- 您現在的位置：買賣IC網 > PDF目錄44990 > LTC3226EUD#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHED CAPACITOR REGULATOR, PQCC16 PDF資料下載
參數資料
| 型號： | LTC3226EUD#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHED CAPACITOR REGULATOR, PQCC16 |
| 封裝： | 3 X 3 MM, LEAD FREE, PLASTIC, MO-220WEED-2, QFN-16 |
| 文件頁數： | 2/16頁 |
| 文件大?。?/td> | 431K |
| 代理商： | LTC3226EUD#TRPBF |
LTC3226
10
3226f
OPERATION
CAPGOOD Status Output
The LTC3226 charge pump includes a comparator to re-
port the status of the supercapacitors via an open-drain
NMOS transistor on the CAPGOOD pin. This pin is pulled
to ground until the CPO pin voltage rises to within 7.5%
of the programmed value. Once the CPO pin is above this
threshold, the CAPGOOD pin goes high impedance.
PROG Pin Short-Circuit Protection
Typically the maximum current that the LTC3226 charge
pump can deliver is set by the PROG resistor. However, if
for any reason, the PROG pin gets shorted to GND, or the
user chooses a PROG resistor value which is far smaller
than recommended, the charge pump input current is
limited to an internally set value of approximately 600mA.
Also the maximum current that can be sourced from the
PROGpinislimitedbyaninternalresistortolessthan1mA.
LOW DROPOUT REGULATOR (LDO)
Another principal circuit component of the LTC3226 is the
low dropout regulator (LDO) which transfers power from
the supercapacitor stack to VOUT through a pass element
with an RDS(ON) of approximately 200mΩ. This LDO has
a current limit internally set to 4A. In the event that the
input supply voltage falls below the PFI threshold, the PFI
comparator promptly turns on the LDO to supply the nec-
essary load without letting the VOUT rail droop too much.
However, to prevent unrestricted current flow from the
input to the supercapacitors through the ideal diode, the
LDO is turned off until the CPO voltage is greater than VIN
by 100mV typical. The LDO output voltage is programmed
through an external resistor divider via the LDO_FB pin.
POWER-FAIL (PFI) COMPARATOR
The LTC3226 contains a fast comparator which switches
the part from normal to backup mode in the event the
input voltage, VIN, falls below an externally programmed
threshold voltage. In backup mode, the charge pump
shuts off and the LDO powers the load as long as there
is enough charge stored on the supercapacitors. The PFI
threshold voltage is programmed by an external resistor
divider via the PFI pin. The output of the PFI comparator
also drives the gate of an open-drain NMOS to report the
status via the PFO pin. In normal mode, the PFO pin is
high Impedance but in backup mode, the pin is pulled
down to ground.
IDEAL DIODE CONTROLLER
The LTC3226 contains an ideal diode controller which
controls the gate of an external PFET connected between
the input, VIN, and the output, VOUT, through the GATE
pin. Under normal operating conditions, this external FET
constitutes the main power path from input to output. For
very light loads, the controller maintains a 15mV delta
across the FET between the input and output voltage. In
the event VIN suddenly drops below VOUT, the controller
quickly turns the FET completely off to prevent any reverse
conduction from VOUT back to the input supply.
RESET COMPARATOR
The LTC3226 contains a RESET comparator which moni-
tors VOUT under all operating modes via the RST_FB pin
and reports the status via an open-drain NMOS transis-
tor on the RST pin. At any time, if VOUT falls 7.5% from
its programmed value, it pulls the RST pin low almost
instantaneously.However,ontherisingedgethecompara-
tor waits 290ms after VOUT crosses the threshold before
making the RST pin high impedance.
GLOBAL THERMAL SHUTDOWN
The LTC3226 includes a global thermal shutdown which
shuts down the entire part in the event the die temperature
exceeds 152°C. It resumes normal operation once the
temperaturedropsbyabout15°Ctoapproximately137°C.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3226IUD#PBF | SWITCHED CAPACITOR REGULATOR, PQCC16 |
| LTC3400BES6#PBF | 0.85 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3404MPMS8#PBF | 1.5 A SWITCHING REGULATOR, 1650 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3404IMS8#PBF | 1.5 A SWITCHING REGULATOR, 1650 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3404MPMS8#TRPBF | 1.5 A SWITCHING REGULATOR, 1650 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3226IUD | 制造商:LINEAR 制造商全稱:LINEAR 功能描述:2-Cell Supercapacitor Charger with Backup PowerPath Controller |
| LTC3226IUD#PBF | 功能描述:IC 2CELL SUPERCAP CHARGE 16QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:PowerPath™ 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3226IUD#TRPBF | 功能描述:IC 2CELL SUPERCAP CHARGE 16QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:PowerPath™ 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3230 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:5-LED Main/Sub Display Driver with Dual LDO |
| LTC3230EUD#PBF | 功能描述:IC LED DRIVR WHITE BCKLGT 20-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - LED 驅動器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 恒定電流:- 恒定電壓:- 拓?fù)?升壓（升壓），切換式電容器（充電泵） 輸出數:1 內部驅動器:是 類型 - 主要:背光 類型 - 次要:白色 LED 頻率:625kHz ~ 875kHz 電源電壓:2.7 V ~ 5.3 V 輸出電壓:5V 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-µMAX 包裝:帶卷 (TR) 工作溫度:-40°C ~ 85°C |
發布緊急采購，3分鐘左右您將得到回復。