- 您現在的位置：買賣IC網 > PDF目錄26838 > MPC932PFA (MOTOROLA INC) PLL BASED CLOCK DRIVER, 6 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQFP32 PDF資料下載
參數資料
| 型號： | MPC932PFA |
| 廠商： | MOTOROLA INC |
| 元件分類： | 時鐘及定時 |
| 英文描述： | PLL BASED CLOCK DRIVER, 6 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQFP32 |
| 封裝： | TQFP-32 |
| 文件頁數： | 5/8頁 |
| 文件大?。?/td> | 115K |
| 代理商： | MPC932PFA |
MPC932P
TIMING SOLUTIONS
BR1333 — REV 5
5
MOTOROLA
APPLICATIONS INFORMATION
MPC932P
Figure 2. MPC932P Potential Configurations
(Mode = 1)
FBSEL0
‘0’
FBSEL1
‘0’
FB_In
66MHz
Qn
66MHz
QFB
6
1
Input Ref
66MHz
MPC932P
FBSEL0
‘1’
FBSEL1
‘0’
FB_In
83MHz
Qn
66MHz
QFB
6
1
Input Ref
66MHz
MPC932P
FBSEL0
‘1’
FBSEL1
‘0’
FB_In
75MHz
Qn
60MHz
QFB
6
1
Input Ref
60MHz
MPC932P
FBSEL0
‘0’
FBSEL1
‘1’
FB_In
100MHz
Qn
66MHz
QFB
6
1
Input Ref
66MHz
Power Supply Filtering
The MPC932P is a mixed analog/digital product and as
such it exhibits some sensitivities that would not necessarily
be seen on a fully digital product. Analog circuitry is naturally
susceptible to random noise, especially if this noise is seen
on the power supply pins. The MPC932P provides separate
power supplies for the output buffers (VCCO) and the internal
PLL (VCCA) of the device. The purpose of this design
technique is to try and isolate the high switching noise digital
outputs from the relatively sensitive internal analog
phase–locked loop. In a controlled environment such as an
evaluation board this level of isolation is sufficient. However,
in a digital system environment where it is more difficult to
minimize noise on the power supplies a second level of
isolation may be required. The simplest form of isolation is a
power supply filter on the VCCA pin for the MPC932P.
Figure 3. Power Supply Filter
VCCA
VCC
MPC932P
0.01
F
22
F
0.01
F
3.3V
RS=10–15
Figure 3 illustrates a typical power supply filter scheme.
The MPC932P is most susceptible to noise with spectral
content in the 1KHz to 1MHz range. Therefore the filter
should be designed to target this range. The key parameter
that needs to be met in the final filter design is the DC voltage
drop that will be seen between the VCC supply and the VCCA
pin of the MPC932P. From the data sheet the IVCCA current
(the current sourced through the VCCA pin) is typically 15mA
(20mA maximum), assuming that a minimum of 3.0V must be
maintained on the VCCA pin very little DC voltage drop can
be tolerated when a 3.3V VCC supply is used. The resistor
shown in Figure 3 must have a resistance of 10–15
to meet
the voltage drop criteria. The RC filter pictured will provide a
broadband filter with approximately 100:1 attenuation for
noise whose spectral content is above 20KHz. As the noise
frequency crosses the series resonant point of an individual
capacitor its overall impedance begins to look inductive and
thus increases with increasing frequency. The parallel
capacitor combination shown ensures that a low impedance
path to ground exists for frequencies well above the
bandwidth of the PLL.
Although the MPC932P has several design features to
minimize the susceptibility to power supply noise (isolated
power and grounds and fully differential PLL) there still may
be applications in which overall performance is being
degraded due to system power supply noise. The power
supply filter schemes discussed in this section should be
adequate to eliminate power supply noise related problems
in most designs.
相關PDF資料 |
PDF描述 |
|---|---|
| MPC9331FA | PLL BASED CLOCK DRIVER, 6 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQFP32 |
| MPC9331FAR2 | PLL BASED CLOCK DRIVER, 6 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQFP32 |
| MPC9351FAR2 | 9351 SERIES, PLL BASED CLOCK DRIVER, 9 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQFP32 |
| MPC9352AC | 9352 SERIES, PLL BASED CLOCK DRIVER, 11 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQFP32 |
| MPC9352ACR2 | 9352 SERIES, PLL BASED CLOCK DRIVER, 11 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQFP32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPC9330 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:3.3V / 2.5V 1:6 LVCMOS PLL CLOCK GENERATOR |
| MPC9330AC | 功能描述:時鐘發生器及支持產品 FSL 1-6 LVCMOS PLL Clock Generator RoHS:否 制造商:Silicon Labs 類型:Clock Generators 最大輸入頻率:14.318 MHz 最大輸出頻率:166 MHz 輸出端數量:16 占空比 - 最大:55 % 工作電源電壓:3.3 V 工作電源電流:1 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-56 |
| MPC9330ACR2 | 功能描述:IC PLL CLOCK GENERATOR 32-LQFP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:- 類型:時鐘/頻率合成器，扇出分配 PLL:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 除法器/乘法器:- 電源電壓:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:56-VFQFN 裸露焊盤 供應商設備封裝:56-VFQFP-EP（8x8） 包裝:帶卷 (TR) 其它名稱:844S012AKI-01LFT |
| MPC9330FA | 功能描述:時鐘發生器及支持產品 3.3V 200MHz Clock Generator RoHS:否 制造商:Silicon Labs 類型:Clock Generators 最大輸入頻率:14.318 MHz 最大輸出頻率:166 MHz 輸出端數量:16 占空比 - 最大:55 % 工作電源電壓:3.3 V 工作電源電流:1 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-56 |
| MPC9330FAR2 | 制造商:Integrated Device Technology Inc 功能描述:MPC9330FAR2 - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。