- 您現在的位置：買賣IC網 > PDF目錄45309 > MCAQE16G6APP-MXA FLASH MEMORY DRIVE CONTROLLER, PQFP PDF資料下載
參數資料
| 型號： | MCAQE16G6APP-MXA |
| 元件分類： | 存儲控制器/管理單元 |
| 英文描述： | FLASH MEMORY DRIVE CONTROLLER, PQFP |
| 封裝： | LQFP |
| 文件頁數： | 11/65頁 |
| 文件大?。?/td> | 799K |
| 代理商： | MCAQE16G6APP-MXA |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁
NAND Flash-based Solid State Disk
19
Sep. 27. 2006
Figure 2 defines the relationships between the interface signals for PIO data transfers. Peripherals reporting support for PIO mode 3
or 4 shall power-up in a PIO mode 0,1, or 2.
For PIO modes 3 and above, the minimum value of t0 is specified by word 68 in the IDENTIFY DEVICE parameter list. Table 2
defines the minimum value that shall be placed in word 68.
IORDY shall be supported when PIO mode 3 or 4 are the current mode of operation.
DIOR-/DIOW-
WRITE DD(15:0)
IORDY
t1
ADDR valid
t2
(See note 1)
(See note 2)
(See note 3,3-2)
IORDY
(See note 3,3-1)
IORDY
(See note 3,3-3)
t9
t0
t3
t4
t5
t6
t6Z
tA
tC
tRD
tB
tC
NOTE:
1. Device address consists of signals CS0-, CS1- and DA(2:0)
2. Data consists of DD(15:0) for all devices except devices implementing the CFA feature set when 8-bit transfers is enabled. In that case, data consists
of DD(7:0)
3. The negation of IORDY by the device is used to extend the PIO cycle. The determination of whether the cycle is to be extended is made
by the host after tA from the assertion of DIOR- or DIOW-. The assertion and negation of IORDY are described in the following three cases:
3-1. Device never negates IORDY, devices keeps IORDY released: no wait is generated.
3-2. Device negates IORDY before tA, but causes IORDY to be asserted before tA.
IORDY is released prior to negation and may be asserted for no more than 5ns before release: no wait generated.
3-3. Device negates IORDY before tA. IORDY is released prior to negation and may be asserted for no more than 5ns before release: wait generated.
The cycle completes after IORDY is reasserted. For cycles where a wait is generated and DIOR- is asserted, the device shall place read data on
DD(7:0) for tRD before asserting IORDY.
4. DMACK- shall be negated during a PIO data transfer.
Figure 2. PIO data transfer to/from device.
DD(7:0)
t2i
READ DD(15:0)
(See note 2)
DD(7:0)
4.5.2 PIO Data Transfers
相關PDF資料 |
PDF描述 |
|---|---|
| MCBOE32GQAPQ-MWA | FLASH MEMORY DRIVE CONTROLLER, PBGA |
| MC8DE08GQAPR-MWA | FLASH MEMORY DRIVE CONTROLLER, PBGA |
| MCC3E0RX180WB0B | 180 MHz, RISC PROCESSOR, CBGA728 |
| MCCF68HC08LK60 | 8-BIT, FLASH, 4 MHz, MICROCONTROLLER, UUC150 |
| MCW68HC08LK60 | 8-BIT, FLASH, 4 MHz, MICROCONTROLLER, UUC150 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCAQE32G5APP-0XA00 | 制造商:Samsung Semiconductor 功能描述: |
| MCAQE32G8APP-0XA00 | 制造商:Samsung SDI 功能描述:Flash Card 32G-byte 3.3V/5V Flash Disk 44-Pin Tray |
| MCAS015.XP | 制造商:Littelfuse 功能描述:FUSE - MCASE 32V 15A 1-PC CARD 制造商:Littelfuse 功能描述:RETAIL / FUSE - MCASE 32V 15A 1-pc Card |
| MCAS020.XP | 制造商:Littelfuse 功能描述:FUSE - MCASE 32V 20A 1-PC CARD 制造商:Littelfuse 功能描述:RETAIL / FUSE - MCASE 32V 20A 1-pc Card |
| MCAS025.XP | 制造商:Littelfuse 功能描述:FUSE - MCASE 32V 25A 1-PC CARD 制造商:Littelfuse 功能描述:RETAIL / FUSE - MCASE 32V 25A 1-pc Card |
發布緊急采購，3分鐘左右您將得到回復。