- 您現在的位置：買賣IC網 > PDF目錄1932 > KSZ8873MLLJ (Micrel Inc)IC ETHERNET SWITCH 3PORT 64LQFP PDF資料下載
參數資料
| 型號： | KSZ8873MLLJ |
| 廠商： | Micrel Inc |
| 文件頁數： | 30/108頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ETHERNET SWITCH 3PORT 64LQFP |
| 特色產品： | KSZ8873MLLJ Ethernet Switches |
| 標準包裝： | 160 |
| 系列： | * |
| 其它名稱： | 576-3996 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁當前第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁
Micrel, Inc.
KSZ8873MLLJ
September 2011
28
M9999-091911-1.8
To ensure no packet loss in 10 BASE-T or 100 BASE-TX half duplex modes, the user must enable the following:
1. Aggressive back-off (register 3 (0x03), bit [0])
2. No excessive collision drop (register 4 (0x04), bit [3])
Note: These bits are not set as defaults, as this is not the IEEE standard.
Broadcast Storm Protection
The KSZ8873MLLJ has an intelligent option to protect the switch system from receiving too many broadcast packets. As
the broadcast packets are forwarded to all ports except the source port, an excessive number of switch resources
(bandwidth and available space in transmit queues) may be utilized. The KSZ8873MLLJ has the option to include
“multicast packets” for storm control. The broadcast storm rate parameters are programmed globally, and can be enabled
or disabled on a per port basis. The rate is based on a 67ms interval for 100BT and a 500ms interval for 10BT. At the
beginning of each interval, the counter is cleared to zero, and the rate limit mechanism starts to count the number of bytes
during the interval. The rate definition is described in register 6 (0x06) and 7 (0x07). The default setting is 0x63 (99
decimal). This is equal to a rate of 1%, calculated as follows:
148,800 frames/sec * 67ms/interval * 1% = 99 frames/interval (approx.) = 0x63
Note: 148,800 frames/sec is based on 64-byte block of packets in 100BASE-TX with 12 bytes of IPG and 8 bytes of
preamble between two packets.
Port Individual MAC address and Source Port Filtering
The KSZ8873MLLJ provide individual MAC address for port 1 and port 2 respectively. They can be set at register 142-147
and 148-153. With this feature, the CPU connected to the port 3 can receive the packets from two internet subnets which
has their own MAC address.
The packet will be filtered if its source address matches the MAC address of port 1 or port 2 when the register 21 and 37
bit 6 is set to 1 respectively. For example, the packet will be dropped after it completes the loop of a ring network.
MII Interface Operation
The Media Independent Interface (MII) is specified in Clause 22 of the IEEE 802.3u Standard. It provides a common
interface between physical layer and MAC layer devices. The MII provided by the KSZ8873 MLLJ is connected to the
device’s third MAC. The interface contains two distinct groups of signals: one for transmission and the other for reception.
The following table describes the signals used by the MII bus.
PHY-Mode Connections
MAC-Mode Connections
External MAC
Controller Signals
KSZ8873 MLLJ
PHY Signals
Pin
Descriptions
External
PHY Signals
KSZ8873 MLLJ
MAC Signals
MTXEN
SMTXEN3
Transmit enable
MTXEN
SMRXDV3
MTXER
SMTXER3
Transmit error
MTXER
(not used)
MTXD3
SMTXD33
Transmit data bit 3
MTXD3
SMRXD33
MTXD2
SMTXD32
Transmit data bit 2
MTXD2
SMRXD32
MTXD1
SMTXD31
Transmit data bit 1
MTXD1
SMRXD31
MTXD0
SMTXD30
Transmit data bit 0
MTXD0
SMRXD30
MTXC
SMTXC3
Transmit clock
MTXC
SMRXC3
MCOL
SCOL3
Collision detection
MCOL
SCOL3
MCRS
SCRS3
Carrier sense
MCRS
SCRS3
MRXDV
SMRXDV3
Receive data valid
MRXDV
SMTXEN3
MRXER
(not used)
Receive error
MRXER
SMTXER3
MRXD3
SMRXD33
Receive data bit 3
MRXD3
SMTXD33
MRXD2
SMRXD32
Receive data bit 2
MRXD2
SMTXD32
MRXD1
SMRXD31
Receive data bit 1
MRXD1
SMTXD31
MRXD0
SMRXD30
Receive data bit 0
MRXD0
SMTXD30
MRXC
SMRXC3
Receive clock
MRXC
SMTXC3
Table 3. MII Signals
相關PDF資料 |
PDF描述 |
|---|---|
| KSZ8873MMLI | IC ETHERNET SWITCH 3PORT 64LQFP |
| KSZ8893FQL | IC SWITCH FAST ETH 3PORT 128PQFP |
| KSZ8895MQI | IC ETHERNET SWITCH 5PORT 128PQFP |
| KSZ8895MQ | IC ETHERNET SW 5PORT 128-PQFP |
| KSZ8993FL | IC CONV MED 10/100 SGL 128PQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ8873MML | 功能描述:以太網 IC 3-Port Fast Ethernet Switch with 2x MII Interface, Lead Free RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8873MML-EVAL | 功能描述:以太網開發工具 3-Port Fast Ethernet Switch with 2x MII Interface - Evaluation Board RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓: |
| KSZ8873MMLI | 功能描述:以太網 IC 3-Port Fast Ethernet Switch with 2x MII Interface (Industrial Grade) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8873RLL | 功能描述:以太網 IC 3-Port Fast Ethernet Switch with 1x RMII Interface, Lead Free RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8873RLL-EVAL | 功能描述:以太網開發工具 3-Port Fast Ethernet Switch with 1x RMII Interface - Evalaution Board RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓: |
發布緊急采購，3分鐘左右您將得到回復。