- 您現在的位置：買賣IC網 > PDF目錄44995 > LTC3880EUJ-1#PBF (LINEAR TECHNOLOGY CORP) 0.1 A DUAL SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC40 PDF資料下載
參數資料
| 型號： | LTC3880EUJ-1#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.1 A DUAL SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC40 |
| 封裝： | 6 X 6 MM, LEAD FREE, PLASTIC, WJJD-2, QFN-40 |
| 文件頁數： | 24/112頁 |
| 文件大小： | 2182K |
| 代理商： | LTC3880EUJ-1#PBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁
LTC3880/LTC3880-1
19
3880fa
OPERATION
multiple outputs are controlled by the same GPIO pin,
the decay time of the faulted output determines the retry
delay. If the natural decay time of the output is too long,
it is possible to remove the voltage requirement of the
MFR_RETRY_DELAY command by asserting bit 0 of
MFR_CHAN_CONFIG_LTC3880. Alternatively, the con-
troller can be configured so that it remains latched-off
following a fault and clearing requires user intervention
such as toggling RUNn or commanding the part OFF
then ON.
LIGHT LOAD CURRENT OPERATION
The LTC3880 has three modes of operation including high
efficiency Burst Mode operation, discontinuous conduc-
tion mode or forced continuous conduction mode. Mode
selection is done using the MFR_PWM_MODE_LTC3880
command (discontinuous conduction is always the start-
up mode, forced continuous is the default running mode).
In Burst Mode operation the peak current in the inductor
is set to approximately one-third of the maximum sense
voltage even though the voltage on the ITH pin indicates a
lower value. If the average inductor current is higher than
the load current, the error amplifier, EA, will decrease the
voltage on the ITH pin. When the ITH voltage drops below
approximately 0.5V, the internal Burst Mode operation as-
serts and both external MOSFETS are turned off. In Burst
Mode operation, the load current is supplied by the output
capacitor. As the output voltage decreases, the EA output
begins to rise. When the output voltage drops sufficiently,
Burst Mode operation is deasserted, and the controller
resumes normal operation by turning on the top external
MOSFET on the next PWM cycle.
If a controller is enabled for Burst Mode operation, the
inductor current is not allowed to reverse. The reverse
currentcomparator,IREV,turnsoffthebottomgateexternal
MOSFET just before the inductor current reaches zero,
preventing it from reversing and going negative. Thus, the
controllercanoperateindiscontinuousoperation.Inforced
continuousoperation,theinductorcurrentisallowedtore-
verseatlightloadsorunderlargetransientconditions.The
peak inductor current is determined solely by the voltage
on the ITH pin. In this mode, the efficiency at light loads is
lower than in Burst Mode operation. However, continuous
mode exhibits lower output ripple and less interference
with audio circuitry. Forced continuous conduction mode
may result in reverse inductor current, which can cause
the input supply to boost. The VIN_OV_FAULT_LIMIT can
detectthisandturnofftheoffendingchannel.However,this
fault is based on an ADC read and can take up to 120ms
to detect. If there is a concern about the input supply
boosting, keep the part in discontinuous conduction or
Burst Mode operation.
If the part is set to Burst Mode operation, as the inductor
average current increases, the controller will automati-
cally modify the operation from Burst Mode operation,
to discontinuous mode to continuous mode.
SWITCHING FREQUENCY AND PHASE
The switching frequency of the LTC3880’s controller can
be established with internal clock references or with an
external time-base. The LTC3880 can be configured for an
externalclockinputthroughtheprogrammedvalueinNVM,
a PMBus command or setting the RBOTTOM resistor of the
FREQ_CFG pin to 0Ω and the RTOP to open. The PMBus
command FREQUENCY_SWITCH is set to external clock.
TheMFR_PWM_CONFIG_LTC3880commanddetermines
the relative phasing. Using the RCONFIG input, channel 0
and channel 1 have a relative phasing of 0° and 180° with
respect to the falling edge of SYNC. The master should
be selected to be out of phase with the slave. Both RUN
pins must be low or both channels commanded off before
theFREQUENCYandMFR_PWM_CONFIG_LTC3880com-
mands can be written to the LTC3880. The relative phas-
ing of all devices in a PolyPhase rail should be optimally
phased. The relative phasing of each rail is 360/n where
n is the number of phases in the rail.
If the LTC3880 is configured as the oscillator output on
SYNC,theswitchingfrequencysourcecanbeselectedwith
either external configuration resistors or through serial
busprogramming.TheFREQ_CFGconfigurationresistor
pin can be used to select the FREQUENCY_SWITCH
and MFR_PWM_CONFIG_LTC3880 values as outlined
in Table 14. Otherwise, the FREQUENCY_SWITCH and
MFR_PWM_CONFIG_LTC3880PMBuscommandscanbe
used to select PWM switching frequency and the PWM
channel phase relationship. The phase and frequency
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3880IUJ-1#PBF | 0.1 A DUAL SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC40 |
| LTC3890EGN-1#PBF | SWITCHING CONTROLLER, PDSO28 |
| LTC3890IGN-1#TRPBF | SWITCHING CONTROLLER, PDSO28 |
| LTC3890IGN-1#PBF | SWITCHING CONTROLLER, PDSO28 |
| LTC3890MPUH#TRPBF | DUAL SWITCHING CONTROLLER, 585 kHz SWITCHING FREQ-MAX, PQCC32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3880IUJ#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 40-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3880IUJ#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 40-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3880IUJ-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 40-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3880IUJ-1#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 40-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3883EUH#PBF | 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN 制造商:Linear Technology 功能描述:BUCK CNTRL 24V 1MHZ 0.5/5.5V 32QFN 制造商:Linear Technology 功能描述:BUCK, CNTRL, 24V, 1MHZ, 0.5/5.5V, 32QFN 制造商:Linear Technology 功能描述:PWM CONTROLLER, BUCK, 1MHZ, 24V, QFN-32, Input Voltage:24V, Output Voltage:5.5V, Output Current:30A, Supply Voltage Min:4.5V, Supply Voltage Max:24V, Digital IC Case Style:QFN, No. of Pins:32, Frequency:1MHz, MSL:MSL 1 - Unlimited , RoHS Compliant: Yes 制造商:Linear Technology 功能描述:DP-SWREG/Controller, Digitally Programmable, Multiphase Step-Down DC/DC Controll |
發布緊急采購，3分鐘左右您將得到回復。