- 您現在的位置：買賣IC網 > PDF目錄369842 > LSIFC929 LSIFC929 dual channel fibre solutions PDF資料下載
參數資料
| 型號： | LSIFC929 |
| 英文描述： | LSIFC929 dual channel fibre solutions |
| 中文描述： | LSIFC929雙通道光纖解決方案 |
| 文件頁數： | 51/144頁 |
| 文件大?。?/td> | 1496K |
| 代理商： | LSIFC929 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁當前第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁
4-11
TESTRESET/
B13
I
N/A
Test Reset.
Forces chip into Power-On-Reset state or
Soft-Reset state, depending on the state of the Mode pins.
This pad contains an internal 100
μ
A pull-up.
ARMEN/
C14
I
N/A
ARM Enable.
When this pin is asserted LOW, the ARM
RISC processor core (IOP) is enabled and will boot from
Flash ROM following chip reset. If this configuration pin is
held HIGH, the IOP core will be held reset until the
DisARM bit in the Diagnostic register is cleared by the
host CPU. This pad contains an internal 100
μ
A pull-up.
FSELZ
B6
I
N/A
Frequency Select.
This pin when HIGH indicates that the
REFCLK input shall be internally divided by 2 to generate
the internal ZCLK source (106.25 / 2 = 53.125 MHz).
When this pin is LOW, the internal ZCLK tree is sourced
directly from the ZCLK input signal. This pad contains an
internal 100
μ
A pull-up.
MODE[7:0]
D8,
A9,
B9,
C9,
D9,
A10,
B10,
C10
I
N/A
Mode Select.
This 8-bit bus defines operational and test
modes for the chip. For Normal Mode, MODE7 and
MODE6 should be tied LOW. The Mode encodings are
given below:
Normal Mode
Mode[7:0] = 0011xxxx==Interleaved BSRAM
Mode[7:0] = 0001xxxx==Noninterleaved BSRAM
Mode[7:0] = 00x11xxx==GBIC (Fault is active HIGH)
Mode[7:0] = 00x10xxx==MIA (Fault is active LOW)
Mode[7:0] = 00x1x1xx==Soft Reset Mode
Mode[7:0] = 00x1xx11==Normal SEPROM Auto Load
Mode[7:0] = 00x1xx01==Firmware PCI Config Mode
(ARMEN/ must also be LOW)
Mode[7:0] = 00x1xx00 ==PCI Config use default values
All other combinations are reserved.
Each of these pads contains an internal 100
μ
A pull-up.
Table 4.5
Configuration Signals (Cont.)
Name
BGA
Pos
Type
Strength
Description
相關PDF資料 |
PDF描述 |
|---|---|
| LSIFC929X | LSIFC929X dual channel fibre solutions |
| LSIU160 | LSIU160 Ultra160 SCSI host adapter |
| LSIU40HVD | LSIU40HVD PCI to Dual Channel SCSI host adapter user＇s guide v2.2 8/02 |
| LSIU40SE | LSIU40SE Dual Channel PCI to Ultra SCSI host adapter user＇s guide v2.2 8/02 |
| LSIU80LVD | LSIU80LVD Ultra2 LVD SCSI host adapter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LSIFC929-329BGA | 制造商:LSI Corporation 功能描述:Fiber Controller 456-Pin BGA |
| LSIFC929X | 制造商:LSI Corporation 功能描述:- Bulk |
| LSIFC929XL | 制造商:LSI Corporation 功能描述:2GB PCI-X TO DUAL CHANNEL - Bulk |
| LSIFC949X | 制造商:LSI Corporation 功能描述:PCI-X TO DUAL CHANNEL - Bulk |
| LSIFC949X A0 | 制造商:LSI 功能描述: 制造商:LSI Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。