- 您現在的位置：買賣IC網 > PDF目錄44981 > LT1680ISW#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | LT1680ISW#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 0.300 INCH, PLASTIC, SOP-16 |
| 文件頁數： | 2/16頁 |
| 文件大小： | 217K |
| 代理商： | LT1680ISW#TRPBF |
10
LT1680
capacitor CSS, the start up delay time to full available
average current will be:
tSS = (1.5)(105)(CSS)
Shutdown Function—Input Undervoltage Detect
and Threshold Hysteresis
The LT1680 RUN/SHDN pin uses a bandgap generated
reference threshold of about 1.25V. This precision thresh-
old allows use of the RUN/SHDN pin for both logic-level
shutdown applications and analog monitoring applica-
tions such as power supply sequencing.
Because an LT1680 controlled converter is a power trans-
fer device, a voltage that is lower than expected on the
input supply could require currents that exceed the sourc-
ing capabilities of that supply, causing the system to lock-
up in an undervoltage state. Input supply start-up protection
can be achieved by enabling the RUN/SHDN pin using a
resistor divider from the input supply to ground. Setting
the divider output to 1.25V when the supply is almost fully
enabled prevents the LT1680 regulator from drawing large
currents until the input supply is able to supply the
required power.
If additional hysteresis is desired for the enable function,
an external feedback resistor can be used from the LT1680
regulator output. If connection to the regulator output is
not desired, the 5VREF internal supply pin can be used.
Figure 3 shows an input supply sequencing configuration
on a 24V input converter. This configuration yields an
enable condition of 90% VIN (~ 21.5V) with about 10%
threshold hysteresis.
The shutdown function can be disabled by connecting the
RUN/SHDN pin to the 12VIN rail. This pin is internally
Figure 3. Input Supply Sequencing Programming
TIMING RESISTOR (k
)
3
7 11 15 19 23 27 31 35 39 43 47
OSCILLATOR
FREQUENCY
(kHz)
200
180
160
140
120
100
80
60
40
1680 F02
CCT = 0.68nF
CCT = 1nF
CCT = 2.2nF
CCT = 1.5nF
Figure 2. Operating Frequency vs RCT, CCT
Average Current Limit
The average current limit function is implemented using
an external capacitor (CAVG) connected either from the
IAVG pin to the VC pin or from the IAVG pin to SGND. This
capacitor forms a single-pole integrator with the 50k
output impedance of the IAVG pin. Precise integration
frequencies can be determined using a ground reference
integration capacitor using the relation:
f–3dB = (3.2)(10–6)/CAVG
Connecting a capacitor from the IAVG pin to the VC pin uses
an internal gain block to form an active integrator circuit,
minimizing the required capacitance for stable operation.
A typical value for this integration capacitor is 220pF from
IAVG to VC.
Shorting the IAVG pin to SGND will disable the average
current limit function.
Soft Start Programming
The current control pin (VC) limits sensed inductor current
to zero at voltages less than a transistor VBE, to full average
current limit at VC = VBE + 1.8V. This generates a 1.8V full
regulation range for average load current. An internal
voltage clamp forces the VC pin to a VBE – 100mV above
the SS pin voltage. This 100mV “dead zone” assures 0%
duty cycle operation at the start of the soft start cycle or
when the soft start pin is pulled to ground. Given the
typical soft start current of 8
A and a soft start timing
VIN
24V
16
11
160k
390k
10k
1680 F03
5VREF
RUN/SHDN
LT1680
APPLICATIO S I FOR ATIO
WU
UU
相關PDF資料 |
PDF描述 |
|---|---|
| LT1702-7FB1 | 1-OUTPUT 500 W AC-DC REG PWR SUPPLY MODULE |
| LT1740-7DF | 1-OUTPUT 550 W AC-DC REG PWR SUPPLY MODULE |
| LT1740-7 | 1-OUTPUT 550 W AC-DC REG PWR SUPPLY MODULE |
| LT1840-7DZF | 1-OUTPUT 450 W AC-DC REG PWR SUPPLY MODULE |
| LT1240-7DZF | 1-OUTPUT 400 W AC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1681 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Transistor Synchronous Forward Controller |
| LT1681ESW | 功能描述:IC SYNCHRONOUS FWRD CTRLR 20SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LT1681ESW#PBF | 功能描述:IC SYNCHRONOUS FWRD CTRLR 20SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LT1681ESW#TR | 功能描述:IC SYNCHRONOUS FWRD CTRLR 20SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LT1681ESW#TRPBF | 功能描述:IC SYNCHRONOUS FWRD CTRLR 20SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。