
2
IR5001
www.irf.com
Unless otherwise specified, these specifications apply over V
line
= 36V to 100V; Vcc is decoupled with 0.1uF to
Gnd,
C
L
=10nF
at Vout; INP is
connected to Gnd. Typical values refer to
T
A
=25°C. Minimum and maximum limits
apply to T
A
= 0°C to
85°C temperature range
and
are
100% production-tested
at
both temperature extremes. Low
duty cycle pulse testing is used which keeps junction and case temperatures equal to the ambient temperature.
ABSOLUTE MAXIMUM RATINGS
CAUTION:
1. Stresses above those listed in "Absolute Maximum Ratings" may cause permanent damage to the device. This
is a stress only rating and operation of the device at these or any other conditions above those indicated in the
operational section of this specification is not implied.
2. This device is ESD sensitive. Use of standard ESD handling precautions is required.
.
ELECTRICAL SPECIFICATIONS
Vline Voltage
Vcc Voltage
Icc Current
INN, INP Voltage
FETch, FETst
FETst Sink Current
Junction Temperature
Storage Temperature Range
-5.0V to 100V (continuous)
-0.5V to 15VDC
5mA
-5.0V to 100V (continuous)
-0.5V to 5.5V
10mA
-40°C to 125°C
-65°C to 150°C
PARAMETERS
SYMBOL
TEST CONDITION
Vline=25V
MIN TYP MAX UNITS
0.14
0.3
0.5
Vline=36V
0.2
0.5
0.75
Vline=100V, Note 1
1.2
1.7
2.2
VCC output voltage
Vcc(out)
Vline=25V
10.2 12.5 13.9
V
UVLO Section
UVLO ON Threshold Voltage
Vcc(ON)
Vline=open, VINP=0; VINN= -
0.3V
Vcc increased until Vout switches
from LO to HI, Note 2
Vline=open, VINP=0, VINN=-
0.3V, Vcc is decreased until
Vout switches from HI to LO
8.3
9.6
10.9
UVLO OFF Threshold Voltage
Vcc(OFF)
5.7
7.2
8.5
UVLO Hysteresis
1.6
2.3
2.8
V
Input Comparator Section
Input Offset Voltage (VINP-
VINN)
Vos
VINP=0V and VINN Ramping up,
VOUT changes from HI to LO,
Fig.3
-7.9
-4.0
0
Input Hysteresis Voltage
Vhyst
VINP=0,VINN ramping down,
Figures 3 and 4
13
31
44
(INN) Input Bias Current
I(INN)
VINP=0V, VINN=36V
0.2
0.5
0.9
(INP) Input Bias Current
I(INP)
VINN=0V, VINP=36V
0.2
0.5
0.9
mA
mV
Iline
Bias Section
Vline Bias Current
V
mA