參數資料
型號: LPC2290FBD144
廠商: NXP Semiconductors N.V.
元件分類: 數學處理器
英文描述: 16-32-bit ARM microcontroller with CAN, 10-bit ADC and external memory interface
封裝: LPC2290FBD144/01<SOT486-1 (LQFP144)|<<http://www.nxp.com/packages/SOT486-1.html<1<Always Pb-free,;
文件頁數: 18/41頁
文件大?。?/td> 198K
代理商: LPC2290FBD144
LPC2290_3
NXP B.V. 2006. All rights reserved.
Product data sheet
Rev. 03 — 16 November 2006
18 of 41
NXP Semiconductors
LPC2290
16/32-bit ARM microcontroller with external memory interface
All I/O default to inputs after reset.
6.7.2
Fast I/O features available in LPC2290/01 only
Fast I/O registers are located on the ARM local bus for the fastest possible I/O timing.
All GPIO registers are byte addressable.
Entire port value can be written in one instruction.
Mask registers allow single instruction to set or clear any number of bits in one port.
6.8 10-bit ADC
The LPC2290 each contain a single 10-bit successive approximation ADC with eight
multiplexed channels.
6.8.1
Features
Measurement range of 0 V to 3.3 V.
Capable of performing more than 400000 10-bit samples per second.
Burst conversion mode for single or multiple inputs.
Optional conversion on transition on input pin or Timer Match signal.
6.8.2
ADC features available in LPC2290/01 only
Every analog input has a dedicated result register to reduce interrupt overhead.
Every analog input can generate an interrupt once the conversion is completed.
6.9 CAN controllers and acceptance filter
The LPC2290 contains two CAN controllers. The CAN is a serial communications protocol
which efficiently supports distributed real-time control with a very high level of security. Its
domain of application ranges from high-speed networks to low cost multiplex wiring.
6.9.1
Features
Data rates up to 1 Mbit/s on each bus.
32-bit register and RAM access.
Compatible with CAN specification 2.0B, ISO 11898-1.
Global Acceptance Filter recognizes 11-bit and 29-bit RX identifiers for all CAN buses.
Acceptance Filter can provide FullCAN-style automatic reception for selected
Standard identifiers.
Full CAN messages can generate interrupts.
6.10 UARTs
The LPC2290 contains two UARTs. In addition to standard transmit and receive data
lines, UART1 also provides a full modem control handshake interface.
6.10.1
Features
16 B Receive and Transmit FIFOs.
相關PDF資料
PDF描述
LPC2292FBD144 16-32-bit ARM microcontrollers; 256 kB ISP-IAP flash with CAN, 10-bit ADC and external memory interface
LPC2292FET144 16-32-bit ARM microcontrollers; 256 kB ISP-IAP flash with CAN, 10-bit ADC and external memory interface
LPC2294HBD144 16-32-bit ARM microcontrollers; 256 kB ISP-IAP flash with CAN, 10-bit ADC and external memory interface
LPC2361FBD100 Single-chip 16-bit-32-bit MCU; up to 128 kB flash with ISP-IAP, Ethernet, USB 2.0 device-host-OTG, CAN, and 10-bit ADC-DAC
LPC2362FBD100 Single-chip 16-bit-32-bit MCU; up to 128 kB flash with ISP-IAP, Ethernet, USB 2.0 device-host-OTG, CAN, and 10-bit ADC-DAC
相關代理商/技術參數
參數描述
LPC2290FBD144,551 功能描述:ARM微控制器 - MCU RLESS/16K RM/2 CAN/ADC/EXT BUS RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
LPC2290FBD144/01 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16/32-bit ARM microcontroller with CAN, 10-bit ADC and external memory interface
LPC2290FBD144/01,5 功能描述:ARM微控制器 - MCU ARM7 16KR/2CAN/ADC ROMLESS RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
LPC2290FBD144551 制造商:NXP Semiconductors 功能描述:IC 16/32BIT MCU ARM7 SMD LPC2290
LPC2292 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16/32-bit ARM microcontrollers; 256 kB ISP/IAP flash with CAN, 10-bit ADC and external memory interface