參數資料
型號: M34583EDFP
元件分類: 微控制器/微處理器
英文描述: 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PQFP32
封裝: 7 X 7 MM, 0.80 MM PITCH, PLASTIC, LQFP-32
文件頁數: 105/153頁
文件大小: 947K
代理商: M34583EDFP
Rev.3.00
Aug 06, 2004
page 55 of 151
REJ03B0009-0300Z
4583 Group
PRELIMINARY
Notice: This is not a final specification.
Some parametric limits are subject to change.
VOLTAGE DROP DETECTION CIRCUIT
The built-in voltage drop detection circuit is designed to detect a
drop in voltage and to reset the microcomputer if the supply voltage
drops below a set value.
Fig. 45 Voltage drop detection reset circuit
Fig. 46 Voltage drop detection circuit operation waveform
Table 15 Voltage drop detection circuit operation state
VDCE pin
“L”
“H”
At CPU operating
Invalid
Valid
EPOF instruction +
POF instruction
Q
S
R
SVDE instruction
Internal reset signal
Key-on wakeup signal
Q
S
R
+
VRST
+
-
VDCE
Voltage drop detection circuit
Reset signal
Voltage drop detection circuit
VRST (reset release voltage)
+
-
VDD
Voltage drop detection circuit
Reset signal
Microcomupter starts operation after
on-chip oscillator (internal oscillator)
clock is counted 120 to 144 times.
VRST (reset voltage)
RESET pin
Note: Detection voltage hysteresis of voltage drop detection circuit is 0.1 V (Typ).
At RAM back-up
(SVDE instruction not executed)
Invalid
At RAM back-up
(SVDE instruction executed)
Invalid
Valid
(2) Note on voltage drop detection circuit
The voltage drop detection circuit detection voltage of this prod-
uct is set up lower than the minimum value of the supply voltage
of the recommended operating conditions.
When the supply voltage of a microcomputer falls below to the
minimum value of recommended operating conditions and re-
goes up (ex. battery exchange of an application product),
depending on the capacity value of the bypass capacitor added
to the power supply pin, the following case may cause program
failure (Figure 47);
supply voltage does not fall below to VRST-, and
its voltage re-goes up with no reset.
In such a case, please design a system which supply voltage is
once reduced below to VRST- and re-goes up after that.
Fig. 47 VDD and VRST–
VDD
Recommended
operatng condition
min.value
No reset
Program failure may occur.
VRST
+
VRST
VDD
Recommended
operatng condition
min.value
VRST
+
VRST
→ Normal operation
Reset
(1) SVDE instruction
When the SVDE instruction is executed, the voltage drop detec-
tion circuit is valid even after system enters into the RAM
back-up mode. The SVDE instruction can be executed only once.
In order to release the execution of the SVDE instruction, the
system reset is required.
相關PDF資料
PDF描述
M35013-001SP 24 X 10 CHARACTERS CRT CHAR DSPL CTLR, PDIP20
M35015-001SP 24 X 10 CHARACTERS CRT CHAR DSPL CTLR, PDIP20
M35014-001SP 24 X 10 CHARACTERS CRT CHAR DSPL CTLR, PDIP20
M35043-XXXFP 24 X 12 CHARACTERS CRT CHAR DSPL CTLR, PDSO20
M35043-XXXSP 24 X 12 CHARACTERS CRT CHAR DSPL CTLR, PDIP20
相關代理商/技術參數
參數描述
M34583MD-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34584EDFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34584MD-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M3459 功能描述:電纜固定件和配件 RLTCG 3/8 NPT GRAY NO NUT RoHS:否 制造商:Heyco 類型:Cable Grips, Liquid Tight 材料:Nylon 顏色:Black 安裝方法:Cable 最大光束直徑:11.4 mm 抗拉強度:
M3460 功能描述:電纜固定件和配件 RLTCG 3/4 NPT BLACK NO NUT RoHS:否 制造商:Heyco 類型:Cable Grips, Liquid Tight 材料:Nylon 顏色:Black 安裝方法:Cable 最大光束直徑:11.4 mm 抗拉強度: