Schmitt triggered input that also has a glitch
suppression circuit.
8.12.3 Open-drain output conguration
The open-drain output conguration turns off all pull-ups and only drives the pull-down
transistor of the port driver when the port latch contains a logic 0. To be used as a logic
output, a port congured in this manner must have an external pull-up, typically a resistor
tied to VDD.
An open-drain port pin has a Schmitt triggered input that also has a glitch suppression
circuit.
8.12.4 Input-only conguration
The input-only port conguration has no output drivers. It is a Schmitt triggered input that
also has a glitch suppression circuit.
8.12.5 Push-pull output conguration
The push-pull output conguration has the same pull-down structure as both the
open-drain and the quasi-bidirectional output modes, but provides a continuous strong
pull-up when the port latch contains a logic 1. The push-pull mode may be used when
more source current is needed from a port output. A push-pull port pin has a Schmitt
triggered input that also has a glitch suppression circuit.
8.12.6 Port 0 analog functions
The P89LPC9102/9103/9107 incorporates an Analog Comparator. In order to give the
best analog function performance and to minimize power consumption, pins that are being
used for analog functions must have the digital outputs and digital inputs disabled.
Digital outputs are disabled by putting the port output into the Input-only (high-impedance)
mode as described in Section 8.12.4 “Input-only conguration”.
Digital inputs on Port 0 may be disabled through the use of the PT0AD register. On any
reset, the PT0AD bits default to logic 0s to enable digital functions.
8.12.7 Additional port features
After power-up, all pins are in Input-only mode. Please note that this is different from
the LPC76x series of devices.
相關PDF資料 |
PDF描述 |
|---|---|
| 861257-1 | CONN RCPT W/FLANGE FEED-THRU TIN |
| VI-J6W-IX-B1 | CONVERTER MOD DC/DC 5.5V 75W |
| ATMEGA324PA-MU | MCU AVR 32K FLASH 44-QFN |
| VJ1825A223JBAAT4X | CAP CER 0.022UF 50V 5% NP0 1825 |
| VI-J6B-IX-B1 | CONVERTER MOD DC/DC 95V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P89LPC9107 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontrollers with two-clock accelerated 80C51 core 1 kB 3 V byte-erasable flash with 8-bit A/D converter |
| P89LPC9107FDH | 制造商:NXP Semiconductors 功能描述:MCU 8BIT 80C51 1K FLASH TSSOP14 |
| P89LPC9107FDH,129 | 功能描述:8位微控制器 -MCU 80C51 1K FL 128B RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| P89LPC9107FDH129 | 制造商:NXP Semiconductors 功能描述:IC 8BIT MCU 80C51 18MHZ TSSOP-14 |
| P89LPC9107FN | 功能描述:8位微控制器 -MCU 1KFL/128B RAM/8B ADC/PWM/UART RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。