參數資料
型號： L6995STR
廠商： STMICROELECTRONICS
元件分類： 穩壓器
英文描述： SWITCHING CONTROLLER, PDSO20
封裝： MO-153-AC, TSSOP-20
文件頁數： 9/26頁
文件大?。?/td> 427K
代理商： L6995STR
17/26
L6995S
Eq 20
Considering a switching frequency around 270kHz from the equation above the ripple current is around 7A.
So the maximum ESR should be:
Eq 21
The dynamic specifications are sometimes more relaxed than the static requirements so the ESR value around
7m
should be enough.
The current ripple flows through the output capacitor, so the output capacitors should be calculated also to sus-
tain this ripple: the RMS current value is given from Eq22.
Eq 22
But this is usually a negligible constrain when choosing output capacitor.
To allow the device control loop to work properly output capacitor zero should be at the least ten times smaller
than switching frequency. The output capacitor value (COUT) and the output capacitor ESR (ESROUT) should be
large enough and small enough, to keep the output voltage ripple within the specification and to give to the de-
vice a minimum signal to noise ratio.
6.4 Power MOSFETS and Schottky Diodes
Since a 5V bus powers the gate drivers of the device, the use of logic-level MOSFETS is highly recommended,
especially for high current applications. The breakdown voltage VBRDSS must be greater than VINMAX with a
certain margin.
The RDSON can be selected once the allowable power dissipation has been established. By selecting identical
Power MOSFET for the main switch and the synchronous rectifier, the total power they dissipate does not de-
pend on the duty cycle. Thus, if PON is this power loss (few percent of the rated output power), the required
RDSON (@ 25 °C) can be derived from:
Eq 23
α is the temperature coefficient of RDSON (typically, α = 510-3 °C-1 for these low-voltage classes) and T the
admitted temperature rise. It is worth noticing, however, that generally the lower RDSON, the higher is the gate
charge QG, which leads to a higher gate drive consumption. In fact, each switching cycle, a charge QG moves
from the input source to ground, resulting in an equivalent drive current:
Eq 24
For application with low Duty Cycle, where the input voltage is high (around 20V) it is very important to select
the high side MOSFET with low gate charge, to reduce the switching losses as STS11NF3LL. For the low side
section should be selected a low RDSON as STS25NH3LL.
A SCHOTTKY diode can be added to increase the system efficiency at high switching frequency (where the
dead times could be an important part of total switching period).
This optional diode must be placed in parallel to the synchronous rectifier must have a reverse voltage VRRM
greater than VINMAX. The current size of the diode must be selected in order to keep it in safe operating condi-
tions.
I
Vin
Vo
–
L
-----------------------
Vo
Vin
--------- T
sw
=
ESR
V
ripple
I
2
-----
---------------------
7m
==
Icout
rms
1
23
----------- I
L
=
RDS
ON
P
ON
Iout
2
1
α
T
+
()
-------------------------------------------------
=
Iq
Qg F
SW
=
相關PDF資料
PDF描述
L6997D SWITCHING CONTROLLER, PDSO20
L6997DTR SWITCHING CONTROLLER, PDSO20
L7200 DISK DRIVE MOTOR CONTROLLER, 2.6 A, PQFP64
L7250 VOICE COIL MOTOR CONTROLLER, PQFP64
L7980A 3.5 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO8
相關代理商/技術參數
參數描述
L6996 功能描述:DC/DC 開關控制器 Step-Down Contrllr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
L6996-1 制造商:Johanson 功能描述:TUNING ROTOR
L6996-13 制造商:Johanson Manufacturing 功能描述:TUNING ELEMENT
L6996-16 制造商:Johanson Manufacturing 功能描述:TUNING ELEMENT
L6996-17 制造商:Johanson Manufacturing 功能描述:TUNING ELEMENT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*