- 您現在的位置：買賣IC網 > PDF目錄43901 > L99H01XPTR (STMICROELECTRONICS) BRUSH DC MOTOR CONTROLLER, PDSO36 PDF資料下載
參數資料
| 型號： | L99H01XPTR |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 運動控制電子 |
| 英文描述： | BRUSH DC MOTOR CONTROLLER, PDSO36 |
| 封裝： | ROHS COMPLIANT, SSOP-36 |
| 文件頁數： | 24/53頁 |
| 文件大?。?/td> | 1129K |
| 代理商： | L99H01XPTR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁
L99H01
Doc ID 15567 Rev 3
3.8
Temperature warning and thermal shutdown
If junction temperature rises above TjTWON the temperature warning flag TW is set and is
detectable via the SPI. If junction temperature increases above the second threshold
TjSDON, the thermal shutdown bit (TSD) is set. The gate drivers and the charge pump are
switched-off to protect the device. The gates of the H-bridge are discharged by the resistive
low mode (see Section 3.4). In order to reactivate the output stages the junction
temperature must decrease below TjSDOFF and the thermal shutdown bit has to be cleared
by the microcontroller.
3.9
Short-circuit detection / drain source monitoring
The drain - source voltage of each activated external MOSFET of the H-bridge is monitored
by comparators to detect shorts to ground or battery. If the voltage drop over the external
MOSFET exceeds the threshold voltage VSCd for longer than the short current detection
time tSCd the corresponding gate driver switches the external MOSFET off and the
corresponding drain source monitoring flag (DS_MON [3:0]) is set. Until this failure flag is
reseted the corresponding half bridge is in sink condition. The DS_MON bits have to be
cleared through a software reset to reactivate the gate drivers. The drain source monitoring
has a filter time of 6 s. This monitoring is only active when the corresponding gate driver is
in source condition. The threshold voltage VSCd can be programmed in 4 steps between
0.5 V and 2 V with the SPI.
3.10
Programmable cross current protection
The external Power MOSFET’s transistors in H-bridge (two halfbridges) configuration are
switched-on with an additional delay time tCCP to prevent cross current in the halfbridge. The
cross current protection time tCCP can be programmed with the SPI.
3.11
Current sense amplifier (CSA)
The current sense amplifier (CSA) is specially designed for current shunt automotive
applications. It is a bidirectional, single-supply difference amplifier for amplifying small
differential voltages in a wide common mode voltage range (-4 V to (VCP - 8) V). It supports
the current measurement at two shunts. The result of respective shunt can be multiplexed to
the microcontroller compatible output voltage by a SPI command.
A gain of 50, 20 or 10 is SPI programmable. The inputs (CSI1+ / CSI1- and CSI2+ / CSI2-)
are build as a transconductance stage. Therefore a series resistor (for filtering etc.) should
not exceed 50
Ω to keep the additional gain error below 1%.
The output works at half scale: VCSO0 = (0,5 * VCC) V for VIDIFF = 0 V. An internal offset
measurement is in normal mode available with the "OFF_CAL" SPI-bit. If this bit is set to
logic "1" the input pins are disconnected from the amplifier and a virtual zero input
differential voltage is selected.
相關PDF資料 |
PDF描述 |
|---|---|
| L99PM62XP | 4-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO36 |
| LA5635H | SPECIALTY ANALOG CIRCUIT, PDSO28 |
| LA5693D | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDIP8 |
| LA5693M | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO8 |
| LA8638NV | COMPANDER, PDSO30 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L99LD01 | 制造商:STMicroelectronics 功能描述: |
| L99LD01TR-E | 功能描述:LED 驅動器 IC 2 輸出 DC DC 控制器 回掃，降壓（降壓），升壓 PWM 調光 32-LQFP（7x7） 制造商:stmicroelectronics 系列:- 包裝:剪切帶（CT） 零件狀態:有效 類型:DC DC 控制器 拓撲:回掃，降壓（降壓），升壓 內部開關:無 輸出數:2 電壓 - 供電（最低）:5.6V 電壓 -?供電（最高）:24V 電壓 - 輸出:- 電流 - 輸出/通道:- 頻率:100kHz ~ 500kHz 調光:PWM 應用:汽車級 工作溫度:-40°C ~ 150°C（TJ） 安裝類型:表面貼裝 封裝/外殼:32-LQFP 供應商器件封裝:32-LQFP（7x7） 標準包裝:1 |
| L99-M0014-1000-A | 功能描述:MAGNETIC USB MAGNETIC USB 2.0 A 制造商:rosenberger north america 系列:- 零件狀態:在售 配置:A 公型至 Micro-B 公型 長度:3.28'（1.00m） 規格:USB 2.0 屏蔽:無屏蔽 樣式:加長電纜 標準包裝:100 |
| L99-M0015-150-A | 功能描述:MAGNETIC USB MAGNETIC USB 2.0 A 制造商:rosenberger north america 系列:- 零件狀態:在售 配置:A母頭至微型B公頭 長度:3.28'（1.00m） 規格:USB 2.0 屏蔽:無屏蔽 樣式:加長電纜 標準包裝:100 |
| L99MC6 | 功能描述:馬達/運動/點火控制器和驅動器 6 CH DEVICE 0.6 A RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。