- 您現在的位置：買賣IC網 > PDF目錄9421 > ISL12032IVZ-T (Intersil)IC RTC LP BATT BACK SRAM 14TSSOP PDF資料下載
參數資料
| 型號： | ISL12032IVZ-T |
| 廠商： | Intersil |
| 文件頁數： | 13/26頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC RTC LP BATT BACK SRAM 14TSSOP |
| 產品培訓模塊： | Solutions for Industrial Control Applications |
| 標準包裝： | 1 |
| 類型： | 時間事件記錄器 |
| 特點： | 警報器，SRAM，涓流充電器 |
| 存儲容量： | 128B |
| 時間格式： | HH:MM:SS:hh（12/24 小時） |
| 數據格式： | YY-MM-DD-dd |
| 接口： | I²C，2 線串口 |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 電壓 - 電源，電池： | 1.8 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 14-TSSOP |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 1246 (CN2011-ZH PDF) |
| 其它名稱： | ISL12032IVZ-TDKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
20
FN6618.3
May 5, 2011
DstHrFd controls the hour that DST begins. It includes the
MIL bit, which is in the corresponding RTC register. The RTC
hour and DstHrFd registers need to match formats (Military
or AM/PM) in order for the DST function to work. The default
value for DST hour is 2:00AM (02h). The time is advanced
from 2:00:00AM to 3:00:00AM for this setting.
DST REVERSE REGISTERS (19H TO 1CH)
DST end (reverse) is controlled by the following DST
Registers.
DstMoRv sets the Month that DST ends. The default value
for the DST end month is October (10h).
DstDwRv controls the Day of the Week that DST should end.
The DwRvE bit sets the priority of the Day of the Week over
the Date. For DwRvE = 1, Day of the week is the priority. Note
that Day of the week counts from 0 to 6, like the RTC
registers. The default for DST DwRv end is Sunday (00h).
DstDtRv controls which Date DST ends. The default value
for DST Date Reverse is on the first date of the month. The
DstDtRv is only effective if the DwRvE = 0.
DstHrRv controls the hour that DST ends. It includes the MIL
bit, which is in the corresponding RTC register. The RTC
hour and DstHrRv registers need to match formats (Military
or AM/PM) in order for the DST function to work. The default
value sets the DST end at 2:00AM. The time is set back from
2:00:00AM to 1:00:00AM for this setting.
ALARM Registers (1Dh to 28h)
The alarm register bytes are set up identical to the RTC
register bytes, except that the MSB of each byte functions as
an enable bit (enable = “1”). These enable bits specify which
alarm registers (seconds, minutes, etc.) are used to make
the comparison. Note that there is no alarm byte for year.
The alarm function works as a comparison between the
alarm registers and the RTC registers. As the RTC
advances, the alarm will be triggered once a match occurs
between the alarm registers and the RTC registers. Any one
alarm register, multiple registers, or all registers can be
enabled for a match.
There are two alarm operation modes: Single Event and
periodic Interrupt Mode:
Single Event Mode is enabled by setting either ALE0 or
ALE1 to 1, then setting bit 7 on any of the Alarm registers
(ESCA... EDWA) to “1”, and setting the IM bit to “0”. This
mode permits a one-time match between the Alarm registers
and the RTC registers. Once this match occurs, the ALM bit
is set to “1” and the IRQ output will be pulled LOW and will
remain LOW until the ALM bit is reset. This can be done
manually or by using the auto-reset feature. Since the IRQ
output is shared by both alarms, they both need to be reset
in order for the IRQ output to go HIGH.
Interrupt Mode is enabled by setting either ALE0 or ALE1 to
1, then setting bit 7 on any of the Alarm registers (ESCA...
EDWA) to “1”, and setting the IM bit to “1”. Setting the IM bit
to 1 puts both ALM0 and ALM1 into Interrupt mode. The IRQ
output will now be pulsed each time an alarm occurs (either
AL0 or AL1). This means that once the interrupt mode alarm
is set, it will continue to alarm until it is reset.
To clear a single event alarm, the corresponding ALM0 or
ALM1 bit in the SRDC register must be set to “0” with a write.
Note that if the ARST bit is set to “1” (address 0Ch, bit 7), the
ALM0 and ALM1 bits will automatically be cleared when the
status register is read.
The IRQ output will be set by an alarm match for either
ALM0 or ALM1.
Following are examples of both Single Event and periodic
Interrupt Mode alarms.
TABLE 26. DST FORWARD REGISTERS
ADDRESS
FUNCTION
7
6
5
4
3
2
1
0
15h
Month Forward
DSTE
0
MoFd20
MoFd13
MoFd12
MoFd11
MoFd10
16h
Day Forward
0
DwFdE
WkFd12
WkFd11
WkFd10
DwFd12
DwFd11
DwFd10
17h
Date Forward
0
DtFd21
DtFd20
DtFd13
DtFd12
DtFd11
DtFd10
18h
Hour Forward
HrFdMIL
0
HrFd21
HrFd20
HrFd13
HrFd12
HrFd11
HrFd10
TABLE 27. DST REVERSE REGISTERS
ADDRESS
NAME
7
6
5
4
3
2
1
0
19h
Month Reverse
0
MoRv20
MoRv13
MoRv12
MoRv11
MoRv10
1Ah
Day Reverse
0
DwRvE
WkRv12
WkRv11
WkRv10
DwRv12
DwRv11
DwRv10
1Bh
Date Reverse
0
DtRv21
DtRv20
DtRv13
DtRv12
DtRv11
DtRv10
1Ch
Hour Reverse
HrRvMIL
0
HrRv21
HrRv20
HrRv13
HrRv12
HrRv11
HrRv10
ISL12032
相關PDF資料 |
PDF描述 |
|---|---|
| VE-J1N-MZ | CONVERTER MOD DC/DC 18.5V 25W |
| VI-J1N-MZ | CONVERTER MOD DC/DC 18.5V 25W |
| VE-J1P-MZ | CONVERTER MOD DC/DC 13.8V 25W |
| ISL1209IU10Z-TK | IC RTC LP SRAM EEPROM 10-MSOP |
| VI-J3Z-EY-F4 | CONVERTER MOD DC/DC 2V 20W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL12057 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Low Cost and Low Power I2C RTC Real Time Clock/Calendar |
| ISL12057IBZ | 功能描述:實時時鐘 REAL TIME CLK W/ ALARM DS1337 COMP RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| ISL12057IBZ-T | 功能描述:實時時鐘 REAL TIME CLK W/ ALARM DS1337 COMP RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| ISL12057IRUZ-T | 功能描述:實時時鐘 REAL TIME CLK W/ ALARM DS1337 COMP RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| ISL12057IUZ | 功能描述:實時時鐘 REAL TIME CLK W/ ALARM DS1337 COMP RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。