22 FN6668.9 June 20, 2012 DST REVERSE REGISTERS (24H TO 27H) DST end (reverse) is controlled by the following DST Registers: DST Mont" />
參數資料
型號: ISL12022MIBZ-T7A
廠商: Intersil
文件頁數: 15/31頁
文件大?。?/td> 0K
描述: IC RTC/CALENDAR TEMP SNSR 20SOIC
應用說明: Addressing Power Issues in Real Time Clock Appls
產品培訓模塊: Solutions for Industrial Control Applications
標準包裝: 250
類型: 時鐘/日歷
特點: 警報器,夏令時,閏年,SRAM
存儲容量: 128B
時間格式: HH:MM:SS(12/24 小時)
數據格式: YY-MM-DD-dd
接口: I²C,2 線串口
電源電壓: 2.7 V ~ 5.5 V
電壓 - 電源,電池: 1.8 V ~ 5.5 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 20-SOIC(0.295",7.50mm 寬)
供應商設備封裝: 20-SOIC
包裝: 帶卷 (TR)
ISL12022M
22
FN6668.9
June 20, 2012
DST REVERSE REGISTERS (24H TO 27H)
DST end (reverse) is controlled by the following DST Registers:
DST Month Reverse
DstMoRv sets the Month that DST ends. The format is the same
as for the RTC register month, from 1 to 12. The default value for
the DST end month is October (10h).
DST Day/Week Reverse
DstDwRv contains both the Day of the Week and the Week of the
Month data for DST Reverse control. DST can be controlled either by
actual date or by setting both the Week of the month and the Day of
the Week. DstDwRvE sets the priority of the Day/Week over the
Date. For DstDwRvE = 1, Day/Week is the priority. You must have
the correct Day of Week entered in the RTC registers for the
Day/Week correction to work properly.
Bits 0,1,2 contain the Day of the week information which sets
the Day of the Week that DST ends. Note that Day of the week
counts from 0 to 6, like the RTC registers. The default for the
DST Reverse Day of the Week is 00h (normally Sunday).
Bits 3, 4, 5 contain the Week of the Month information that sets
the week that DST ends. The range is from 1 to 5, and Week 7 is
used to indicate the last week of the month. The default for the
DST Reverse Week of the Month is 00h.
DST Date Reverse
DstDtRv controls which Date DST ends. The format for the Date is
the same as for the RTC register, from 1 to 31. The default value
for DST Date Reverse is 00h. The DstDtRv is only effective if the
DwRvE = 0.
DST Hour Reverse
DstHrRv controls the hour that DST ends. The RTC hour and
DstHrFd registers have the same formats except there is no
Military bit for DST hour. The user sets the DST hour with the
same format as used for the RTC hour (AM/PM or MIL) but
without the MIL bit, and the DST will still advance as if the MIL bit
were there. The default value for DST hour Reverse is 00h.
TEMP Registers (TEMP)
The temperature sensor produces an analog voltage output
which is input to an A/D converter and produces a 10-bit
temperature value in degrees Kelvin. TK07:00 are the LSBs of the
code, and TK09:08 are the MSBs of the code. The temperature
result is actually the average of two successive temperature
measurements to produce greater resolution for the temperature
control. The output code can be converted to °C by first
converting from binary to decimal, dividing by 2, and then
subtracting 273d.
The practical range for the temp sensor register output is from 446d
to 726d, or -50°C to +90°C. The temperature compensation
function is only guaranteed over -40°C to +85°C. The TSE bit must
be set to “1” to enable temperature sensing.
NPPM Registers (NPPM)
The NPPM value is exactly 2x the net correction, in ppm, required
to bring the oscillator to 0ppm error. The value is the combination
of oscillator Initial Correction (IPPM) and crystal temperature
dependent correction (CPPM).
IPPM is used to compensate the oscillator offset at room
temperature and is controlled by the ITR0 and BETA registers. This
value is normally set during room temperature testing.
The CPPM compensates the oscillator frequency fluctuation over-
temperature. It is determined by the temperature (T), crystal
curvature parameter (ALPHA), and crystal turnover temperature
(XT0). T is the result of the temp sensor/ADC conversion, whose
decimal result is 2x the actual temperature in Kelvin. ALPHA is
from either the ALPHA (cold) or ALPHAH (hot) register depending
on T, and XT0 is from the XT0 register.
TABLE 20. DST FORWARD REGISTERS
ADDRESS
FUNCTION
7
6
5
4
321
0
20h
Month Forward
DSTE
0
MoFd20
MoFd13
MoFd12
MoFd11
MoFd10
21h
Day Forward
0
DwFdE
WkFd12
WkFd11
WkFd10
DwFd12
DwFd11
DwFd10
22h
Date Forward
0
DtFd21
DtFd20
DtFd13
DtFd12
DtFd11
DtFd10
23h
Hour Forward
0
HrFd21
HrFd20
HrFd13
HrFd12
HrFd11
HrFd10
TABLE 21. DST REVERSE REGISTERS
ADDRESS
NAME
7
654
321
0
24h
Month Reverse
0
MoRv20MoRv13
MoRv12MoRv11MoRv10
25h
Day Reverse
0
DwRvE
WkRv12
WkRv11
WkRv10
DwRv12
DwRv11
DwRv10
26h
Date Reverse
0
DtRv21
DtRv20
DtRv13
DtRv12
DtRv11
DtRv10
27h
Hour Reverse
0
HrRv21
HrRv20
HrRv13
HrRv12
HrRv11
HrRv10
TABLE 22.
TEMP
76
54
32
10
TK0L
TK07 TK06 TK05 TK04 TK03 TK02 TK01 TK00
TK0M
00
TK09 TK08
Temperature in °C
[(TK <9:0>)/2] - 273
=
(EQ. 3)
相關PDF資料
PDF描述
ISL12022MIBZR5421 IC RTC/CALENDAR TEMP SNSR 20SOIC
ISL12023IVZ IC RTC/CLDR TEMP SNSR 14-TSSOP
ISL12024IRTCZ IC RTC/CALENDER 64BIT 8-TDFN
ISL12024IVZ IC RTC/CALENDAR EEPROM 8-TSSOP
ISL12025IVZ IC RTC/CALENDAR EEPROM 8-TSSOP
相關代理商/技術參數
參數描述
ISL12022MIBZ-TR5421 功能描述:實時時鐘 REAL TIME CLK W/MFK IMPROVED ESD AIR RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
ISL12022MR5421 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Low Power RTC with Battery Backed SRAM, Integrated 5ppm
ISL12022M-R5421 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:High-Accuracy RTC Modules, Feature-Rich RTCs
ISL12023 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Low Power RTC with Battery-Backed SRAM and Embedded Temp Compensation ±5ppm with Auto Daylight Saving
ISL12023IVZ 功能描述:實時時鐘 REAL TIME CLK/CLNDR W/TEMP COM 14 L RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube