參數資料
型號: MC80C52TXXX-30
廠商: ATMEL CORP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 30 MHz, MICROCONTROLLER, CDIP40
封裝: 0.600 INCH, SIDE BRAZED, DIP-40
文件頁數: 152/234頁
文件大小: 25028K
代理商: MC80C52TXXX-30
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁當前第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁第218頁第219頁第220頁第221頁第222頁第223頁第224頁第225頁第226頁第227頁第228頁第229頁第230頁第231頁第232頁第233頁第234頁
24
ATtiny25/45/85 [DATASHEET]
2586Q–AVR–08/2013
6.1.4
ADC Clock – clk
ADC
The ADC is provided with a dedicated clock domain. This allows halting the CPU and I/O clocks in order to reduce
noise generated by digital circuitry. This gives more accurate ADC conversion results.
6.1.5
Internal PLL for Fast Peripheral Clock Generation - clk
PCK
The internal PLL in ATtiny25/45/85 generates a clock frequency that is 8x multiplied from a source input. By
default, the PLL uses the output of the internal, 8.0 MHz RC oscillator as source. Alternatively, if bit LSM of
PLLCSR is set the PLL will use the output of the RC oscillator divided by two. Thus the output of the PLL, the fast
peripheral clock is 64 MHz. The fast peripheral clock, or a clock prescaled from that, can be selected as the clock
source for Timer/Counter1 or as a system clock. See Figure 6-2. The frequency of the fast peripheral clock is
divided by two when LSM of PLLCSR is set, resulting in a clock frequency of 32 MHz. Note, that LSM can not be
set if PLL
CLK is used as system clock.
Figure 6-2.
PCK Clocking System.
The PLL is locked on the RC oscillator and adjusting the RC oscillator via OSCCAL register will adjust the fast
peripheral clock at the same time. However, even if the RC oscillator is taken to a higher frequency than 8 MHz,
the fast peripheral clock frequency saturates at 85 MHz (worst case) and remains oscillating at the maximum fre-
quency. It should be noted that the PLL in this case is not locked any longer with the RC oscillator clock. Therefore,
it is recommended not to take the OSCCAL adjustments to a higher frequency than 8 MHz in order to keep the PLL
in the correct operating range.
The internal PLL is enabled when:
The PLLE bit in the register PLLCSR is set.
The CKSEL fuse is programmed to ‘0001’.
The CKSEL fuse is programmed to ‘0011’.
The PLLCSR bit PLOCK is set when PLL is locked.
Both internal RC oscillator and PLL are switched off in power down and stand-by sleep modes.
6.1.6
Internal PLL in ATtiny15 Compatibility Mode
Since ATtiny25/45/85 is a migration device for ATtiny15 users there is an ATtiny15 compatibility mode for back-
ward compatibility. The ATtiny15 compatibility mode is selected by programming the CKSEL fuses to ‘0011’.
In the ATtiny15 compatibility mode the frequency of the internal RC oscillator is calibrated down to 6.4 MHz and the
multiplication factor of the PLL is set to 4x. See Figure 6-3. With these adjustments the clocking system is
ATtiny15-compatible and the resulting fast peripheral clock has a frequency of 25.6 MHz (same as in ATtiny15).
1/2
8 MHz
LSM
8.0 MHz
OSCILLATOR
PLL
8x
CKSEL[3:0]
PLLE
OSCCAL
4 MHz
1/4
LOCK
DETECTOR
PRESCALER
CLKPS[3:0]
SYSTEM
CLOCK
PLOCK
PCK
OSCILLATORS
XTAL1
XTAL2
64 / 32 MHz
8 MHz
16 MHz
相關PDF資料
PDF描述
MQ80C32-30SHXXX 8-BIT, 30 MHz, MICROCONTROLLER, CQFP44
MC80C32-25:D 8-BIT, 25 MHz, MICROCONTROLLER, CDIP40
MD80C32E-20SHXXX:D 8-BIT, 20 MHz, MICROCONTROLLER, CDIP40
MD80C52EXXX-36:D 8-BIT, MROM, 36 MHz, MICROCONTROLLER, CDIP40
MQ80C32-12SHXXX:R 8-BIT, 12 MHz, MICROCONTROLLER, CQFP44
相關代理商/技術參數
參數描述
MC80D21000G 制造商:COR 功能描述:RN
MC80F0104 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-BIT SINGLE-CHIP MICROCONTROLLERS
MC80F0104B 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-BIT SINGLE-CHIP MICROCONTROLLERS
MC80F0104D 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-BIT SINGLE-CHIP MICROCONTROLLERS
MC80F0204 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-BIT SINGLE-CHIP MICROCONTROLLERS