參數資料
型號： LM1247
廠商： National Semiconductor Corporation
英文描述： 150 MHz I2C Compatible RGB Preamplifier with Internal 512 Character OSD ROM, 512 Character RAM and 4 DACs
中文描述： 150 MHz的I2C兼容的RGB前置放大器512個字符OSD光盤，512個字符RAM和4 DAC的內置
文件頁數： 15/48頁
文件大?。?/td> 3141K
代理商： LM1247
OSD Generator Operation
PAGE OPERATION
Figure 12
shows the block diagram of the OSD generator.
OSD screens are created using any of the 512 predefined
characters stored in the mask programmed ROM. The OSD
image is composed of up to 512 characters stored in page
RAM, where each character has a unique 8-bit address. This
means only half of the 512 ROM characters can be dis-
played at any one time. Since a 9 bit address is needed to
select from 512 ROM addresses, a bank select register is
used to convert the upper 2 bits of the character code into a
3 bit bank address which is combined with the other 6 bits to
produce the necessary 9 bits.Also, since the lower 6 bits can
address 64 characters, this gives a bank size of 64. There-
fore, the ROM consists of 8 banks of 64 characters each,
where 4 of these 8 banks are displayed by loading the 4
bank address registers with the appropriate 3 bit code. This
allows the programmer to switch between two different OSD
images, by simply reprogramming the bank addresses.
OSD ROM CONFIGURATION
The OSD ROM is equivalent to two 256 character ROMs of
the type used in the LM1253A and LM1237. Because of the
bank select method described earlier, each can be consid-
ered as a group of 3 banks (192) two-color characters fol-
lowed by 1 bank (64) four-color characters. Physically, the
combined ROM is then 192x2 + 64x4 + 192x2 + 64x4. This
is shown in
Figure 12
.
BANK ADDRESSING
A pictorial view of this addressing method is shown in
Figure
13
. On the left side is a section of the Page RAM with four
different addresses in successive locations, which have
been chosen to demonstrate accessing 4 of the 8 ROM
banks using the Bank Select Registers. The first has 10b for
the two most significant bits, so the OSD generator looks in
B2AD[2:0], located in Bank Select Register B, for its ROM
bank address. SInce B2AD[2:0] contains 101b, the character
font is read from Bank 5. The complete font address is
composed of this bank address, plus the lower six bits of the
original byte in Page RAM, giving a ROM address of
101101110b. The remaining addresses demonstrate that the
four selected banks can be displayed in any order.
END-OF-LINE AND END-OF-SCREEN CODES
There are two special character addresses used in the page
RAM, 0x00 (End-of-Screen) and 0x01 (End-of-Line). The
first must be used to terminate a window and the second to
terminate a line. The LM1247 is different from the LM1253A
and LM1237 in that these are now not actually encoded into
ROM, but are instead detected by the logic as the OSD
image is read from page RAM. This means that the two
lowest locations in the bank which is currently selected by
Bank Select Register 0, 0x8427[2:0], cannot be displayed in
an OSD image. However, these two characters can be
masked in the ROM, and if this bank is selected by Bank
Select Registers 1, 2 or 3, then these two characters are
usable on screen. The consequences of this is that only 254
ROM characters are displayable at one time.
DISPLAYING AN OSD IMAGE
Consecutive lines of characters make up the displayed win-
dow. These characters are stored in the page RAM through
the I
2
C compatible bus. Each line can contain any number of
characters up to the limit of the displayable line length (de-
pendent on the pixels per line register), although some re-
strictions concerning the enhanced features apply on char-
acter lines longer than 32 characters. The number of
characters across the width and height of the page can be
20048427
FIGURE 12. OSD Generator Block Diagram
L
www.national.com
15
相關PDF資料
PDF描述
LM1270 Hi-Brite 200 MHz I2C Compatible RGB Image Enhancer with Video Auto Sizing
LM1270N Hi-Brite 200 MHz I2C Compatible RGB Image Enhancer with Video Auto Sizing
LM1270NA Hi-Brite 200 MHz I2C Compatible RGB Image Enhancer with Video Auto Sizing
LM1279 110 MHz RGB Video Amplifier System with OSD
LM1279N 110 MHz RGB Video Amplifier System with OSD
相關代理商/技術參數
參數描述
LM1247AAG/NA 功能描述:IC PREAMP CMOS 150MHZ 24DIP RoHS:否 類別:集成電路 (IC) >> 線性 - 視頻處理 系列:- 產品變化通告:Product Discontinuation 07/Mar/2011 標準包裝:3,000 系列:OMNITUNE™ 類型:調諧器 應用:移動電話，手機，視頻顯示器 安裝類型:表面貼裝 封裝/外殼:65-WFBGA 供應商設備封裝:PG-WFSGA-65 包裝:帶卷 (TR) 其它名稱:SP000365064
LM1247DMC/NA 制造商:Texas Instruments 功能描述:
LM124A 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low Power Quad Operational Amplifiers
LM124AD 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:LOW POWER QUAD OPERATIONAL AMPLIFIERS
LM124ADR 制造商:TI 制造商全稱:Texas Instruments 功能描述:QUADRUPLE OPERATIONAL AMPLIFIERS
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*