- 您現在的位置：買賣IC網 > PDF目錄98006 > M37733MHBXXXFP 16-BIT, MROM, 25 MHz, MICROCONTROLLER, PQFP80 PDF資料下載
參數資料
| 型號： | M37733MHBXXXFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, MROM, 25 MHz, MICROCONTROLLER, PQFP80 |
| 封裝： | 14 X 20 MM, 0.80 MM PITCH, PLASTIC, QFP-80 |
| 文件頁數： | 13/92頁 |
| 文件大?。?/td> | 1725K |
| 代理商： | M37733MHBXXXFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁
17
MITSUBISHI MICROCOMPUTERS
M37733MHBXXXFP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
PRELIMINARY
Notice:
This
is not
a final
specification.
Some
parametric
limits
are
subject
to change.
Data bus (odd)
Data bus (even)
Count start flag
Down count
Up-down flag
(High-order 8 bits)
Counter(16)
Up/Down
Polarity
selection
Timer (gate function)
TAi IN
f2
f16
f64
f512
Clock source selection
(i = 0 – 4)
Timer
One-shot
Pulse width modulation
Event counter
External trigger
Always decremented
except in event count mode
Timer A0 4716 4616
Timer A1 4916 4816
Timer A2 4B16 4A16
Timer A3 4D16 4C16
Timer A4 4F16 4E16
Address
(Low-order
8 bits)
(Address 4016)
Pulse output
TAi OUT
(i = 0 – 4)
(Address 4416)
Reload register(16)
Toggle flip-flop
TIMER
There are eight 16-bit timers. They are divided by type into timer A(5)
and timer B(3).
The timer I/O pins are also used as I/O pins for ports P5 and P6. To
use these pins as timer input pins, the port direction register bit
corresponding to the pin must be cleared to “0” to specify the input
mode.
TIMER A
Figure 13 shows a block diagram of timer A.
Timer A has four modes; timer mode, event counter mode, one-shot
pulse mode, and pulse width modulation mode. The mode is selected
with bits 0 and 1 of the timer Ai mode register (i = 0 to 4). Each of
these modes is described below.
(1) Timer mode [00]
Figure 14 shows the bit configuration of the timer Ai mode register
during timer mode. Bits 0, 1, and 5 of timer Ai mode register must
always be “0” in the timer mode.
Bit 3 is ignored if bit 4 is “0”.
Bits 6 and 7 are used to select the timer counter source. The counting
of the selected clock starts when the count start flag is “1” and stops
when it is “0”.
Figure 15 shows the bit configuration of the count start flag. The
counter is decremented. An interrupt is caused and the interrupt
request bit of the timer Ai interrupt control register is set when the
contents becomes 000016. At the same time, the contents of the reload
register are transferred to the counter, and count is continued.
Fig. 13 Block diagram of timer A
相關PDF資料 |
PDF描述 |
|---|---|
| M37733S4LHP | 16-BIT, 12 MHz, MICROCONTROLLER, PQFP80 |
| M37734M8LXXXHP | 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| M37735M4BXXXFP | 16-BIT, MROM, 25 MHz, MICROCONTROLLER, PQFP80 |
| M37735MHBXXXFP | 16-BIT, MROM, 25 MHz, MICROCONTROLLER, PQFP80 |
| M37735MHLXXXHP | 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M37733MHL | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M37733MHLXXXHP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M37733S4 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:16-BIT CMOS MICROCOMPUTER |
| M37733S4BFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER |
| M37733S4LHP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。