- 您現在的位置：買賣IC網 > PDF目錄43901 > L6732TR (STMICROELECTRONICS) SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | L6732TR |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | LEAD FREE, HTSSOP-16 |
| 文件頁數： | 8/37頁 |
| 文件大?。?/td> | 898K |
| 代理商： | L6732TR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
Device description
L6732
16/37
5.7
Driver section
The high-side and low-side drivers allow using different types of power MOSFETs (also
multiple MOSFETs to reduce the RDS(on) maintaining fast switching transitions.
The low-side driver is supplied by VCCDR while the high-side driver is supplied by the BOOT
pin. A predictive dead time control avoids MOSFETs cross-conduction maintaining very
short dead time duration in the range of 20 ns. The control monitors the phase node in order
to sense the low-side body diode recirculation. If the phase node voltage is less than a
certain threshold (-350 mV typ.) during the dead time, it will be reduced in the next PWM
cycle. The predictive dead time control doesn't work when the high-side body diode is
conducting because the phase node doesn't go negative. This situation happens when the
converter is sinking current for example and, in this case, an adaptive dead time control
operates.
5.8
Monitoring and protections
The output voltage is monitored by means of pin FB. If it is not within ±10 % (typ.) of the
programmed value, the Power good (PGOOD) output is forced low.
The device provides over-voltage-protection: when the voltage sensed on FB pin reaches a
value 20% (typ.) greater than the reference, the low-side driver is turned on as long as the
over voltage is detected (see Figure 10.).
It must be taken into account that there is an electrical network between the output terminal
and the FB pin and therefore the voltage at the pin is not a perfect replica of the output
voltage. However due to the fact that the converter can sink current, in the most of cases the
low-side will turn-on before the output voltage exceeds the over-voltage threshold, because
the error amplifier will throw off balance in advance. Even if the device doesn't report an
over-voltage, the behavior is the same, because the low-side is turned-on immediately. The
following figure shows the device behavior during an over-voltage event. The output voltage
Figure 10.
OVP
LGate
FB
相關PDF資料 |
PDF描述 |
|---|---|
| L6788ATR | 3-CHANNEL POWER SUPPLY SUPPORT CKT, QCC40 |
| L6788A | 3-CHANNEL POWER SUPPLY SUPPORT CKT, QCC40 |
| L6910A | 1.3 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| L6910GTR | 1.3 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| L6917BD | SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L6733 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Advanced modular synchronous PWM controller |
| L6733TR | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Advanced modular synchronous PWM controller |
| L6738 | 功能描述:電流型 PWM 控制器 Single-Phase SD Cont 5V to 12V bus 1.5V RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| L6738A | 功能描述:電流型 PWM 控制器 Single-phase PWM Light Load EFF RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| L6738ATR | 功能描述:電流型 PWM 控制器 Single Phase PWM CNTRL Light-Load EFF RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
發布緊急采購，3分鐘左右您將得到回復。