參數資料
型號： JS28F640P30T85
廠商： INTEL CORP
元件分類： DRAM
英文描述： Intel StrataFlash Embedded Memory
中文描述： 4M X 16 FLASH 1.8V PROM, 85 ns, PDSO56
封裝： 14 X 20 MM, LEAD FREE, TSOP-56
文件頁數： 53/102頁
文件大?。?/td> 1609K
代理商： JS28F640P30T85
1-Gbit P30 Family
Datasheet
Intel StrataFlash
Embedded Memory (P30)
Order Number: 306666, Revision: 001
April 2005
53
10.0
Read Operations
The device supports two read modes: asynchronous page mode and synchronous burst mode.
Asynchronous page mode is the default read mode after device power-up or a reset. The Read
Configuration Register must be configured to enable synchronous burst reads of the flash memory
array (see
Section 10.3, “Read Configuration Register” on page 54
).
The device can be in any of four read states: Read Array, Read Identifier, Read Status or Read
Query. Upon power-up, or after a reset, the device defaults to Read Array. To change the read state,
the appropriate read command must be written to the device (see
Section 9.2, “Device Commands”
on page 50
). See
Section 14.0, “Special Read States” on page 75
for details regarding Read Status,
Read ID, and CFI Query modes.
The following sections describe read-mode operations in detail.
10.1
Asynchronous Page-Mode Read
Following a device power-up or reset, asynchronous page mode is the default read mode and the
device is set to Read Array. However, to perform array reads after any other device operation (e.g.
write operation), the Read Array command must be issued in order to read from the flash memory
array.
Note:
Asynchronous page-mode reads can only be performed when Read Configuration Register bit
RCR[15] is set (see
Section 10.3, “Read Configuration Register” on page 54
).
To perform an asynchronous page-mode read, an address is driven onto the Address bus, and CE#
and ADV# are asserted. WE# and RST# must already have been deasserted. WAIT is deasserted
during asynchronous page mode. ADV# can be driven high to latch the address, or it must be held
low throughout the read cycle. CLK is not used for asynchronous page-mode reads, and is ignored.
If only asynchronous reads are to be performed, CLK should be tied to a valid V
IH
level, WAIT
signal can be floated and ADV# must be tied to ground. Array data is driven onto DQ[15:0] after
an initial access time t
AVQV
delay. (see
Section 7.0, “AC Characteristics” on page 33
).
In asynchronous page mode, four data words are “sensed” simultaneously from the flash memory
array and loaded into an internal page buffer. The buffer word corresponding to the initial address
on the Address bus is driven onto DQ[15:0] after the initial access delay. The lowest two address
bits determine which word of the 4-word page is output from the data buffer at any given time.
10.2
Synchronous Burst-Mode Read
To perform a synchronous burst- read, an initial address is driven onto the Address bus, and CE#
and ADV# are asserted. WE# and RST# must already have been deasserted. ADV# is asserted, and
then deasserted to latch the address. Alternately, ADV# can remain asserted throughout the burst
access, in which case the address is latched on the next valid CLK edge while ADV# is asserted.
During synchronous array and non-array read modes, the first word is output from the data buffer
on the next valid CLK edge after the initial access latency delay (see
Section 10.3.2, “Latency
Count” on page 55
). Subsequent data is output on valid CLK edges following a minimum delay.
相關PDF資料
PDF描述
JS28F128P30B85 Intel StrataFlash Embedded Memory
JS4PS-1W Power Splitter/Combiner
JSPHS-1000 180?Voltage Variable, 700 to 1000 MHz
JSPHS-12 Phase Shifter
JSPHS-150 Narrow Band Phase Shifter 50ohm 180 Voltage Variable 100 to 150 MHz
相關代理商/技術參數
參數描述
JS28F640P30T85A 功能描述:IC FLASH 64MBIT 85NS 56TSOP RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:StrataFlash™ 標準包裝:1 系列:- 格式 - 存儲器:RAM 存儲器類型:SDRAM 存儲容量:256M（8Mx32） 速度:143MHz 接口:并聯 電源電壓:3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 封裝/外殼:90-VFBGA 供應商設備封裝:90-VFBGA（8x13） 包裝:托盤 其它名稱:Q2841869
JS28F640P30TF75A 制造商:Micron Technology Inc 功能描述:PARALLEL NOR - Trays 制造商:Micron Technology Inc 功能描述:MICJS28F640P30TF75A 64MB NOR FLASH MEMOR 制造商:Micron Technology Inc 功能描述:NOR Flash Parallel/Serial 1.8V 64Mbit 4M x 16bit 75ns 56-Pin TSOP Tray 制造商:Micron Technology Inc 功能描述:IC FLASH 64MBIT 75NS 56TSOP
JS28F640P33B85A 功能描述:IC FLASH 64MBIT 85NS 56TSOP RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:StrataFlash™ 產品變化通告:Product Discontinuation 26/Apr/2010 標準包裝:136 系列:- 格式 - 存儲器:RAM 存儲器類型:SRAM - 同步，DDR II 存儲容量:18M（1M x 18） 速度:200MHz 接口:并聯 電源電壓:1.7 V ~ 1.9 V 工作溫度:0°C ~ 70°C 封裝/外殼:165-TBGA 供應商設備封裝:165-CABGA（13x15） 包裝:托盤 其它名稱:71P71804S200BQ
JS28F640P33BF70A 制造商:Micron Technology Inc 功能描述:NOR Flash Parallel/Serial 2.5V/3.3V 64Mbit 4M x 16bit 70ns 56-Pin TSOP Tray 制造商:Micron Technology Inc 功能描述:PARALLEL NOR - Trays 制造商:Micron Technology Inc 功能描述:FLASH PARALLEL 64MBIT 56TSO 制造商:Micron Technology Inc 功能描述:FLASH, PARALLEL, 64MBIT, 56TSOP 制造商:Micron Technology Inc 功能描述:FLASH, PARALLEL, 64MBIT, 56TSOP; Memory Type:Flash - NOR; Memory Size:64Mbit; Memory Configuration:4M x 16bit; Supply Voltage Min:2.3V; Supply Voltage Max:3.6V; Memory Case Style:TSOP; No. of Pins:56; Clock Frequency:40MHz; Access ;RoHS Compliant: Yes
JS28F640P33T85A 功能描述:IC FLASH 64MBIT 85NS 56TSOP RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:StrataFlash™ 產品變化通告:Product Discontinuation 26/Apr/2010 標準包裝:136 系列:- 格式 - 存儲器:RAM 存儲器類型:SRAM - 同步，DDR II 存儲容量:18M（1M x 18） 速度:200MHz 接口:并聯 電源電壓:1.7 V ~ 1.9 V 工作溫度:0°C ~ 70°C 封裝/外殼:165-TBGA 供應商設備封裝:165-CABGA（13x15） 包裝:托盤 其它名稱:71P71804S200BQ
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*