- 您現在的位置：買賣IC網 > PDF目錄45053 > M8803F2W-15T1 (STMICROELECTRONICS) 1M X 1 FLASH, 27 I/O, PIA-GENERAL PURPOSE, PQFP52 PDF資料下載
參數資料
| 型號： | M8803F2W-15T1 |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 1M X 1 FLASH, 27 I/O, PIA-GENERAL PURPOSE, PQFP52 |
| 封裝： | PLASTIC, QFP-52 |
| 文件頁數： | 40/85頁 |
| 文件大?。?/td> | 601K |
| 代理商： | M8803F2W-15T1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁當前第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁
45/85
M88 FAMILY
driven out to the pins if the Direction Register or
the output enable product term is set to “1”. The
contents of the register can also be read back by
the microcontroller.
Output Macrocells (OMCs)
The CPLD OMCs occupy a location in the
microcontroller’s
address
space.
The
microcontroller can read the output of the OMCs.
If the Mask Macrocell Register bits are not set,
writing to the Macrocell loads data to the Macrocell
flip flops. Refer to the section entitled “Output
Macrocell”, on page 29.
Mask Macrocell Register
Each Mask Register bit corresponds to an OMC
flip flop. When the Mask Register bit is set to a “1”,
loading data into the OMC flip flop is blocked. The
default value is “0” or unblocked.
Inpu t Macrocells (IMCs)
The IMCs can be used to latch or store external
inputs. The outputs of the IMCs are routed to the
PLD
input bus, and
can be
read by the
microcontroller. Refer to the section entitled
“PLDs”, on page 23.
Enable Out
The Enable Out register can be read by the
microcontroller. It contains the output enable
values for a given port. A “1” indicates the driver is
in output mode. A “0” indicates the driver is in tri-
state and the pin is in input mode.
Ports A and B – Functionality and Structure
Ports A and B have similar functionality and
structure, as shown in Figure 29. The two ports
can be configured to perform one or more of the
following functions:
t MCU I/O Mode
t CPLD Output – Macrocells McellAB[7:0] can be
connected to Port A or Port B. McellBC[7:0] can be
connected to Port B or Port C.
t CPLD Input – Via the input Macrocells.
t Latched Address output – Provide latched
address output per Table 32.
t Address In – Additional high address inputs
using the Input Macrocells.
t Open Drain/Slew Rate – pins PA[3:0] and
PB[3:0] can be configured to fast slew rate, pins
PA[7:4] and PB[7:4] can be configured to Open
Drain Mode.
t Data Port – Port A to D[7:0] for 8 bit non-
multiplexed bus
t Multiplexed Address/Data port for certain types
of microcontroller interfaces.
Figu re 30. Port C Structure
Note: 1. ISP or Battery Back-up
INTERNAL
DATA
BUS
DATA OUT
REG.
DQ
WR
MCELLBC[ 7:0]
ENABLE PRODUCT TERM (.OE)
READ MUX
P
D
B
CPLD-INPUT
DIR REG.
INPUT
MACROCELL
ENABLE OUT
SPECIAL FUNCTION
1
SPECIAL FUNCTION
1
CONFIGURATION
BIT
DATA IN
OUTPUT
SELECT
OUTPUT
MUX
PORT C PIN
DATA OUT
AI02888
相關PDF資料 |
PDF描述 |
|---|---|
| M8813F3W-15K1 | 1M X 1 FLASH, 27 I/O, PIA-GENERAL PURPOSE, PQCC52 |
| M8813F3Y-90K1 | 1M X 1 FLASH, 27 I/O, PIA-GENERAL PURPOSE, PQCC52 |
| M8813F3Y-90T1 | 1M X 1 FLASH, 27 I/O, PIA-GENERAL PURPOSE, PQFP52 |
| M8803F3Y-90K1T | 1M X 1 FLASH, 27 I/O, PIA-GENERAL PURPOSE, PQCC52 |
| M8813F3Y-90K1T | 1M X 1 FLASH, 27 I/O, PIA-GENERAL PURPOSE, PQCC52 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M8805/100-007 | 制造商:OTTO Engineering Inc 功能描述:M8805/100-007 |
| M8805/100-009 | 制造商:OTTO Engineering Inc 功能描述:M8805/100-009 |
| M8805/100-010 | 制造商:OTTO Engineering Inc 功能描述:M8805/100-010 |
| M8805/100-015 | 制造商:OTTO Engineering Inc 功能描述:M8805/100-015 |
| M8805/100-016 | 制造商:OTTO Engineering Inc 功能描述:M8805/100-016 |
發布緊急采購，3分鐘左右您將得到回復。