參數資料
型號： MRF24J40-IMM
廠商： Microchip Technology Inc.
英文描述： IEEE 802.15.4⑩ 2.4 GHz RF Transceiver
中文描述： IEEE 802.15.4標準⑩2.4 GHz射頻收發器
文件頁數： 62/66頁
文件大?。?/td> 748K
代理商： MRF24J40-IMM
MRF24J40
DS39776A-page 60
Advance Information
2006 Microchip Technology Inc.
PCB Antenna
Dimensions ................................................................49
Simulation Results .....................................................50
PHY Initialization ................................................................22
Pin Descriptions ...................................................................5
CLKOUT (Clock Output) ..............................................5
CS (Serial Interface Enable) ........................................5
GND (Ground, Digital Circuit) ......................................5
GND (Ground, PLL) .....................................................5
GND (Guard Ring Ground) ..........................................5
GPIO0 (External PA Enable) .......................................5
GPIO1 (External TX/RX Switch Control) ......................5
GPIO2 (External TX/RX Switch Control) ......................5
GPIO3 (General Purpose Digital I/O) ...........................5
GPIO4 (General Purpose Digital I/O) ...........................5
GPIO5 (General Purpose Digital I/O) ...........................5
INT (Interrupt Pin) ........................................................5
LCAP (PLL Loop Filter External Capacitor) .................5
LPOSC1 (32 kHz Crystal Input) ...................................5
LPOSC2 (32 kHz Crystal Input) ...................................5
NC (No Connection) .....................................................5
OSC1 (20 MHz Crystal Input) ......................................5
OSC2 (20 MHz Crystal Input) ......................................5
RESET (Global Hardware Reset Active-Low) ..............5
RFN (Differential RF Pin, Negative) .............................5
RFP (Differential RF Pin, Positive) ...............................5
RXIP (Analog RX I Channel Output) ............................5
RXQP (Analog RX Q Channel Output) ........................5
SCK (Serial Interface Clock) ........................................5
SDI (Serial Interface Data Input) ..................................5
SDO (Serial Interface Data Output) .............................5
V
DD
(Charge Pump Power Supply) ..............................5
V
DD
(Digital Circuit Power Supply) ...............................5
V
DD
(Guard Ring Power Supply) ..................................5
V
DD
(PLL Power Supply) ..............................................5
V
DD
(Power Supply, Analog Circuit) .............................5
V
DD
(Power Supply, Band Gap
Reference Circuit) ................................................5
V
DD
(RF Power Supply) ...............................................5
V
DD
(VCO Supply) .......................................................5
WAKE (External Wake-up Trigger) ..............................5
Power-Saving Mode .............................................................3
Proprietary Protocols ............................................................1
MiWi .............................................................................1
ZigBee ......................................................................1, 9
R
Reader Response ..............................................................62
Receive Buffers ....................................................................9
Receive Filters ...................................................................21
Receive Packets ................................................................21
Receive Process Flowchart ................................................32
Receiving Packets ..............................................................31
Freeing Buffer Space .................................................34
Layout ........................................................................33
Recommended Operating Conditions ................................42
Reference Clock Output .......................................................3
Register File Summary .......................................................11
Registers
BBREG2 (Baseband CCA/RSSI Mode 2) ..................25
BBREG6 (Baseband RSSI Mode 6) ..........................25
CLKCTRL (Divided Sleep Clock Selection) .................7
CLKINTCR (SLPCLK On/Off and
Interrupt Polarity) ...............................................38
GPIO (GPIO Port) ......................................................39
INTMSK (Interrupt Mask) ...........................................37
ISRSTS (Interrupt Status) .......................................... 36
PANIDH (MAC PAN High Byte) ................................. 26
PANIDL (MAC PAN Low Byte) .................................. 26
RFCTL (RF Mode Control) ........................................ 24
RFCTRL0 (RF Control 0) ........................................... 24
RFCTRL2 (RF Control 2) ........................................... 22
RFCTRL3 (RF Control 3) ........................................... 22
RFCTRL6 (RF Control 6) ........................................... 23
RFCTRL7 (RF Control 7) ............................................. 8
RFCTRL8 (RF Control 8) ........................................... 23
RSSITHCCA (RSSI Threshold for CCA) ................... 23
RXFLUSH (Receive FIFO Flush) ............................... 34
RXMCR (Receive Filter Control) ................................ 21
SADRH (MAC Short Address High Byte) .................. 27
SADRL (MAC Short Address Low Byte) .................... 27
TRISGPIO (GPIO Pin Direction
and SPI Mode) ................................................... 40
TXNMTRIG (Trigger and Setting
for Normal Frame, CAP) .................................... 30
TXSR (TX MAC Status) ............................................. 31
RF Measurements ............................................................. 47
RF Output ............................................................................ 8
RF Transceiver .................................................................. 47
RSSI Default Threshold ..................................................... 22
RX FIFO ............................................................................. 31
RX MAC ............................................................................. 31
S
Schematic .......................................................................... 55
Security Buffer ..................................................................... 9
Serial Communications ........................................................ 3
Serial Peripheral Interface (SPI) ........................................ 13
Short Address Register Interface ....................................... 14
Reading ..................................................................... 14
Writing ....................................................................... 15
Short Address Summary .................................................... 11
Short Addresses ................................................................ 26
Sleep Mode .......................................................................... 3
T
Timing Diagrams
Example SPI Slave Mode .......................................... 43
Long Address Read ................................................... 16
Long Address Write ................................................... 17
Short Address Read .................................................. 14
Short Address Write ................................................... 15
SPI Input .................................................................... 13
SPI Output ................................................................. 13
Transmit Buffers .................................................................. 9
Transmit Packets ............................................................... 21
Transmitting Packets ......................................................... 29
Status ........................................................................ 31
Trigger Packet ........................................................... 30
TX FIFO ............................................................................. 30
TX FIFO Format ................................................................. 29
TX MAC ............................................................................. 29
W
WWW Address .................................................................. 61
WWW, On-Line Support ...................................................... 2
Z
Zigbee V1.0 Specification .................................................... 9
相關PDF資料
PDF描述
MRSM75 Rotation detection MR sensor
MRUS51S Micro power Built-in IC ultra-minimum MR sensor
MS-012AA SOIC: 8−LEAD (POWER ICS ONLY)
MS1022 PNP RF Amplifier Transistor Surface Mount
MS1022-CT1 PNP RF Amplifier Transistor Surface Mount
相關代理商/技術參數
參數描述
MRF24J40MA 制造商:Microchip Technology Inc 功能描述:WIRELESS TRANCEIVER MODULE, Supply Voltage Min:2.4V, Supply Voltage Max:3.6V, MS
MRF24J40MA-I/RM 功能描述:Zigbee/802.15.4模塊 2.4GHz IEEE 802.15.4 Transceiver Module RoHS:否 制造商:Digi International 頻帶:902 MHz to 928 MHz 視線范圍: 數據速率: 靈敏度: 工作電源電壓:2.4 V to 3.6 V 傳輸供電電流:215 mA 接收供電電流:26 mA 輸出功率:250 mW 天線連接器類型:Wire 最大工作溫度:+ 85 C 尺寸:32.94 mm x 22 mm x 2.03 mm
MRF24J40MAT-I/RM 功能描述:射頻接收器 2.4GHz IEEE 802.15.4 Transceiver Module RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel
MRF24J40MB-I 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:IEEE 802.15.4a?￠ 2.4 GHz RF Transceiver
MRF24J40MB-I/RM 功能描述:Zigbee/802.15.4模塊 2.4GHz, 802.15.4 Xcvr w/int PA RoHS:否 制造商:Digi International 頻帶:902 MHz to 928 MHz 視線范圍: 數據速率: 靈敏度: 工作電源電壓:2.4 V to 3.6 V 傳輸供電電流:215 mA 接收供電電流:26 mA 輸出功率:250 mW 天線連接器類型:Wire 最大工作溫度:+ 85 C 尺寸:32.94 mm x 22 mm x 2.03 mm
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*