參數資料
型號: M3823AGF-XXXHP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP80
封裝: 12 X 12 MM, 0.50 MM PITCH, PLASTIC, LQFP-80
文件頁數: 26/76頁
文件大小: 896K
代理商: M3823AGF-XXXHP
Rev.2.02
Jun 19, 2007
page 32 of 73
REJ03B0146-0202
3823 Group
Timer 1, Timer 2, Timer 3
Timer 1, timer 2, and timer 3 are 8-bit timers. The count source for
each timer can be selected by timer 123 mode register. The timer
latch value is not affected by a change of the count source. How-
ever, because changing the count source may cause an
inadvertent count down of the timer, rewrite the value of timer
whenever the count source is changed.
●Timer 2 write control
If the timer 2 write control bit is “0”, when the value is written in the
address of timer 2, the value is loaded in the timer 2 and the latch
at the same time.
If the timer 2 write control bit is “1”, when the value is written in the
address of timer 2, the value is loaded only in the latch. The value
in the latch is loaded in timer 2 after timer 2 underflows.
●Timer 2 output control
When the timer 2 (TOUT) is output enabled, an inversion signal
from the TOUT pin is output each time timer 2 underflows.
In this case, set the port shared with the TOUT pin to the output
mode.
■Notes on timer 1 to timer 3
When the count source of timer 1 to 3 is changed, the timer count-
ing value may be changed large because a thin pulse is generated
in count input of timer . If timer 1 output is selected as the count
source of timer 2 or timer 3, when timer 1 is written, the counting
value of timer 2 or timer 3 may be changed large because a thin
pulse is generated in timer 1 output.
Therefore, set the value of timer in the order of timer 1, timer 2
and timer 3 after the count source selection of timer 1 to 3.
Fig. 25 Structure of timer 123 mode register
TOUT output active edge switch bit
0 : Start at “H” output
1 : Start at “L” output
TOUT output control bit
0 : TOUT output disabled
1 : TOUT output enabled
Timer 2 write control bit
0 : Write data in latch and counter
1 : Write data in latch only
Timer 2 count source selection bit
0 : Timer 1 output
1 : f(XIN)/16
(or f(SUB)/16 in low-speed mode)
Timer 3 count source selection bit
0 : Timer 1 output
1 : f(XIN)/16
(or f(SUB)/16 in low-speed mode)
Timer 1 count source selection bit
0 : f(XIN)/16
(or f(SUB)/16 in low-speed mode)
1 : f(SUB)
Not used (return “0” when read)
Timer 123 mode register
(T123M :address 002916)
Note: f(SUB) is the source oscillation frequency in low-speed
mode. f(SUB) shows the oscillation frequency of XCIN or
the on-chip oscillator.
Internal clock φ is f(SUB)/2 in the low-speed mode.
b7
b0
相關PDF資料
PDF描述
M38238G8FP 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP80
M3823AGFHP 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP80
M38239GC-XXXFP 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP80
M38234G4HP 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP80
M38235G6HP 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP80
相關代理商/技術參數
參數描述
M3823AT-RLFS 功能描述:DEV EMULATOR PERSONALITY KIT M38 RoHS:否 類別:編程器,開發系統 >> 配件 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program RoHS指令信息:IButton RoHS Compliance Plan 標準包裝:1 系列:- 附件類型:USB 至 1-Wire? RJ11 適配器 適用于相關產品:1-Wire? 設備 產品目錄頁面:1429 (CN2011-ZH PDF)
M3823-BLACK-1000 制造商:Alpha Wire 功能描述:
M3824 功能描述:電纜固定件和配件 LTSCG 1000 BLACK RoHS:否 制造商:Heyco 類型:Cable Grips, Liquid Tight 材料:Nylon 顏色:Black 安裝方法:Cable 最大光束直徑:11.4 mm 抗拉強度:
M38257E8FP 制造商:Renesas Electronics Corporation 功能描述:8-BIT, OTPROM, 4 MHz, MICROCONTROLLER, PQFP100
M38257E8FS 功能描述:IC 740 MCU OTP 32K 100-PQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:740/38000 標準包裝:160 系列:S08 核心處理器:S08 芯體尺寸:8-位 速度:40MHz 連通性:I²C,LIN,SCI,SPI 外圍設備:LCD,LVD,POR,PWM,WDT 輸入/輸出數:53 程序存儲器容量:32KB(32K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1.9K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 12x12b 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:64-LQFP 包裝:托盤