參數資料
型號： MC705JJ7CDWE
廠商： Freescale Semiconductor
文件頁數： 107/164頁
文件大?。?/td> 0K
描述： IC MCU 8BIT 224B RAM 20-SOIC
標準包裝： 38
系列： HC05
核心處理器： HC05
芯體尺寸： 8-位
速度： 2.1MHz
連通性： SIO
外圍設備： POR，溫度傳感器，WDT
輸入/輸出數： 14
程序存儲器容量： 6KB（6K x 8）
程序存儲器類型： OTP
RAM 容量： 224 x 8
電壓 - 電源 (Vcc/Vdd)： 2.7 V ~ 5.5 V
數據轉換器： A/D 4x12b
振蕩器型： 內部
工作溫度： -40°C ~ 85°C
封裝/外殼： 20-SOIC（0.295"，7.50mm 寬）
包裝： 管件
Reset States
MC68HC705JJ7 MC68HC705JP7 Advance Information Data Sheet, Rev. 4.1
Freescale Semiconductor
47
5.5.4 COP Watchdog
A reset clears the COP watchdog timeout counter.
5.5.5 16-Bit Programmable Timer
A reset has these effects on the 16-bit programmable timer:
Initializes the timer counter registers (TMRH and TMRL) to a value of $FFFC
Initializes the alternate timer counter registers (ACRH and ACRL) to a value of $FFFC
Clears all the interrupt enables and the output level bit (OLVL) in the timer control register (TCR)
Does not affect the input capture edge bit (IEDG) in the TCR
Does not affect the interrupt flags in the timer status register (TSR)
Does not affect the input capture registers (ICRH and ICRL)
Does not affect the output compare registers (OCRH and OCRL)
5.5.6 Serial Interface
A reset has these effects on the serial interface:
Clears all bits in the SIOP control register (SCR)
Clears all bits in the SIOP status register (SSR)
Does not affect the contents of the SIOP data register (SDR)
A reset, therefore, disables the SIOP and leaves the shared port B pins as general I/O. Any pending
interrupt flag is cleared and the SIOP interrupt is disabled. Also the baud rate defaults to the slowest rate.
5.5.7 Analog Subsystem
A reset has these effects on the analog subsystem:
Clears all the bits in the multiplex register (AMUX) bits except the hold switch bit (HOLD) which is
set
Clears all the bits in the analog control register (ACR)
Clears all the bits in the analog status register (ASR)
A reset, therefore, connects the negative input of comparator 2 to the channel selection bus, which is
switched to VSS. Both comparators are set up as non-inverting (a higher positive voltage on the positive
input results in a positive output) and both are powered down. The current source and discharge device
on the PB0/AN0 pin is disabled and powered down. Any analog subsystem interrupt flags are cleared and
the analog interrupt is disabled. Direct drive by comparator 1 to the PB4 pin and the voltage offset to the
sample capacitor are disabled (if both are enabled by the OPT bit being set in the COPR).
5.5.8 External Oscillator and Internal Low-Power Oscillator
A reset presets the oscillator select bits (OM1 and OM2) in the interrupt status and control register (ISCR)
such that the device runs from the internal oscillator (OM1 = 0, OM2 = 1) which has these effects on the
oscillators:
The internal low-power oscillator is enabled and selected.
The external oscillator is disabled.
The CPU bus clock is driven from the internal low-power oscillator.
相關PDF資料
PDF描述
VI-B1H-IY-F4 CONVERTER MOD DC/DC 52V 50W
VE-B43-IX-B1 CONVERTER MOD DC/DC 24V 75W
AD724JRZ-RL IC ENCODER RGB TO NTSC 16SOIC TR
VE-B42-IX-B1 CONVERTER MOD DC/DC 15V 75W
VI-B1F-IY-F3 CONVERTER MOD DC/DC 72V 50W
相關代理商/技術參數
參數描述
MC705JJ7CDWE 制造商:Freescale Semiconductor 功能描述:8-Bit Microcontroller IC
MC705JP7CPE 功能描述:8位微控制器 -MCU 8B MCU 224 BYTES RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
MC705JP7CPE 制造商:Freescale Semiconductor 功能描述:IC 8BIT MCU 68HC05 2.1MHZ DIP-28
MC705K1CP 制造商:Motorola Inc 功能描述:16 PIN DIP INTEGRATED CIRCUIT
MC705L16CFUE 功能描述:8位微控制器 -MCU 8B MCU W/ EPROM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*