- 您現在的位置：買賣IC網 > PDF目錄384587 > L9214A (Lineage Power) Low-Cost Ringing SLIC(低價格振鈴用戶環路接口電路) PDF資料下載
參數資料
| 型號： | L9214A |
| 廠商： | Lineage Power |
| 英文描述： | Low-Cost Ringing SLIC(低價格振鈴用戶環路接口電路) |
| 中文描述： | 低成本振鈴用戶接口（低價格振鈴用戶環路接口電路） |
| 文件頁數： | 12/44頁 |
| 文件大小： | 964K |
| 代理商： | L9214A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁
Preliminary Data Sheet
October 2000
Low-Cost Ringing SLIC
L9214A/G
12
Lucent Technologies Inc.
State Definitions
Forward Active (Off-Hook)
I
Pin PT is positive with respect to PR.
I
V
BAT2
is applied to tip/ring drive amplifiers for the
from V
BAT1
through a power control resistor.
I
Loop closure and common-mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
Overhead is set for undistorted transmission of
+3.17 dBm into 600
.
Reverse Active (Off-Hook)
I
Pin PR is positive with respect to PT.
I
V
BAT2
is applied to tip/ring drive amplifiers via the soft
battery switch for the majority of loop lengths. This
may also be derived from V
BAT1
through a power
control resistor.
I
Loop closure and common-mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
Overhead is set to nominal 4.0 V for undistorted
transmission of 0 dBm into 600
and may be
increased automatically for larger signal levels.
Forward Active (On-Hook)
I
Pin PT is positive with respect to PR.
I
V
BAT1
is applied to tip/ring drive amplifiers. The tip to
ring on-hook differential voltage will be between
–42.5 V and –56.5 V with a primary battery of –65 V.
I
Loop closure and common-mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
On-hook transmission is enabled.
I
Overhead is set to nominal 17.0 V for undistorted
transmission of 0 dBm into 600
.
Reverse Active (On-Hook)
I
Pin PR is positive with respect to PT.
I
V
BAT1
is applied to tip/ring drive amplifiers. The tip to
ring on-hook differential voltage will be between
–42.5 V and –56.5 V with a primary battery of –65 V.
I
Loop closure and common-mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
On-hook transmission is enabled.
I
Overhead is set to nominal 17.0 V for undistorted
transmission of 0 dBm into 600
.
Scan
I
Except for loop closure, all circuits (including ring trip
and common-mode detector) are powered down.
I
On-hook transmission is disabled.
I
Pin PT is positive with respect to PR, and V
BAT1
is
applied to tip/ring.
I
The tip to ring on-hook differential voltage will be
between –42.5 V and –56.5 V with a –65 V primary
battery.
Disconnect
I
The tip/ring amplifiers and all supervision are turned
off.
I
The SLIC goes into a high-impedance state.
I
NSTAT is forced high (on-hook).
Ring
I
Power ring signal is applied to tip and ring.
I
Software-selectable slew rate, fast or slow.
I
Ring trip supervision and common-mode current
supervision are active; loop closure is inactive.
I
Overhead voltage is reduced to typically 2.5 V and
current limit set at I
PROG
is disabled.
I
Current is limited by saturation current of the amplifi-
ers themselves, typically 72 mA peak at 125 °C.
Thermal Shutdown
I
Not controlled via truth table inputs.
I
This mode is caused by excessive heating of the
device, such as may be encountered in an extended
power-cross situation.
相關PDF資料 |
PDF描述 |
|---|---|
| L9214G | Low-Cost Ringing SLIC(低價格振鈴用戶環路接口電路) |
| L9215G | Short-Loop Sine Wave Ringing SLIC(短環路正弦波振鈴用戶接口（SLIC）) |
| L9215A | Short-Loop Sine Wave Ringing SLIC(短環路正弦波振鈴用戶接口（SLIC）) |
| L9216A | Short-Loop Ringing SLIC with Ground Start(接地起動的短環路振鈴用戶接口) |
| L9216G | Short-Loop Ringing SLIC with Ground Start(接地起動的短環路振鈴用戶接口) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L9215A | 制造商:AGERE 制造商全稱:AGERE 功能描述:Short-Loop Sine Wave Ringing SLIC |
| L9216A | 制造商:AGERE 制造商全稱:AGERE 功能描述:Short-Loop Ringing SLIC with Ground Start |
| L9217A | 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Line Interface with Reverse Battery and PPM |
| L9218A | 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Line Interface |
| L9219A | 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Line Interface with Reverse Battery and Dual Current Limit |
發布緊急采購，3分鐘左右您將得到回復。