- 您現在的位置：買賣IC網 > PDF目錄9258 > ISL22317TFRTZ-TK (Intersil)IC POT DGTL 128TP LN LP 10-TDFN PDF資料下載
參數資料
| 型號： | ISL22317TFRTZ-TK |
| 廠商： | Intersil |
| 文件頁數： | 2/15頁 |
| 文件大小： | 0K |
| 描述： | IC POT DGTL 128TP LN LP 10-TDFN |
| 產品培訓模塊： | Solutions for Industrial Control Applications |
| 標準包裝： | 1,000 |
| 系列： | XDCP™ |
| 接片： | 128 |
| 電阻（歐姆）： | 100k |
| 電路數： | 1 |
| 溫度系數： | 標準值 ±10 ppm/°C |
| 存儲器類型： | 非易失 |
| 接口： | I²C（設備位址） |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 10-TDFN-EP（3x3） |
| 包裝： | 帶卷 (TR) |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁
10
FN6912.1
April 15, 2010
Pin Description
Potentiometers Pins
RH AND RL
The high (RH) and low (RL) terminals of the ISL22317 are
equivalent to the fixed terminals of a mechanical
potentiometer. RH and RL are referenced to the relative
position of the wiper and the voltage potential on the
terminals. With WR set to 127 decimal, the wiper will be
closest to RH. With the WR set to 0, the wiper is closest to
RL. The voltage potential on the RH terminal must be higher
than voltage potential on RL terminal.
RW
RW is the wiper terminal and is equivalent to the movable
terminal of a mechanical potentiometer. The position of the
wiper within the array is determined by the WR register.
REF_A, REF_B
REF_A and REF_B are pins to connect an external resistor.
If application is required to connect RL terminal to GND, then
the REF_B pin should also be connected to GND.
Warning! Do not connect REF_A to GND under any
circumstances. That may damage the ISL22317.
Bus Interface Pins
SERIAL DATA INPUT/OUTPUT (SDA)
The SDA is a bidirectional serial data input/output pin for I2C
interface. It receives device address, operation code, wiper
address and data from an I2C external master device at the
rising edge of the serial clock SCL, and it shifts out data after
each falling edge of the serial clock.
SDA requires an external pull-up resistor, since it is an open
drain input/output.
SERIAL CLOCK (SCL)
This input is the serial clock of the I2C serial interface.
DEVICE ADDRESS (A1)
The address input is used to set the A1 bit of the 7-bit I2C
interface slave address, see Table 4. A match in the slave
address serial data stream must match with the Address
input pins in order to initiate communication with the
FIGURE 17. TC FOR RHEOSTAT MODE (10k/50k/100k) IN ppm
[RREF 2ppm/°C]
FIGURE 18. TC FOR VOLTAGE DIVIDER MODE (10k/50k/100k)
IN ppm [RREF 10ppm/°C]
FIGURE 19. STANDBY ICC vs TEMPERATURE
FIGURE 20. WIPER RESISTANCE vs TAP POSITION WHEN
PRECISION IS OFF
Typical Performance Curves (Continued)
0
10
20
30
40
15
35
55
75
95
115
TAP POSITION (DECIMAL)
TCr
(ppm/
C)
VCC = 5.5V
VCC = 2.7V
0
10
20
30
40
15
35
55
75
95
115
TAP POSITION (DECIMAL)
TCv
(ppm
/C)
VCC = 5.5V
VCC = 2.7V
0
200
400
600
800
-40
0
40
80
120
TEMPERATURE (°C)
IS
B
(uA
)
VCC = 5.5V
VCC = 2.7V
0
20
40
60
80
100
0
20406080
100
120
TAP POSITION (DECIMAL)
WIPE
R
RES
IS
TANCE
(Ω
)
T = +125°C
T = +25°C
T = -40°C
VCC = 5.5V
ISL22317
相關PDF資料 |
PDF描述 |
|---|---|
| M83723/72R22128 | CONN RCPT 12POS WALL MT W/PINS |
| M83723/72R22127 | CONN RCPT 12POS WALL MT W/PINS |
| M83723/72R22126 | CONN RCPT 12POS WALL MT W/PINS |
| MS27484T16A6PA | CONN PLUG 6POS STRAIGHT W/PINS |
| MS27474T20B2PA | CONN RCPT 65POS JAM NUT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL22317UFRTZ | 功能描述:數字電位計 IC 128 TAP FL RNG PRECISION 10LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| ISL22317UFRTZ-TK | 功能描述:數字電位計 IC 128 TAP FL RNG PRECISION 10LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| ISL22317UFRTZTKS2568 | 制造商:Intersil Corporation 功能描述:INTEL, ISL22317UFRTZ-TK W/BARCODE LABELS, 12 MONTH D/C RESTR - Tape and Reel |
| ISL22317WFRTZ | 功能描述:數字電位計 IC 128 TAP FL RNG PRECISION 10LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| ISL22317WFRTZ-TK | 功能描述:數字電位計 IC 128 TAP FL RNG PRECISION 10LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。