- 您現在的位置：買賣IC網 > PDF目錄383165 > ISL8102CRZ-T (INTERSIL CORP) Two-Phase Buck PWM Controller with High Current Integrated MOSFET Drivers PDF資料下載
參數資料
| 型號： | ISL8102CRZ-T |
| 廠商： | INTERSIL CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Two-Phase Buck PWM Controller with High Current Integrated MOSFET Drivers |
| 中文描述： | SWITCHING CONTROLLER, PQCC32 |
| 封裝： | 5 X 5 MM, ROHS COMPLIANT, PLASTIC, MO-220VHHD-2, MLFP-32 |
| 文件頁數： | 18/27頁 |
| 文件大?。?/td> | 711K |
| 代理商： | ISL8102CRZ-T |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
18
FN9247.0
October 19, 2005
When the upper MOSFET turns off, the lower MOSFET does
not conduct any portion of the inductor current until the
voltage at the phase node falls below ground. Once the
lower MOSFET begins conducting, the current in the upper
MOSFET falls to zero as the current in the lower MOSFET
ramps up to assume the full inductor current. In Equation 16,
the required time for this commutation is t
1
and the
approximated associated power loss is P
UP,1
.
At turn on, the upper MOSFET begins to conduct and this
transition occurs over a time t
2
. In Equation 17, the
approximate power loss is P
UP,2
.
A third component involves the lower MOSFET reverse-
recovery charge, Q
rr
. Since the inductor current has fully
commutated to the upper MOSFET before the lower-
MOSFET body diode can recover all of Q
rr
, it is conducted
through the upper MOSFET across VIN. The power
dissipated as a result is P
UP,3
.
Finally, the resistive part of the upper MOSFET is given in
Equation 19 as P
UP,4
.
The total power dissipated by the upper MOSFET at full load
can now be approximated as the summation of the results
from Equations 16, 17, 18 and 19. Since the power
equations depend on MOSFET parameters, choosing the
correct MOSFETs can be an iterative process involving
repetitive solutions to the loss equations for different
MOSFETs and different switching frequencies.
Package Power Dissipation
When choosing MOSFETs it is important to consider the
amount of power being dissipated in the integrated drivers
located in the controller. Since there are a total of two drivers
in the controller package, the total power dissipated by both
drivers must be less than the maximum allowable power
dissipation for the QFN package.
Calculating the power dissipation in the drivers for a desired
application is critical to ensure safe operation. Exceeding the
maximum allowable power dissipation level will push the IC
beyond the maximum recommended operating junction
temperature of 125°C. The maximum allowable IC power
dissipation for the 5x5 QFN package is approximately 4W
at
room temperature. See
Layout Considerations
paragraph for
thermal transfer improvement suggestions.
When designing the ISL8102 into an application, it is
recommended that the following calculation is used to
ensure safe operation at the desired frequency for the
selected MOSFETs. The total gate drive power losses,
P
Qg_TOT
, due to the gate charge of MOSFETs and the
integrated driver’s internal circuitry and their corresponding
average driver current can be estimated with Equations 20
and 21, respectively.
In Equations 20 and 21, P
Qg_Q1
is the total upper gate drive
power loss and P
Qg_Q2
is the total lower gate drive power
loss; the gate charge (Q
G1
and Q
G2
) is defined at the
particular gate to source drive voltage PVCC in the
corresponding MOSFET data sheet; I
Q
is the driver total
quiescent current with no load at both drive outputs; N
Q1
and
N
Q2
are the number of upper and lower MOSFETs per phase,
respectively; N
PHASE
is the number of active phases. The
I
Q*
VCC product is the quiescent power of the controller
without capacitive load and is typically 75mW at 300kHz.
The total gate drive power losses are dissipated among the
resistive components along the transition path and in the
bootstrap diode. The portion of the total power dissipated in
the controller itself is the power dissipated in the upper drive
path resistance, P
DR_UP
, the lower drive path resistance,
P
DR_LOW
, and in the boot strap diode, P
BOOT
. The rest of
the power will be dissipated by the external gate resistors
(R
G1
and R
G2
) and the internal gate resistors (R
GI1
and
R
GI2
) of the MOSFETs. Figures 15 and 16 show the typical
upper and lower gate drives turn-on transition path. The total
power dissipation in the controller itself, P
DR
, can be roughly
estimated as:
P
UP 1
V
IN
I
M
N
-----
I
---2
+
t
1
2
----
F
SW
≈
(EQ. 16)
P
UP 2
,
V
IN
I
M
N
-----
I
2
--------
–
t
2
2
----
F
SW
≈
(EQ. 17)
P
UP 3
V
IN
Q
rr
F
SW
=
(EQ. 18)
P
UP 4
r
DS ON
)
I
M
N
-----
2
d
I
2
--12
+
≈
(EQ. 19)
P
Qg_TOT
P
Qg_Q1
P
Qg_Q2
I
Q
VCC
+
+
=
(EQ. 20)
P
Qg_Q1
3
2
--
Q
G1
PVCC F
SW
N
Q1
N
PHASE
=
P
Qg_Q2
Q
G2
PVCC F
SW
N
Q2
N
PHASE
=
I
DR
3
2
--
Q
G1
N
Q1
Q
G2
N
Q2
+
N
PHASE
F
SW
I
Q
+
=
(EQ. 21)
P
DR
P
DR_UP
P
DR_LOW
P
BOOT
I
Q
VCC
(
)
+
+
+
=
(EQ. 22)
P
DR_UP
R
HI1
R
EXT1
---------------+
R
LO1
R
EXT1
---------------+
+
P
---------------------
=
P
DR_LOW
R
HI2
R
EXT2
--------------+
R
LO2
R
EXT2
---------------+
+
P
---------------------
=
R
EXT1
R
G1
R
N
Q1
-------------
+
=
R
EXT2
R
G2
R
N
Q2
-------------
+
=
P
BOOT
P
3
---------------------
=
ISL8102
相關PDF資料 |
PDF描述 |
|---|---|
| ISL8102IRZ | Two-Phase Buck PWM Controller with High Current Integrated MOSFET Drivers |
| ISL8102IRZ-T | Two-Phase Buck PWM Controller with High Current Integrated MOSFET Drivers |
| ISL8102 | Two-Phase Buck PWM Controller with High Current Integrated MOSFET Drivers |
| ISL8102EVAL1 | Two-Phase Buck PWM Controller with High Current Integrated MOSFET Drivers |
| ISL81387 | ±15kV ESD Protected, Dual Protocol (RS-232/RS-485) Transceivers(±15kV ESD保護，雙協議(RS-232/RS-485)收發器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL8102EVAL1 | 功能描述:EVAL BOARD 1 FOR ISL8102 RoHS:否 類別:編程器，開發系統 >> 評估板 - DC/DC 與 AC/DC（離線）SMPS 系列:* 標準包裝:1 系列:- 主要目的:DC/DC，步降 輸出及類型:1，非隔離 功率 - 輸出:- 輸出電壓:3.3V 電流 - 輸出:3A 輸入電壓:4.5 V ~ 28 V 穩壓器拓撲結構:降壓 頻率 - 開關:250kHz 板類型:完全填充 已供物品:板 已用 IC / 零件:L7981 其它名稱:497-12113STEVAL-ISA094V1-ND |
| ISL8102IRZ | 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:100% 電源電壓:8.2 V ~ 30 V 降壓:無 升壓:無 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:0°C ~ 70°C 封裝/外殼:8-DIP（0.300"，7.62mm） 包裝:管件 產品目錄頁面:1316 (CN2011-ZH PDF) |
| ISL8102IRZ-T | 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:100% 電源電壓:8.2 V ~ 30 V 降壓:無 升壓:無 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:0°C ~ 70°C 封裝/外殼:8-DIP（0.300"，7.62mm） 包裝:管件 產品目錄頁面:1316 (CN2011-ZH PDF) |
| ISL8103 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Three-Phase Buck PWM Controller with High Current Integrated MOSFET Drivers |
| ISL8103CRZ | 功能描述:IC REG CTRLR BUCK PWM VM 40-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:100% 電源電壓:8.2 V ~ 30 V 降壓:無 升壓:無 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:0°C ~ 70°C 封裝/外殼:8-DIP（0.300"，7.62mm） 包裝:管件 產品目錄頁面:1316 (CN2011-ZH PDF) |
發布緊急采購，3分鐘左右您將得到回復。