參數資料
型號: L5962
廠商: STMICROELECTRONICS
元件分類: 穩壓器
英文描述: SWITCHING REGULATOR, PDSO36
封裝: ROHS COMPLAINT, SOP-36
文件頁數: 7/24頁
文件大?。?/td> 242K
代理商: L5962
L5962
Device description
Doc ID 16819 Rev 2
4
Device description
The IC includes one standby regulator, always active to guarantee the standby functions;
two switched linear regulators, managed by the I2C bus and a step-down switching voltage
regulator with selectable current limit.
4.1
Regulators
The VSTBY regulator is always active when the IC is supplied.
The other regulators can be enabled or disabled. Their outputs are automatically disabled
whenever the VBAT voltage exceeds the over-voltage shutdown threshold. Upon return from
over-voltage shutdown, the outputs recover without intervention from the system.
4.1.1
Linear regulators
VSTBY (3.3 V / 5.0 V standby)
VSTBY is a linearly regulated 3.3/5 V output. This output is enabled on battery connect. It is
supplied from the protected battery input (VBATP).
In order to select the 3.3 V output, the VSTBYSEL pin must be connected to ground.
In order to select the 5.0 V output, the VSTBYSEL pin must be connected to 5 V.
When the dropout voltage of the regulator cannot be maintained, the output shall track the
VBATP input voltage less the saturation voltage of the regulator pass element.
This regulator has a short circuit protection consisting of current limit, and thermal
shutdown. If the local die temperature exceeds the thermal shutdown detection threshold,
the output is disabled. The thermal shutdown circuitry has hysteresis such that the output is
enabled only after the die temperature falls below the thermal shutdown disable threshold.
Thermal shutdown on this output doesn't directly disable any other circuitry.
RST provides an indication that VSTBY is in regulation. It is an open drain output used to
indicate that VSTBY is in regulation (below the low-voltage threshold). RST remains low
until VSTBY achieves regulation and the RSTDLY input has charged to its threshold. For
instance, RST remains low during battery connect and disconnect and under low-voltage
battery lockout. The transition from standby mode to active mode (and vice versa) does not
cause the RST output to be triggered.
RSTDLY provides a means to delay the releasing of RST once VSTBY has achieved
regulation. It is used to delay the release of RST when VSTBY achieves regulation. This
input has a current source to charge an external capacitor and an internal pull-down to
discharge the external capacitor. The voltage on this capacitor is used to control the
operation of the RST output.
The RSTDLY pull-down is activated when a loss of regulation is detected. The input remains
low until VSTBY once again achieves regulation.
When the RSTDLY is released the current source charges the external capacitor. When the
voltage exceeds the pin's threshold, RST pin is also released, disabling its pull-down.
相關PDF資料
PDF描述
L5973DD 3.5 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDSO8
L5988D 5.6 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO16
L5994A 1 A DUAL SWITCHING CONTROLLER, 345 kHz SWITCHING FREQ-MAX, PQFP32
L5994 1 A DUAL SWITCHING CONTROLLER, 345 kHz SWITCHING FREQ-MAX, PQFP32
L6206PD013TR STEPPER MOTOR CONTROLLER, 5.6 A, PDSO36
相關代理商/技術參數
參數描述
L5962TR 功能描述:低壓差穩壓器 - LDO Multifunction Voltage Regulator RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
L5963D-EHX 功能描述:Linear And Switching Voltage Regulator IC 3 Output Step-Down (Buck) Synchronous (2), Linear (LDO) (1) 250kHz ~ 2MHz 36-PowerFSOP (0.295", 7.50mm Width) 制造商:stmicroelectronics 系列:- 包裝:管件 零件狀態:有效 拓?fù)?降壓(降壓)同步(2),線性(LDO)(1) 功能:任何功能 輸出數:3 頻率 - 開關:250kHz ~ 2MHz 電壓/電流 - 輸出 1:可編程,2.5A 電壓/電流 - 輸出 2:可編程,3A 電壓/電流 - 輸出 3:可編程,250mA 帶 LED 驅動器:無 帶監控器:無 帶定序器:無 電壓 - 電源:3.5 V ~ 26 V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:36-??FSOP(0.295",7.50mm 寬) 供應商器件封裝:36-PWRSSO EP 標準包裝:49
L5963Q-V0Y 功能描述:IC REG BCK/LIN/SYNC TRPL 48VFQFN 制造商:stmicroelectronics 系列:- 包裝:托盤 零件狀態:在售 拓?fù)?降壓同步(1),線性(LDO)(1) 功能:任何功能 輸出數:3 頻率 - 開關:250kHz ~ 2MHz 電壓/電流 - 輸出 1:可編程,2.5A 電壓/電流 - 輸出 2:可編程,3A 電壓/電流 - 輸出 3:可編程,250mA 帶 LED 驅動器:無 帶監控器:無 帶定序器:無 電壓 - 電源:3.5 V ~ 26 V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:48-TFQFN 裸露焊盤 供應商器件封裝:48-VFQFPN(7x7) 標準包裝:260
L5970 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:UP TO 1A STEP DOWN SWITCHING REGULATOR
L5970AD 功能描述:直流/直流開關調節器 4.4-36V 1A Step-Down RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5