參數資料
型號： ISL8102EVAL1
廠商： Intersil Corporation
英文描述： Two-Phase Buck PWM Controller with High Current Integrated MOSFET Drivers
中文描述： 兩相降壓PWM控制器，帶有高電流集成MOSFET驅動器
文件頁數： 20/27頁
文件大?。?/td> 711K
代理商： ISL8102EVAL1
20
FN9247.0
October 19, 2005
Due to errors in the inductance or DCR it may be necessary
to adjust the value of R
COMP
to match the time constants
correctly. The effects of time constant mismatch can be seen
in the form of droop overshoot or undershoot during the
initial load transient spike, as shown in Figure 19. Follow the
steps below to ensure the R-C and inductor L/DCR time
constants are matched accurately.
1. Capture a transient event with the oscilloscope set to
about L/DCR/2 (sec/div). For example, with L = 1
μ
H and
DCR = 1m
, set the oscilloscope to 500
μ
s/div.
2. Record
V
1
and
V
2
as shown in Figure 19.
3. Select a new value, R
COMP,2
, for the time constant
resistor based on the original value, R
COMP,1
, using the
following equation.
4. Replace R
COMP
with the new value and check to see that
the error is corrected. Repeat the procedure if necessary.
After choosing a new value for R
COMP
, it will most likely be
necessary to adjust the value of R
S
to obtain the desired full
load droop voltage. Use Equation 26 to obtain the new value
for R
S
.
Compensation
The two opposing goals of compensating the voltage
regulator are stability and speed. Depending on whether the
regulator employs the optional load-line regulation as
described in Load-Line Regulation, there are two distinct
methods for achieving these goals.
Compensating the Load-Line Regulated Converter
The load-line regulated converter behaves in a similar
manner to a peak current mode controller because the two
poles at the output filter L-C resonant frequency split with the
introduction of current information into the control loop. The
final location of these poles is determined by the system
function, the gain of the current signal, and the value of the
compensation components, R
2
and C
1
.
Since the system poles and zero are affected by the values
of the components that are meant to compensate them, the
solution to the system equation becomes fairly complicated.
Fortunately, there is a simple approximation that comes very
close to an optimal solution. Treating the system as though it
were a voltage-mode regulator, by compensating the L-C
poles and the ESR zero of the voltage mode approximation,
FIGURE 18. DCR SENSING CONFIGURATION
-
+
ICOMP
DCR
L
INDUCTOR
IL
1
V
OUT
C
OUT
-
+V
L
(s)
DCR
L
INDUCTOR
IL
2
PHASE1
PHASE2
R
S
R
S
R
COMP
C
COMP
ISUM
IREF
ISL8102
-
+
V
DROOP
I
OUT
DROOP
R
COMP 2
R
COMP 1
V
1
V
2
----------
=
(EQ. 27)
FIGURE 19. TIME CONSTANT MISMATCH BEHAVIOR
V
1
V
OUT
I
TRAN
V
2
I
FIGURE 20. COMPENSATION CONFIGURATION FOR
LOAD-LINE REGULATED ISL8102 CIRCUIT
ISL8102
COMP
C
1
R
2
R
1
FB
VDIFF
C
2
(OPTIONAL)
ISL8102
相關PDF資料
PDF描述
ISL81387 ±15kV ESD Protected, Dual Protocol (RS-232/RS-485) Transceivers(±15kV ESD保護，雙協議(RS-232/RS-485)收發器)
ISL81483 1/8 Unit Load, 5V, Low Power, High Speed or Slew Rate Limited, RS-485/RS-422 Transceivers(1/8 單位負載、5V、小功率、高速或帶有限斜率功能的RS-485/RS-422收發器)
ISL81487 1/8 Unit Load, 5V, Low Power, High Speed or Slew Rate Limited, RS-485/RS-422 Transceivers(1/8 單位負載、5V、小功率、高速或帶有限斜率功能的RS-485/RS-422收發器)
ISL8487 1/8 Unit Load, 5V, Low Power, High Speed or Slew Rate Limited, RS-485/RS-422 Transceivers(1/8 單位負載、5V、小功率、高速或帶有限斜率功能的RS-485/RS-422收發器)
ISL81485IU 5V, 30Mbps, RS-485/RS-422 Transceiver
相關代理商/技術參數
參數描述
ISL8102IRZ 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:100% 電源電壓:8.2 V ~ 30 V 降壓:無 升壓:無 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:0°C ~ 70°C 封裝/外殼:8-DIP（0.300"，7.62mm） 包裝:管件 產品目錄頁面:1316 (CN2011-ZH PDF)
ISL8102IRZ-T 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:100% 電源電壓:8.2 V ~ 30 V 降壓:無 升壓:無 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:0°C ~ 70°C 封裝/外殼:8-DIP（0.300"，7.62mm） 包裝:管件 產品目錄頁面:1316 (CN2011-ZH PDF)
ISL8103 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Three-Phase Buck PWM Controller with High Current Integrated MOSFET Drivers
ISL8103CRZ 功能描述:IC REG CTRLR BUCK PWM VM 40-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:100% 電源電壓:8.2 V ~ 30 V 降壓:無 升壓:無 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:0°C ~ 70°C 封裝/外殼:8-DIP（0.300"，7.62mm） 包裝:管件 產品目錄頁面:1316 (CN2011-ZH PDF)
ISL8103CRZ-T 功能描述:IC REG CTRLR BUCK PWM VM 40-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:100% 電源電壓:8.2 V ~ 30 V 降壓:無 升壓:無 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:0°C ~ 70°C 封裝/外殼:8-DIP（0.300"，7.62mm） 包裝:管件 產品目錄頁面:1316 (CN2011-ZH PDF)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*