- 您現在的位置：買賣IC網 > PDF目錄97995 > L6728D (STMICROELECTRONICS) 30 A SWITCHING CONTROLLER, 300 kHz SWITCHING FREQ-MAX, PDSO10 PDF資料下載
參數資料
| 型號： | L6728D |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 穩壓器 |
| 英文描述： | 30 A SWITCHING CONTROLLER, 300 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | 3 X 3 MM, ROHS COMPLIANT, DFN-10 |
| 文件頁數： | 5/33頁 |
| 文件大小： | 1215K |
| 代理商： | L6728D |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
L6728D
Overcurrent protection
Doc ID 16498 Rev 1
13/33
8
Overcurrent protection
The overcurrent function protects the converter from a shorted output or overload, by
sensing the output current information across the low side MOSFET drain-source on-
resistance, RDS(on). This method reduces cost and enhances converter efficiency by
avoiding the use of expensive and space-consuming sense resistors.
The low side RDS(on) current sense is implemented by comparing the voltage at the PHASE
node when the LS MOSFET is turned on with the programmed OCP threshold voltages,
internally held. If the monitored voltage is higher than these thresholds, an overcurrent event
is detected.
For maximum safety and load protection, the L6728D implements a dual-level overcurrent
protection system:
●
1st level threshold: This is the user externally-set threshold. If the monitored voltage
on PHASE exceeds this threshold, a 1st level overcurrent is detected. If four 1st level
OC events are detected in four consecutive switching cycles, overcurrent protection is
triggered.
●
2nd level threshold: This is an internal threshold whose value is equal to the 1st level
threshold multiplied by a factor 1.5. If the monitored voltage on PHASE exceeds this
threshold, overcurrent protection is triggered immediately.
When overcurrent protection is triggered, the device turns off both the LS and HS MOSFETs
in a latched condition.
To recover from an overcurrent protection-triggered condition, the VCC power supply must
be cycled.
相關PDF資料 |
PDF描述 |
|---|---|
| L6911C | 1.3 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO20 |
| L6911DTR | 1.3 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO20 |
| L6911E | 1.3 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO20 |
| L6911ETR | 1.3 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO20 |
| L6924U013 | POWER SUPPLY SUPPORT CKT, PQCC16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L6728DTR | 功能描述:電流型 PWM 控制器 Single-Phase PWM 5V to 12V Controller RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| L6728H | 功能描述:電壓模式 PWM 控制器 Sgl Output 300 KHz DFN-10 RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓?fù)浣Y(jié)構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| L6728HTR | 功能描述:電流型 PWM 控制器 SINGLE PHASE PWM CNTRL PWR GOOD RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| L6728TR | 功能描述:DC/DC 開關控制器 Sngl phase PWM controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| L6730 | 功能描述:DC/DC 開關控制器 Adjustable Step Down Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
發布緊急采購，3分鐘左右您將得到回復。