- 您現在的位置：買賣IC網 > PDF目錄44994 > LTC3851IGN#TRPBF (LINEAR TECHNOLOGY CORP) 0.05 A SWITCHING CONTROLLER, 790 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | LTC3851IGN#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.05 A SWITCHING CONTROLLER, 790 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 0.150 INCH, LEAD FREE, PLASTIC, SSOP-16 |
| 文件頁數： | 4/28頁 |
| 文件大?。?/td> | 325K |
| 代理商： | LTC3851IGN#TRPBF |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC3851
12
3851fb
APPLICATIONS INFORMATION
The Typical Application on the rst page of this data sheet
is a basic LTC3851 application circuit. The LTC3851 can
be congured to use either DCR (inductor resistance)
sensing or low value resistor sensing. The choice of the
two current sensing schemes is largely a design trade-off
between cost, power consumption and accuracy. DCR
sensing is becoming popular because it saves expensive
current sensing resistors and is more power efcient,
especially in high current applications. However, current
sensing resistors provide the most accurate current limits
for the controller. Other external component selection
is driven by the load requirement, and begins with the
selection of RSENSE (if RSENSE is used) and the inductor
value. Next, the power MOSFETs and Schottky diodes are
selected. Finally, input and output capacitors are selected.
The circuit shown on the rst page can be congured for
operation up to 38V at VIN.
Current Limit Programming
The ILIM pin is a tri-level logic input to set the maximum
current limit of the controller. When ILIM is grounded, the
maximum current limit threshold of the current compara-
tor is programmed to be 30mV. When ILIM is oated, the
maximum current limit threshold is 50mV. When ILIM is
tied to INTVCC, the maximum current limit threshold is
set to 75mV.
SENSE+ and SENSE– Pins
The SENSE+ and SENSE– pins are the inputs to the current
comparators. The common mode input voltage range of
the current comparators is 0V to 5.5V. Both SENSE pins
are high impedance inputs with small base currents of
less than 1μA. When the SENSE pins ramp up from 0V
to 1.4V, the small base currents ow out of the SENSE
pins. When the SENSE pins ramp down from 5V to 1.1V,
the small base currents ow into the SENSE pins. The
high impedance inputs to the current comparators allow
accurate DCR sensing. However, care must be taken not
to oat these pins during normal operation.
Low Value Resistors Current Sensing
A typical sensing circuit using a discrete resistor is shown
in Figure 1. RSENSE is chosen based on the required output
current.
The current comparator has a maximum threshold, VMAX,
determined by the ILIM setting. The current comparator
threshold sets the maximum peak of the inductor current,
yielding a maximum average output current, IMAX, equal to
the maximum peak value less half the peak-to-peak ripple
current, ΔIL. Allowing a margin of 20% for variations in
the IC and external component values yields:
R
SENSE = 0.8
V
MAX
I
MAX +ΔIL/2
Inductor DCR Sensing
For applications requiring the highest possible efciency,
the LTC3851 is capable of sensing the voltage drop across
the inductor DCR, as shown in Figure 2. The DCR of the
inductor represents the small amount of DC winding
resistance of the copper, which can be less than 1m
Ω for
today’s low value, high current inductors. If the external
R1||R2 C1 time constant is chosen to be exactly equal
to the L/DCR time constant, the voltage drop across the
external capacitor is equal to the voltage drop across
the inductor DCR multiplied by R2/(R1 + R2). Therefore,
R2 may be used to scale the voltage across the sense
terminals when the DCR is greater than the target sense
resistance. Check the manufacturer’s data sheet for
specications regarding the inductor DCR, in order to
properly dimension the external lter components. The
DCR of the inductor can also be measured using a good
RLC meter.
VIN
INTVCC
BOOST
TG
SW
BG
GND
FILTER COMPONENTS
PLACED NEAR SENSE PINS
SENSE+
SENSE–
LTC3851
VOUT
RSENSE
3851 F01
Figure 1. Using a Resistor to Sense Current with the LTC3851
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3851EUD#TRPBF | 0.05 A SWITCHING CONTROLLER, 790 kHz SWITCHING FREQ-MAX, PQCC16 |
| LTC3858EUH-2#PBF | DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC32 |
| LTC3865EUH-1#TRPBF | DUAL SWITCHING CONTROLLER, 880 kHz SWITCHING FREQ-MAX, PQCC32 |
| LTC3865EFE#PBF | DUAL SWITCHING CONTROLLER, 880 kHz SWITCHING FREQ-MAX, PDSO38 |
| LTC3865IFE#TRPBF | DUAL SWITCHING CONTROLLER, 880 kHz SWITCHING FREQ-MAX, PDSO38 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3851IMSE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3851IMSE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3851IMSE-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3851IMSE-1#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3851IUD#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。