參數資料
型號： LTC3851IGN#TRPBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： 0.05 A SWITCHING CONTROLLER, 790 kHz SWITCHING FREQ-MAX, PDSO16
封裝： 0.150 INCH, LEAD FREE, PLASTIC, SSOP-16
文件頁數： 10/28頁
文件大?。?/td> 325K
代理商： LTC3851IGN#TRPBF
LTC3851
18
3851fb
APPLICATIONS INFORMATION
The required ESR due to a load current step is:
R
ESR ≤
ΔV
ΔI
where ΔI is the change in current from full load to zero load
(or minimum load) and ΔV is the allowed voltage deviation
(not including any droop due to nite capacitance).
The amount of capacitance needed is determined by the
maximum energy stored in the inductor. The capacitance
must be sufcient to absorb the change in inductor
current when a high current to low current transition
occurs. The opposite load current transition is generally
determined by the control loop OPTI-LOOP components,
so make sure not to over compensate and slow down
the response. The minimum capacitance to assure the
inductors’ energy is adequately absorbed is:
C
OUT >
L ΔI
()2
2 ΔV
()V
OUT
where ΔI is the change in load current.
Manufacturers such as Nichicon, United Chemi-Con and
Sanyo can be considered for high performance through-
hole capacitors. The OS-CON semiconductor electrolyte
capacitor available from Sanyo has the lowest (ESR)(size)
product of any aluminum electrolytic at a somewhat
higher price. An additional ceramic capacitor in parallel
with OS-CON capacitors is recommended to reduce the
inductance effects.
In surface mount applications, ESR, RMS current handling
and load step specications may require multiple capacitors
in parallel. Aluminum electrolytic, dry tantalum and
special polymer capacitors are available in surface mount
packages. Special polymer surface mount capacitors offer
very low ESR but have much lower capacitive density per
unit volume than other capacitor types. These capacitors
offer a very cost-effective output capacitor solution and are
an ideal choice when combined with a controller having
high loop bandwidth. Tantalum capacitors offer the highest
capacitance density and are often used as output capacitors
for switching regulators having controlled soft-start.
Several excellent surge-tested choices are the AVX TPS,
AVX TPSV or the KEMET T510 series of surface mount
tantalums, available in case heights ranging from 1.5mm
to 4.1mm. Aluminum electrolytic capacitors can be used
in cost-driven applications, provided that consideration
is given to ripple current ratings, temperature and long-
term reliability. A typical application will require several
to many aluminum electrolytic capacitors in parallel. A
combination of the above mentioned capacitors will often
result in maximizing performance and minimizing overall
cost. Other capacitor types include Nichicon PL series, NEC
Neocap, Panasonic SP and Sprague 595D series. Consult
manufacturers for other specic recommendations.
Like all components, capacitors are not ideal. Each
capacitor has its own benets and limitations. Combina-
tions of different capacitor types have proven to be a very
cost effective solution. Remember also to include high
frequency decoupling capacitors. They should be placed
as close as possible to the power pins of the load. Any
inductance present in the circuit board traces negates
their usefulness.
Setting Output Voltage
The LTC3851 output voltage is set by an external feedback
resistive divider carefully placed across the output,
as shown in Figure 6. The regulated output voltage is
determined by:
V
OUT = 0.8V 1+
R
B
R
A
To improve the transient response, a feed-forward ca-
pacitor, CFF, may be used. Great care should be taken to
route the VFB line away from noise sources, such as the
inductor or the SW line.
LTC3851
VFB
VOUT
RB
CFF
RA
3851 F06
Figure 6. Settling Output Voltage
相關PDF資料
PDF描述
LTC3851EUD#TRPBF 0.05 A SWITCHING CONTROLLER, 790 kHz SWITCHING FREQ-MAX, PQCC16
LTC3858EUH-2#PBF DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC32
LTC3865EUH-1#TRPBF DUAL SWITCHING CONTROLLER, 880 kHz SWITCHING FREQ-MAX, PQCC32
LTC3865EFE#PBF DUAL SWITCHING CONTROLLER, 880 kHz SWITCHING FREQ-MAX, PDSO38
LTC3865IFE#TRPBF DUAL SWITCHING CONTROLLER, 880 kHz SWITCHING FREQ-MAX, PDSO38
相關代理商/技術參數
參數描述
LTC3851IMSE#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3851IMSE#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3851IMSE-1#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3851IMSE-1#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3851IUD#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*