- 您現在的位置：買賣IC網 > PDF目錄2083 > LTC2308IUF#TRPBF (Linear Technology)IC ADC 12BIT 500KSPS 24-QFN PDF資料下載
參數資料
| 型號： | LTC2308IUF#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 3/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 12BIT 500KSPS 24-QFN |
| 標準包裝： | 2,500 |
| 位數： | 12 |
| 采樣率（每秒）： | 500k |
| 數據接口： | MICROWIRE?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 17.5mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 24-QFN 裸露焊盤（4x4） |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 8 個單端，單極；8 個單端，雙極；4 個差分，單極；4 個差分，雙極 |
| 配用： | DC1186A-ND - BOARD SAR ADC LTC2308 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
LTC2308
11
2308fb
Figure 2. Driving COM in UNIPOLAR and BIPOLAR Modes
COM
REFCOMP/2
COM
Unipolar Mode
Bipolar Mode
2308 F02
+
–
Figure 1a. Example MUX Congurations
Figure 1b. Changing the MUX Assignment “On the Fly”
CH0
CH1
CH2
CH3
CH4
CH5
CH6
CH7
COM (
–)
8 Single-Ended
+
4 Differential
+ (–)
+
+ (–)
– (+)
COM (
–)
Combinations of Differential
and Single-Ended
+
–
{
2308 F01a
CH0
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH0
CH1
CH2
CH3
CH4
CH5
CH6
CH7
COM
(UNUSED)
COM (
–)
1st Conversion
2nd Conversion
+
–
+
–
+
–
+
{
CH2
CH3
CH4
CH5
CH2
CH3
CH4
CH5
2308 F01b
Driving the Analog Inputs
The analog inputs of the LTC2308 are easy to drive. Each
of the analog inputs can be used as a single-ended input
relative to the COM pin (CH0-COM, CH1-COM, etc.) or in
differential input pairs (CH0 and CH1, CH2 and CH3, CH4
and CH5, CH6 and CH7). Figure 2 shows how to drive COM
for single-ended inputs in unipolar and bipolar modes.
Regardless of the MUX conguration, the “+” and “–”
inputs are sampled at the same instant. Any unwanted
signal that is common to both inputs will be reduced by
the common mode rejection of the sample-and-hold circuit.
The inputs draw only one small current spike while charg-
ing the sample-and-hold capacitors during the acquire
APPLICATIONS INFORMATION
mode. In conversion mode, the analog inputs draw only
a small leakage current. If the source impedance of the
driving circuit is low, the ADC inputs can be driven directly.
Otherwise, more acquisition time should be allowed for a
source with higher impedance.
Input Filtering
The noise and distortion of the input amplier and other
circuitry must be considered since they will add to the
ADC noise and distortion. Therefore, noisy input circuitry
should be ltered prior to the analog inputs to minimize
noise. A simple 1-pole RC lter is sufcient for many
applications.
The analog inputs of the LTC2308 can be modeled as
a 55pF capacitor (CIN) in series with a 100Ω resistor
(RON) as shown in Figure 3a. CIN gets switched to the
selected input once during each conversion. Large lter
RC time constants will slow the settling of the inputs. It
is important that the overall RC time constants be short
enough to allow the analog inputs to completely settle to
12-bit resolution within the acquisition time (tACQ) if DC
accuracy is important.
When using a lter with a large CFILTER value (e.g. 1μF),
the inputs do not completely settle and the capacitive input
switching currents are averaged into a net DC current
(IDC). In this case, the analog input can be modeled by an
equivalent resistance (REQ = 1/(fSMPL CIN)) in series with
an ideal voltage source (VREFCOMP/2)asshowninFigure 3b.
The magnitude of the DC current is then approximately
IDC = (VIN – VREFCOMP/2)/REQ, which is roughly propor-
tional to VIN. To prevent large DC drops across the resistor
RFILTER, a lter with a small resistor and large capacitor
should be chosen. When running at the minimum cycle
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2309IUF#TRPBF | IC ADC 12BIT SAR 24-QFN |
| LTC2362HTS8#TRPBF | IC ADC 12BIT 500KSPS TSOT23-8 |
| LTC2364HMS-18#PBF | IC ADC 18BIT 250K 1CH 16MSOP |
| LTC2367HMS-18#PBF | IC ADC 18BIT 500K 1CH 16MSOP |
| LTC2368HMS-18#PBF | IC ADC 18BIT 1M 1CH 16MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2309CF#PBF | 功能描述:IC ADC 12BIT SAR 20-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2309CF#TRPBF | 功能描述:IC ADC 12BIT SAR 20-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2309CFPBF | 制造商:Linear Technology 功能描述:ADC 12-Bit 8-Channel 14ksps I2C TSSOP20 |
| LTC2309CUF#PBF | 功能描述:IC ADC 12BIT SAR 24-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2309CUF#PBF | 制造商:Linear Technology 功能描述:A/D Converter (A-D) IC |
發布緊急采購，3分鐘左右您將得到回復。