- 您現在的位置：買賣IC網 > PDF目錄45202 > MB9AF312LPMC 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP64 PDF資料下載
參數資料
| 型號： | MB9AF312LPMC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP64 |
| 封裝： | 0.65 MM PITCH, PLASTIC, LQFP-64 |
| 文件頁數： | 35/114頁 |
| 文件大小： | 1357K |
| 代理商： | MB9AF312LPMC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁當前第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁
27
ATmega48PA/88PA/168PA [DATASHEET]
9223F–AVR–04/14
The CKSEL0 Fuse together with the SUT1...0 fuses select the start-up times as shown in Table 9-4 on page 27.
9.4
Full Swing Crystal Oscillator
Pins XTAL1 and XTAL2 are input and output, respectively, of an inverting amplifier which can be configured for use as an
on-chip oscillator, as shown in Figure 9-2 on page 26. Either a quartz crystal or a ceramic resonator may be used.
This crystal oscillator is a full swing oscillator, with rail-to-rail swing on the XTAL2 output. This is useful for driving other clock
inputs and in noisy environments. The current consumption is higher than the Section 9.3 “Low Power Crystal Oscillator” on
C1 and C2 should always be equal for both crystals and resonators. The optimal value of the capacitors depends on the
crystal or resonator in use, the amount of stray capacitance, and the electromagnetic noise of the environment. Some initial
guidelines for choosing capacitors for use with crystals are given in Table 9-6 on page 28. For ceramic resonators, the
capacitor values given by the manufacturer should be used.
The operating mode is selected by the fuses CKSEL3...1 as shown in Table 9-5.
Table 9-4.
Start-up Times for the Low Power Crystal Oscillator Clock Selection
Oscillator Source / Power
Conditions
Start-up Time from Power-
down and Power-save
Additional Delay from
Reset
(VCC = 5.0V)
CKSEL0
SUT1...0
Ceramic resonator, fast rising
power
258CK
14CK + 4.1ms(1)
0
00
Ceramic resonator, slowly rising
power
258CK
14CK + 65ms(1)
0
01
Ceramic resonator, BOD
enabled
1KCK
14CK(2)
0
10
Ceramic resonator, fast rising
power
1KCK
14CK + 4.1ms(2)
0
11
Ceramic resonator, slowly rising
power
1KCK
14CK + 65ms(2)
1
00
Crystal Oscillator, BOD enabled
16KCK
14CK
1
01
Crystal Oscillator, fast rising
power
16KCK
14CK + 4.1ms
1
10
Crystal Oscillator, slowly rising
power
16KCK
14CK + 65ms
1
11
Notes: 1.
These options should only be used when not operating close to the maximum frequency of the device, and
only if frequency stability at start-up is not important for the application. These options are not suitable for
crystals.
2.
These options are intended for use with ceramic resonators and will ensure frequency stability at start-up.
They can also be used with crystals when not operating close to the maximum frequency of the device, and if
frequency stability at start-up is not important for the application.
Table 9-5.
Full Swing Crystal Oscillator operating modes
Frequency Range(1) (MHz)
Recommended Range for
Capacitors C1 and C2 (pF)
CKSEL3...1
0.4 - 20
12 - 22
011
Notes: 1.
If the crystal frequency exceeds the specification of the device (depends on VCC), the CKDIV8 Fuse can be
programmed in order to divide the internal frequency by 8. It must be ensured that the resulting divided clock
meets the frequency specification of the device.
相關PDF資料 |
PDF描述 |
|---|---|
| MB9AF311NPMC | 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP100 |
| MB9AF316NPMC | RISC MICROCONTROLLER, PQFP100 |
| MB9AF314NPMC | RISC MICROCONTROLLER, PQFP100 |
| MB9AF312NPF | RISC MICROCONTROLLER, PQFP100 |
| MB9AF312LPMC1 | RISC MICROCONTROLLER, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB9AF314LAPMC1-G-JNE2 | 制造商:FUJITSU 功能描述: |
| MB9AF314LAPMC-G-JNE2 | 制造商:Fujitsu 功能描述:Bulk |
| MB9AF314LAQN-G-AVE2 | 功能描述:ARM? Cortex?-M3 FM3 MB9A310A Microcontroller IC 32-Bit 40MHz 256KB (256K x 8) FLASH 64-QFN Exposed Pad (9x9) 制造商:cypress semiconductor corp 系列:FM3 MB9A310A 包裝:托盤 零件狀態:有效 核心處理器:ARM? Cortex?-M3 核心尺寸:32-位 速度:40MHz 連接性:CSIO，I2C，LIN，UART/USART，USB 外設:DMA，LVD，POR，PWM，WDT I/O 數:51 程序存儲容量:256KB（256K x 8） 程序存儲器類型:閃存 EEPROM 容量:- RAM 容量:32K x 8 電壓 - 電源（Vcc/Vdd）:2.7 V ~ 5.5 V 數據轉換器:A/D 9x12b 振蕩器類型:內部 工作溫度:-40°C ~ 105°C（TA） 封裝/外殼:64-VFQFN 裸露焊盤 供應商器件封裝:64-QFN 裸露焊盤（9x9） 標準包裝:260 |
| MB9AF314LPMC1-ESE1 | 制造商:FUJITSU 功能描述: |
| MB9AF314LPMC1-GE1 | 制造商:FUJITSU 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。