- 您現在的位置：買賣IC網 > PDF目錄385493 > LP3936SLX (NATIONAL SEMICONDUCTOR CORP) Lighting Management System for Six White LEDs and One RGB or FLASH LED PDF資料下載
參數資料
| 型號： | LP3936SLX |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 顯示驅動器 |
| 英文描述： | Lighting Management System for Six White LEDs and One RGB or FLASH LED |
| 中文描述： | LED DISPLAY DRIVER, QCC32 |
| 封裝： | 4.5 X 5.5 MM, 0.80 MM HEIGHT, 0.50 PITCH, CSP-32 |
| 文件頁數： | 15/20頁 |
| 文件大?。?/td> | 520K |
| 代理商： | LP3936SLX |
Boost Converter Typical Performance Characteristics
V
IN
= 3.6V, V
OUT
= 4.55V if not
otherwise stated. (Continued)
Boost Line Regulation
Boost Load Regulation, 50 mA–100 mA
20081425
20081426
RGB LED Driver
The RGB driver has three outputs that can independently
drive one RGB LED or three LEDs of any kind. User has
control over the following parameters separately for each
LED:
ON and OFF
(start and stop time in blinking cycle)
DUTY
SLOPE
ENABLE
The main blinking cycle is controlled with 2-bit CYCLE con-
trol (0.25 / 0.5 / 1.0 / 2.0s).
(PWM brightness control)
(dimming slope)
(direct enable control)
20081427
RGB PWM Operating Principle
RGB_START is the master enable control for the whole RGB
function. The internal PWM and blinking control can be
disabled by setting the RGB_PWM control LOW. In this case
the individual enable controls can be used to switch outputs
on and off. RGB_EN input can be used for external hardware
PWM control. RGB_EN input can be used as direct on/off or
brightness (PWM) control. If RGB_EN input is not used, it
must be tied to V
DD_IO
. Recommended maximum frequency
of RGB LED external PWM control is 1 MHz.
In the normal PWM mode the R, G and B switches are
controlled in 3 phases (one phase per driver). During each
phase the peak current set by external resistor is driven
through the LED for the time defined by DUTY setting
(0 μs–50 μs). As a time averaged current this means
0%–33% of the peak current. The PWM period is 150 μs and
the pulse frequency is 6.67 kHz in normal mode.
20081428
Normal Mode PWM Waveforms at different duty
settings
L
www.national.com
15
相關PDF資料 |
PDF描述 |
|---|---|
| LP3939 | Power Amplifier Driver For Dual Band CDMA Handsets |
| LP3939ILQ | Power Amplifier Driver For Dual Band CDMA Handsets |
| LP3939ILQX | Power Amplifier Driver For Dual Band CDMA Handsets |
| LP3943 | RGB/White/Blue 16-LED Fun Light Driver |
| LP3943ISQ | RGB/White/Blue 16-LED Fun Light Driver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LP3936SLX/NOPB | 功能描述:LED照明驅動器 RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| LP3937ILQ-AL | 制造商:Texas Instruments 功能描述:Electronic Component |
| LP3939 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Power Amplifier Driver For Dual Band CDMA Handsets |
| LP3939-ES1 | 制造商:Texas Instruments 功能描述:TELECOM, CELLULAR, RF AND BASEBAND CIRCUIT, PQCC16 |
| LP3939ILQ | 制造商:Texas Instruments 功能描述:TELECOM, CELLULAR, RF AND BASEBAND CIRCUIT, PQCC16 |
發布緊急采購，3分鐘左右您將得到回復。