參數資料
型號: M34506M4-XXXFP
元件分類: 微控制器/微處理器
英文描述: 4-BIT, MROM, MICROCONTROLLER, PDSO20
封裝: 5.30 X 12.60 MM, 1.27 MM PITCH, PLASTIC, SOP-20
文件頁數: 9/114頁
文件大?。?/td> 836K
代理商: M34506M4-XXXFP
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁
4
4-17
EIT
32180 Group User’s Manual (Rev.1.0)
Figure 4.9.2 Timing at Which External Interrupt (EI) is Accepted
[EIT Processing]
(1) Saving SM, IE and C bits
The PSW register’s SM, IE and C bits are saved to the respective backup bits: BSM, BIE and BC.
BSM
SM
BIE
IE
BC
C
(2) Updating SM, IE and C bits
The PSW register’s SM, IE and C bits are updated as shown below.
SM
0
IE
0
C
0
(3) Saving the PC
The content of the PC register (always on word boundary) is saved to the BPC register.
(4) Branching to the EIT vector entry
The CPU branches to the address H’0000 0080 in the user space. However, when operating in flash E/W enable
mode, the CPU goes to the beginning of the internal RAM (address H’0080 4000). (For details, see Section 6.5,
“Programming the Internal Flash Memory.”) This is the last operation performed in hardware preprocessing.
(5) Jumping from the EIT vector entry to the user-created handler
The CPU executes the BRA instruction written by the user at the address H’0000 0080 of the EIT vector
entry to jump to the start address of the user-created handler. At the beginning of the user-created EIT
handler, first save the BPC and PSW registers and the necessary general-purpose registers to the stack.
Also, save the accumulator and FPSR register as necessary.
4.9.3 External Interrupt (EI)
An external interrupt is generated upon an interrupt request which is output by the microcomputer’s internal
interrupt controller. The interrupt controller manages interrupt requests by assigning each one of seven priority
levels. For details, see Chapter 5, “Interrupt Controller.” For details about the interrupt request sources, see each
section in which the relevant internal peripheral I/O is described.
[OccurrenceConditions]
External interrupts are managed based on interrupt requests from each internal peripheral I/O by the
microcomputer’s internal interrupt controller, and are sent to the CPU via the interrupt controller. The CPU checks
these interrupt requests at a break in instructions residing on word boundaries, and when an interrupt request is
detected and the PSW register IE flag = "1", accepts it as an external interrupt.
In no case will an external interrupt be activated immediately after executing a 16-bit instruction that starts from
a word boundary. (For 16-bit branch instructions, however, the interrupt is accepted immediately after branching.)
4.9 Interrupt Processing
16-bit instruction
Order in which instructions are executed
32-bit instruction
Address 1000
Address 1002
Address 1004
Address 1008
Interrupt may
be accepted
×
Interrupt cannot
be accepted
16-bit instruction
Interrupt may
be accepted
Interrupt may
be accepted
相關PDF資料
PDF描述
M34506M2-XXXFP 4-BIT, MROM, MICROCONTROLLER, PDSO20
M34507E4FP 4-BIT, OTPROM, MICROCONTROLLER, PDSO24
M34507M2-XXXFP 4-BIT, MROM, MICROCONTROLLER, PDSO24
M34507M4-XXXFP 4-BIT, MROM, MICROCONTROLLER, PDSO24
M34507M2-XXXFP 4-BIT, MROM, MICROCONTROLLER, PDSO24
相關代理商/技術參數
參數描述
M34507E4FP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34507M2-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:4-BIT CISC SINGLE-CHIP MICROCOMPUTER 4500 SERIES
M34507M4-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34508G4FP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34508G4GP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER