- 您現在的位置：買賣IC網 > PDF目錄384519 > ISD5116EI (WINBOND ELECTRONICS CORP) Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability PDF資料下載
參數資料
| 型號： | ISD5116EI |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 音頻合成 |
| 英文描述： | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
| 中文描述： | 960 SEC, SPEECH SYNTHESIZER WITH RCDG, PDSO28 |
| 封裝： | 8 X 13.40 MM, PLASTIC, TSOP1-28 |
| 文件頁數： | 16/57頁 |
| 文件大?。?/td> | 735K |
| 代理商： | ISD5116EI |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁
October 2000
Page 15
3.6 POWER-UP SEQUENCE
This sequence prepares the ISD5116 for an operation to follow, waiting the Tpud time before sending the
next command sequence.
1.
2.
3.
4.
5.
6.
7.
8.
Send I
2
C POWER UP
Send one byte 10000000 {Slave Address, R/W = 0} 80h
Slave ACK
Wait for SCL High
Send one byte 10000000 {Command Byte = Power Up} 80h
Slave ACK
Wait for SCL High
Send I
2
C STOP
3.6.1 Playback Mode
The command sequence for an analog Playback operation can be handled several ways. One technique
would be to do a Load Address (81h), which requires sending a total of four bytes, and then sending a
Play Analog, which would be a Command Byte (A8h) proceeded by the Slave Address Byte. This is a
total of six bytes plus the times for Start, ACK, and Stop.
Another approach would be to incorporate both into a single four byte exchange, which consists of the
Slave Address (80h), the Command Byte (A9h) for Play Analog @ Address, and the two address bytes.
3.6.2 Record Mode
The command sequence for an Analog Record would be a four byte sequence consisting of the Slave
Address (80h), the Command Byte (91h) for Record Analog @ Address, and the two address bytes. See
“
Load Command Byte Register (Address Load)
”
in section 3.1.2
on page 10.
3.7 FEED THROUGH MODE
The previous examples were dependent upon the device already being powered up and the various paths
being set through the device for the desired operation. To set up the device for the various paths requires
loading the two 16-bit Configuration Registers with the correct data. For example, in the Feed Through
Mode the device only needs to be powered up and a few paths selected.
This mode enables the ISD5116 to connect to a cellular or cordless base band phone chip set without
affecting the audio source or destination. There are two paths involved, the transmit path and the receive
path. The transmit path connects the ISD chip’s microphone source through to the microphone input on
the base band chip set. The receive path connects the base band chip set’s speaker output through to the
speaker driver on the ISD chip. This allows the ISD chip to substitute for those functions and incidentally
gain access to the audio to and from the base band chip set.
To set up the environment described above, a series of commands need to be sent to the ISD5116. First,
the chip needs to be powered up as described in this section. Then the Configuration Registers must be
filled with the specific data to connect the paths desired. In the case of the Feed Through Mode, most of
the chip can remain powered down. The following figure illustrates the affected paths.
相關PDF資料 |
PDF描述 |
|---|---|
| ISD5116P | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
| ISD5116S | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
| ISD5116SD | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
| ISD5116SI | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
| ISD5116X | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISD5116EIR | 功能描述:IC VOICE REC/PL 8-16MN IN 28TSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
| ISD5116EY | 功能描述:IC VOICE REC/PLAY 8-16MN 28-TSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
| ISD5116EYI | 功能描述:IC VOICE REC/PLAY 8-16MN 28-TSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
| ISD5116EYR | 功能描述:IC VOICE REC/PLAY 8-16MN 28-TSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
| ISD5116P | 功能描述:IC VOICE REC/PLAY 8-16MN 28-DIP RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
發布緊急采購，3分鐘左右您將得到回復。