
MAX9121/MAX9122
Quad LVDS Line Receivers with
Integrated Termination and Flow-Through Pinout
6
_______________________________________________________________________________________
Detailed Description
The LVDS interface standard is a signaling method
intended for point-to-point communication over a con-
trolled-impedance medium as defined by the ANSI
TIA/EIA-644 and IEEE 1596.3 standards. The LVDS stan-
dard uses a lower voltage swing than other common
communication standards, achieving higher data rates
with reduced power consumption while reducing EMI
emissions and system susceptibility to noise.
The MAX9121/MAX9122 are 500Mbps, four-channel
LVDS receivers intended for high-speed, point-to-point,
low-power applications. Each channel accepts an
LVDS input and translates it to an LVTTL/LVCMOS out-
put. The receiver is capable of detecting differential
signals as low as 100mV and as high as 1V within an
input voltage range of 0 to 2.4V. The 250mV to 400mV
differential output of an LVDS driver is nominally cen-
tered around a +1.2V offset. This offset, coupled with
the receiver’s 0 to 2.4V input voltage range, allows an
approximate ±1V shift in the signal (as seen by the
receiver). This allows for a difference in ground refer-
ences of the transmitter and the receiver, the common-
mode effects of coupled noise, or both. The LVDS stan-
dards specify an input voltage range of 0 to +2.4V
referenced to receiver ground.
The MAX9122 has an integrated termination resistor
that is internally connected across each receiver input.
The internal termination saves board space, eases lay-
out, and reduces stub length compared to an external
termination resistor. In other words, the transmission
line is terminated on the IC.
Fail-Safe
The fail-safe feature of the MAX9121/MAX9122 sets an
output high when:
Inputs are open.
Inputs are undriven and shorted.
Inputs are undriven and terminated.
A fail-safe circuit is important because under these
conditions, noise at the inputs may switch the receiver
and it may appear to the system that data is being
Pin Description
PIN
NAME
FUNCTION
1, 4, 5, 8
IN_-
Inverting Differential Receiver Inputs
2, 3, 6, 7
IN_+
Noninverting Differential Receiver Inputs
9, 16
EN, EN
Receiver Enable Inputs. When EN = high and
EN = low or open, the outputs are active. For
other combinations of EN and
EN, the outputs are disabled and in high impedance.
10, 11, 14, 15
OUT_
LVCMOS/LVTTL Receiver Outputs
12
GND
Ground
13
VCC
Power-Supply Input. Bypass VCC to GND with 0.1F and 0.001F ceramic capacitors.
Table 1. Input/Output Function Table
ENABLES
INPUTS
OUTPUT
EN
EN
(IN_+) - (IN_-)
OUT_
VID
≥ +100mV
H
VID
≤ -100mV
L
MAX9121
Open, undriven short, or undriven
100
parallel termination
H
L or open
MAX9122
Open or undriven short
H
All other combinations of ENABLE pins
Don’t care
Z