- 您現在的位置：買賣IC網 > PDF目錄30763 > LSM2-T/6-W3-C 1-OUTPUT 19.8 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | LSM2-T/6-W3-C |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 19.8 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | ROHS COMPLIANT |
| 文件頁數： | 6/17頁 |
| 文件大?。?/td> | 1394K |
| 代理商： | LSM2-T/6-W3-C |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁
LSM2 Series
Single Output, Non-isolated, Selectable-Output POL DC/DC Converters
MDC_LSM2_A01 Page 4 of 7
P O W E R E L E C T R O N I C S D I V I S I O N
D C / D C C O N V E R T E R S
www.cd4power.com
Figure 14. Wiring for Simultaneous Phasing
Figure 15. Self-Ramping Power Up
Figure 16. Proportional Phasing
Figure 17. Sequence/Track Simplified Equivalent Schematic
Figure 4 shows a basic Master (POL A) and Slave (POL B) connected so the
POL B ramps up identically to POL A as shown in timing diagram, Figure 0.
RC network R and C charge up at a rate set by the R-C time constant,
giving a roughly linear ramp. As POL A reaches 3.3VOUT (the setpoint of POL
B), POL B will stop rising. POL A then continues rising until it reaches 5V. R
should be significantly smaller than the internal bias current resistor from the
Sequence pin. Start with a 20k
W value. We assume that the critical phase is
only on power up therefore there is no provision for ramped power down.
Figure 5 shows a single POL and the same RC network. However, we have
added a FET at Q as an up/down control. When VIN power is applied to the
POL, Q is biased on, shorting out the Sequence pin. When Q’s gate is biased
off, R charges C and the POL’s output ramps up at the R-C slew rate.
Note: Q’s gate would typically be controlled from some external digital logic.
Guidelines for Sequence/Track Applications
[] Leave the converter’s On/Off Enable control (if installed) in the On setting.
Normally, you should just leave the On/Off pin open.
[2] Allow the converter to stabilize (typically less than 20 mS after +VIN
power on) before raising the Sequence input. Also, if you wish to have a
ramped power down, leave +VIN powered all during the down ramp. Do
not simply shut off power.
[3] If you do not use the Sequence/Track pin, leave it open or tied to +VIN.
[4] Observe the Output slew rate relative to the Sequence input. A rough
guide is 2 Volts per millisecond maximum slew rate. If you exceed this
slew rate on the Sequence pin, the converter will simply ramp up at
it’s maximum output slew rate (and will not necessarily track the faster
Sequence input). The reason to carefully consider the slew rate limitation
is in case you want two different POL’s to precisely track each other.
If you wish to have a ramped power down (rather than a step down), add a
small resistor in series with Q’s drain.
Figure 6 shows both a RC ramp on Master POL A and a proportional tracking
divider (R2 and R3) on POL B. We have also added an optional very small
noise filter cap at C2. Figure 6’s circuit corresponds roughly to Figure ’s
timing for power up.
相關PDF資料 |
PDF描述 |
|---|---|
| LSM2-T/6-W3G-C | 1-OUTPUT 19.8 W DC-DC REG PWR SUPPLY MODULE |
| LSM2-T/6-D12-C | 1-OUTPUT 19.8 W DC-DC REG PWR SUPPLY MODULE |
| LSM2-T/6-D12G-C | 1-OUTPUT 19.8 W DC-DC REG PWR SUPPLY MODULE |
| LSN-1.2/16-W3J | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| LSN-1.5/16-W3J | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LSM2U | 功能描述:限位開關 LIMIT SWITCH RoHS:否 制造商:Honeywell 觸點形式:SPDT 執行器:Non-Contact 電流額定值:30 mA 電壓額定值 AC: 電壓額定值 DC:3.6 V 工作力:10 g IP 等級:IP 67 NEMA 額定值:1, 4, 12, 13 端接類型:4-Pin M12 Connector 安裝:SMD/SMT |
| LSM-3.3/10-D12 | 功能描述:DC/DC轉換器 33W 12V to 3.3V 10A SMT Package RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| LSM-3.3/10-D12-C | 功能描述:DC/DC轉換器 33W 12V to 3.3V 10A RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| LSM-3.3/10-D12EB | 制造商:MURATA 制造商全稱:Murata Manufacturing Co., Ltd. 功能描述:10 Amp DC/DC Power Converter Evaluation Boards |
| LSM-3.3/10-D5 | 功能描述:DC/DC轉換器 33W 5V to 3.3V 10A SMT Package RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發布緊急采購，3分鐘左右您將得到回復。
