- 您現在的位置：買賣IC網 > PDF目錄383231 > L3916A (意法半導體) SPEECH AND 14 MEMORY DIALER WITH LED DRIVER PDF資料下載
參數資料
| 型號： | L3916A |
| 廠商： | 意法半導體 |
| 元件分類： | LED驅動器 |
| 英文描述： | SPEECH AND 14 MEMORY DIALER WITH LED DRIVER |
| 中文描述： | 言論和14記憶體，LED驅動撥號器 |
| 文件頁數： | 5/14頁 |
| 文件大?。?/td> | 124K |
| 代理商： | L3916A |
To dial a number from repertory memory (HKS
must be low), enter the following:
MEM (Location 0-9) or E1-E3
To save the last number dialed, enter the follow-
ing:
PROG MEM (location 0-9) or E1-E3
HOOK FLASH
D1
FLASH
D2
...etc
Hook flash may be entered into the dialed se-
quence at any point by keying in the functionkey,
FLASH. Flash consists of a timed break of
585ms, 300ms or 100ms dependingon the Mask
option. When a FLASH key is pressed, no further
key inputs will be accepted until the hookflash
function has been dialed. The key input following
a FLASH will be stored as the initial digit of the
new number, overwriting the number dialed be-
forethe FLASH, unless it is another FLASH.
FLASH key pressed immediately after hookswitch
or LND will not clear the LND buffer unless digits
are enteredfollowing the FLASH key.
Example:
FLASH
LND not cleared
LND
FLASH
LND not cleared
LND
FLASH
LND bufferwill containD1, D2
D1
D2
PAUSE/LAST NUMBER DIALED
If the PAUSE/LND key is pressed right after off
hook or FLASH key, it is considered as LND, if it
is pressed after a digit, it will be considered as
PAUSE.
LAST NUMBERED DIALED
OFF-HOOK PAUSE/LNDor FLASH PAUSE/LND
Last number dialing is accomplished by entering
the PAUSE/LND key.
PAUSE
OFF-HOOK D1
PAUSE/LND
A pausemay be enteredinto the dialed sequence
at any point by keying in the special function key,
D2
...etc
PAUSE/LND. Pause inserts a 3.1 second delay
into the dialing sequence. The total delay, includ-
ing pre-digit and post-digit pausesis shown in Ta-
ble 3.
Table 3:
SpecialFunction Delays
Each delay shown below represents the time re-
quired after the special function key is depressed
until a new digit is dialed. The time is considered
”FIRST” key if all previous inputs have been com-
pletely dialed. The time is considered”AUTO” if in
redial, or if previousdialling is still in progress.
Function
First/Auto
Delay (seconds)
Pulse
0.2
1.0
2.6
3.4
Tone
SOFTSWITCH
FIRST
AUTO
FIRST
AUTO
PAUSE
3.0
3.1
SOFTSWITCH FUNCTION USING TONE/PULSE
MODE SWITCH
When dialing in Pulse mode after off-hook,
switching TONE/PULSE mode switch from Pulse
to Tone will cause the device to change the sig-
naling mode into tone signal and store the soft-
switch function in the LND memory for redial. To
redial the softswitch function(mixed mode dialing)
in the pulse mode after going on-hook and back
to off-hook,you have to switch the TONE/PULSE
mode switch back to pulse mode either before go-
ing on-hook or after off-hookor during on-hook.
Subsequentmode change from Tone to Pulse will
change the signaling mode to pulse dialing se-
quence but this mode change will not be stored in
.the LND memory.
When dialing in Tone mode after off-hook, a
switching of TONE/PULSE mode Switch from
Tone to Pulse will cause the device to changethe
signaling mode into pulse mode but this mode
change will not be stored in the LND memory.
When LND key is pressed in Tone mode after go-
ing off-hook, the device will output all tone sig-
nals.
A pacifiertone of 75msis provided after 32ms de-
bounce time when switching from Pulse to Tone
mode.
Redial by the LND key will repeat the mixed dial-
ing sequencein Pulsemode.
FUNCTION PIN DESCRIPTION
(continued)
L3916A
5/14
相關PDF資料 |
PDF描述 |
|---|---|
| L3916AD | SPEECH AND 14 MEMORY DIALER WITH LED DRIVER |
| L3926A | Speech and 14 Memory Dialer With LED Driver(語音電路和14個存儲器的撥號器帶LED驅動器) |
| L3936A | Speech and 14 Memory Dialer With LED Driver(語音電路和14個存儲器的撥號器帶LED驅動器) |
| L4620 | LIQUID LEVEL ALARM |
| L465 | LINEAR INTEGRATED CIRCUITS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L3916A_1 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:SPEECH AND 14 MEMORY DIALER WITH LED DRIVER |
| L3916AD | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:SPEECH AND 14 MEMORY DIALER WITH LED DRIVER |
| L3916AN | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:SPEECH AND 14 MEMORY DIALER WITH LED DRIVER |
| L392 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:THYRISTOR MODULE|SCR|DUAL|INDEPENDENT|240V V(RRM)|15A I(T) |
| L-392 | 制造商:RHOMBUS-IND 制造商全稱:Rhombus Industries Inc. 功能描述:Dual Inductor |
發布緊急采購，3分鐘左右您將得到回復。