參數資料
型號： L99H01XPTR
廠商： STMICROELECTRONICS
元件分類： 運動控制電子
英文描述： BRUSH DC MOTOR CONTROLLER, PDSO36
封裝： ROHS COMPLIANT, SSOP-36
文件頁數： 25/53頁
文件大小： 1129K
代理商： L99H01XPTR
L99H01
Doc ID 15567 Rev 3
3.12
Thermal sensor interface / H-bridge switch-off input
The TS/ACT_OFF pin is configurable by SPI with the EXT_TS bit. This pin could be used as
temperature sensor interface for the H-bridge or external off for all gate drivers. The output
bias current ITS_bias is on for EN = high.
3.12.1
EXT_TS-bit = low (active off)
The TS/ACT_OFF input is used as a logic driver control input, without filter delay and
without latching the information.
Pulling the TS/ACT_OFF pin below the programmed threshold all gate drivers are
switched-off and the OT_EXT bit is set.
Increasing the voltage at TS/ACT_OFF pin above the programmed threshold the device
remains to the status set by DIR and PWM-pins and the OT_EXT bit is reseted.
The threshold is programmable by SPI with the registers EXTTH_5:0.
3.12.2
EXT_TS-bit = high (thermal sensor interface)
With the thermal sensor interface external diodes can be used to control the temperature of
the external H-bridge. When the diode forward voltage decreases below the reference
voltage for longer than the internal filter time (64 s) the OT_EXT bit is set and the driver
switches in resistive low (see Section 3.4: Resistive low).
In this mode the OT_EXT-status-bit has to be cleared to reactivate the gate drivers.
The threshold is programmable by SPI with the registers EXTTH_5:0.
3.13
Watchdog
The tasks of the watchdog is to monitor the microcontroller during normal operation within a
nominal trigger cycle of 60 ms. The microcontroller has to restard the watchdog timer by
sending the watchdog restart bit via SPI repeatedly within the watchdog time TWDTO. If no
correct watchdog service is send from the microcontroller, all gate drivers switch in sink
condition and the watchdog time out bit (WDTO) is set. Once the watchdog times out, the
gate drivers can only be reactivated by sending a software reset.
相關PDF資料
PDF描述
L99PM62XP 4-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO36
LA5635H SPECIALTY ANALOG CIRCUIT, PDSO28
LA5693D 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDIP8
LA5693M 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO8
LA8638NV COMPANDER, PDSO30
相關代理商/技術參數
參數描述
L99LD01 制造商:STMicroelectronics 功能描述:
L99LD01TR-E 功能描述:LED 驅動器 IC 2 輸出 DC DC 控制器 回掃，降壓（降壓），升壓 PWM 調光 32-LQFP（7x7） 制造商:stmicroelectronics 系列:- 包裝:剪切帶（CT） 零件狀態:有效 類型:DC DC 控制器 拓?fù)?回掃，降壓（降壓），升壓 內部開關:無 輸出數:2 電壓 - 供電（最低）:5.6V 電壓 -?供電（最高）:24V 電壓 - 輸出:- 電流 - 輸出/通道:- 頻率:100kHz ~ 500kHz 調光:PWM 應用:汽車級 工作溫度:-40°C ~ 150°C（TJ） 安裝類型:表面貼裝 封裝/外殼:32-LQFP 供應商器件封裝:32-LQFP（7x7） 標準包裝:1
L99-M0014-1000-A 功能描述:MAGNETIC USB MAGNETIC USB 2.0 A 制造商:rosenberger north america 系列:- 零件狀態:在售 配置:A 公型至 Micro-B 公型 長度:3.28'（1.00m） 規格:USB 2.0 屏蔽:無屏蔽 樣式:加長電纜 標準包裝:100
L99-M0015-150-A 功能描述:MAGNETIC USB MAGNETIC USB 2.0 A 制造商:rosenberger north america 系列:- 零件狀態:在售 配置:A母頭至微型B公頭 長度:3.28'（1.00m） 規格:USB 2.0 屏蔽:無屏蔽 樣式:加長電纜 標準包裝:100
L99MC6 功能描述:馬達/運動/點火控制器和驅動器 6 CH DEVICE 0.6 A RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*