- 您現在的位置：買賣IC網 > PDF目錄384476 > ICB1FL02G (INFINEON TECHNOLOGIES AG) Smart Ballast Control IC for Fluorescent Lamp Ballasts PDF資料下載
參數資料
| 型號： | ICB1FL02G |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 英文描述： | Smart Ballast Control IC for Fluorescent Lamp Ballasts |
| 中文描述： | 智能鎮流器控制芯片用于熒光燈鎮流器 |
| 文件頁數： | 5/37頁 |
| 文件大小： | 1143K |
| 代理商： | ICB1FL02G |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
Datasheet Version 1.2
5
February 2006
ICB1FL02G
Pin Configuration and Description
1
1.1
Pin Configuration and Description
Pin Configuration PG-DSO-18-1
1.2
Pin Description
LSCS (Low side current sense, Pin 1
)
This pin is directly connected to the shunt resistor
which is located between the Source terminal of the
low-side MOSFET of the inverter and ground.
Internal clamping structures and filtering measures
allow for sensing the Source current of the low-side
inverter MOSFET without additional filter components.
There is a first threshold of 0,8V, which provides a
couple of increasing steps of frequency during ignition
mode, if exceeded by the sensed current signal for a
time longer than 250ns. If the sensed current signal
exceeds a second threshold of 1,6V for longer than
400ns during all operating modes, a latched shut down
of the IC will be the result.
LSGD (Low side gate drive, Pin 2)
The Gate of the low-side MOSFET in a half-bridge
inverter topology is controlled by this pin. There is an
active L-level during UVLO (undervoltage lockout) and
a limitation of the max. H-level at 11V during normal
operation. Turning on the MOSFET softly (with reduced
di
DRAIN
/dt), the Gate drive voltage rises within 220ns
from L-level to H-level. The fall time of the Gate drive
voltage is less than 50ns in order to turn off quickly.
This measure produces different switching speeds
during turn-on and turn-off as it is usually achieved with
a diode in parallel to a resistor in the Gate drive loop. It
is recommended to use a resistor of about 15Ohm
between drive pin and Gate in order to avoid
oscillations and in order to shift the power dissipation of
discharging the Gate capacitance into this resistor. The
dead time between LSGD signal and HSGD signal is
1800ns typically.
VCC (Supply voltage, Pin 3)
This pin provides the power supply of the ground
related section of the IC. There is a turn-on threshold at
14V and an UVLO threshold at 10,5V. Upper supply
voltage level is 17,5V. There is an internal zener diode
clamping Vcc at 16V (2mA typically). The zener current
is internally limited to 5mA max. For higher current
levels an external zener diode is required. Current
consumption during UVLO and during fault mode is
less than 150
μ
A. A ceramic capacitor close to the
supply and GND pin is required in order to act as a low-
impedance power source for Gate drive and logic
signal currents.
GND (Ground, Pin 4)
This pin is connected to ground and represents the
ground level of the IC for supply voltage, Gate drive
and sense signals.
Pin
Symbol
Function
1
LSCS
Low side current sense (inverter)
2
LSGD
Low side gate drive (inverter)
3
VCC
Supply voltage
4
GND
Controller ground
5
PFCGD
PFC gate drive
6
PFCCS
PFC current sense
7
PFCZCD PFC zero current detector
8
PFCVS
PFC voltage sense
9
RFRUN
Set R for run frequency
10
RFPH
Set R for preheating frequency
11
RTPH
Set R for preheating time
12
RES
Restart after lamp removal
13
LVS1
Lamp voltage sense 1
14
LVS2
Lamp voltage sense 2
15
n.e.
Not existing
16
n.e.
Not existing
17
HSGND
High side ground
18
HSVCC
High side supply voltage
19
HSGD
High side gate drive
20
HSGND
High side ground
HSVCC
HSGND
RFPH
RES
LVS1
PG-DSO-18-1 (300mil)
LVS2
RFRUN
PFCVS
PFCZCD
I
GND
HSGD
LSGD
PFCGD
LSCS
PFCCS
VCC
RTPH
HSGND
10
9
8
7
4
2
5
1
6
3
11
12
13
14
17
19
16
20
15
18
相關PDF資料 |
PDF描述 |
|---|---|
| ICE1QS01 | Controller for Switch Mode Power Supplies Supporting Low Power Standby and Power Factor Correction (PFC) |
| ICE1QS01G | Controller for Switch Mode Power Supplies Supporting Low Power Standby and Power Factor Correction (PFC) |
| ICE3AS02 | Off-Line SMPS Current Mode Controller with integrated 500V Startup Cell |
| ICE3AS02G | Off-Line SMPS Current Mode Controller with integrated 500V Startup Cell |
| ICE3BS02 | Off-Line SMPS Current Mode Controller with integrated 500V Startup Cell |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICB1FL02G IFX | 制造商:Infineon Technologies AG 功能描述: |
| ICB1FL02G_08 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Smart Ballast Control IC for Fluorescent Lamp Ballasts |
| ICB1FL02GXUMA1 | 制造商:Infineon Technologies AG 功能描述:Electronic Ballast Controller 12V/15V 100KHz T/R 制造商:Infineon Technologies AG 功能描述:Electronic Ballast Controller 12V/15V 100KHz 18-Pin DSO T/R 制造商:Infineon Technologies AG 功能描述:FL LIGHTING - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC SMART BALLAST CONTROL PDSO-18 |
| ICB1FL03G | 功能描述:LED照明驅動器 LIGHTING RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| ICB1FL03GXUMA1 | 制造商:Infineon Technologies AG 功能描述:ELECTRONIC BALLAST CONTROLLER 12V/15V 100KHZ 制造商:Infineon Technologies AG 功能描述:FL LIGHTING - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC SMART BALLAST CONTROL DSO18 |
發布緊急采購，3分鐘左右您將得到回復。